Manual de instrucciones de Ives Offset Top Pivot 7212

Resumen del contenido incluido en la página 1

Installation Instructions
7212
3/4” Offset Jamb Mounted Bottom Pivot
Right hand
installation shown;
Door
leaf
left hand opposite
Right hand
Bearing
installation
spindle
3/32” Allen
Left hand
Jamb
wrench
installation
leaf
Set
Figure 1
screw
1. Prepare and mortise bottom of door and side jamb to receive pivot set. Determine pivot
location using dimensions on reverse side. Be sure to properly locate and mark center
point of the jamb leaf spindle. Care must be taken to ensure that jamb leaf is comp

Resumen del contenido incluido en la página 2

NOTE ! It is very important for installer to verify that center line of top pivot point lines up with center line of bottom pivot point before final installation. Heel edge of door must be beveled 1/8” in 2” as shown below. The bottom pivot set should be mounted first in most installations. Depth of mortise will vary 3/8” 15/16” to *depending upon installation * * 10 mm 24 mm and/or threshold height. 9/16” 1-1/8” 14 mm 29 mm Bevel heel edge of door 1/8” in 2” with 3/16” rad, typ Door Leaf Face o