Resumen del contenido incluido en la página 1
INSTALLATION INSTRUCTIONS
DRAWER DISHWASHER
INSTRUCCIONES DE INSTALACIÓN
DE LA LAVAVAJILLAS DE CAJÓN
INSTRUCTIONS D’INSTALLATION
LAVE-VAISSELLE À DOUBLE TIROIR
Table of Contents/Índice/Table des matières..................................................................2
IMPORTANT:
Save for local electrical inspector's use.
Installer: Leave installation instructions with the homeowner.
Homeowner: Keep installation instructions for future reference.
IMPORTANTE:
Guarde estas instrucciones para ten
Resumen del contenido incluido en la página 2
TABLE OF CONTENTS DISHWASHER SAFETY .................................................................3 Route Electrical Wiring.................................................................9 Route Water Supply Line and Drain Hose.................................10 INSTALLATION REQUIREMENTS ................................................4 Connect Water Supply Line and Drain Hoses...........................11 Tools and Parts ......................................................................
Resumen del contenido incluido en la página 3
DISHWASHER SAFETY Your safety and the safety of others are very important. We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety messages. This is the safety alert symbol. This symbol alerts you to potential hazards that can kill or hurt you and others. All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.” These words mean: You can be killed or seriously injured if you don't immediately
Resumen del contenido incluido en la página 4
INSTALLATION REQUIREMENTS Parts Supplied Check that all parts are included. T ools and Parts Gather the required tools and parts before starting installation. C Read and follow the instructions provided with any tools listed D B here. A Tools needed ■ Pliers ■ 10" adjustable wrench ■ Phillips screwdriver ■ Utility knife E F ■ Flat-blade screwdriver ■ Level ■ ³⁄₁₆" and ¼" nut drivers or ■ Electric drill hex sockets ■ ¹⁄₈" drill bit ■ Measuring tape or ruler ®† ■ Security T-20 TORX ■ 1½" hole sa
Resumen del contenido incluido en la página 5
Preferred utililty area Product Dimensions 24" 23³⁄₈" A (61 cm) (59.5 cm) 1/2" (1.3 cm) 25" (63.5 cm) B 33³⁄₄" (85.7 cm) 8" (20.3 cm) A. Choose left-hand or right-hand drain and water connection route. B. Choose left-hand or right-hand electric connection route. NOTE: All holes should be drilled at 1½" (3.8 cm) diameter. Water Supply Requirements ■ A hot water line with 20-120 psi (138-862 kPa) water 19¹⁄₄" 1¹⁄₂" pressure. (48.9 cm) (3.75 cm) ■ 120°F (49°C) water temperature at dis
Resumen del contenido incluido en la página 6
If direct wiring dishwasher: ■ Use flexible, armored or nonmetallic sheathed, copper wire Electrical Requirements with grounding wire that meets the wiring requirements for your home and local codes and ordinances. WARNING ■ Use strain relief method provided with house wiring junction box or install a UL-listed/CSA-certified clamp connector to the house wiring junction box. If using conduit, use a UL-listed/CSA-certified conduit connector. If connecting dishwasher with a power supply cord:
Resumen del contenido incluido en la página 7
INSTALLATION INSTRUCTIONS 2. Drill 1½" (3.8 cm) diameter holes for drain and water hoses and electrical wiring as shown. Holes should be placed WARNING ½" (1.3 cm) from back wall. A Electrical Shock Hazard 1/2" Disconnect electrical power at the fuse box or circuit (1.3 cm) breaker box before installing dishwasher. 25" Failure to do so can result in death or electrical shock. (63.5 cm) B 1. Disconnect power. 8" 2. Turn off water supply. (20.3 cm) Unpack Dish Drawer A. Choose left-ha
Resumen del contenido incluido en la página 8
T T T T S S A AR 4 8 ELAY HOURS Option 1: Solid surface countertop installation ■ Install second set of mounting brackets 33½" (85 cm) Prepare Dishwasher from floor. If needed, drill ¹⁄₈" pilot holes in cabinet. WARNING 33¹⁄₂" (85 cm) Tip Over Hazard Do not open dishwasher drawer until inside cabinet opening. Doing so can result in death or serious injury. WARNING Excessive Weight Hazard Option 2: Wood countertop installation Use two or more people to move and install ■ Prepare dishwasher b
Resumen del contenido incluido en la página 9
3. Adjust leveling legs based on the cabinet opening Option 1: Right-hand side utility route measurement and the chart below. X H : X H : X Route wire through 1½" (3.81 cm) hole located 8" (20.32 cm) above 33⁷⁄₈" (86 cm) : 0" 34¹⁄₂" (87.6 cm) :⁵⁄₈" (1.6 cm) the floor. 34" (86.3 cm) :¹⁄₈" (0.3 cm) 34⁵⁄₈" (87.9 cm) :³⁄₄" (1.9 cm) After routing the electrical wire through the right-hand hole, 34¹⁄₈" (86.7 cm) :¼" (0.6 cm) 34³⁄₄" (88.3 cm) :⁷⁄₈" (2.2 cm) attach the wire to back left-hand side of
Resumen del contenido incluido en la página 10
Route Water Supply Line and Drain Hose 1. Connect water supply line to water valve on dishwasher. Option 2: Left-hand side utility access ■ For left-hand routing, remove drain hoses from the clips in the rear bracket as shown. 2. Route water supply line and drain hoses based on your ■ Route water supply line and drain hoses into the cabinet. cabinet requirements. Option 1: Right-hand side utility access ■ For right-hand routing, water supply and drain hoses are shipped in the correct position
Resumen del contenido incluido en la página 11
Connect Water Supply Line and Drain Hoses 1. Connect water supply line to the water valve under the sink. Option 2: No waste disposer and drain air gap B A C A A. Hot water supply 2. Slide clamps onto drain hoses (Figure A). Do not cut drain A. Drain hose connector hoses. B. Drain air gap 3. Push hoses into Y drain connector until fully seated (Figure C. Waste B). Several “clicks” will be heard. 4. Slide clamps into position (figures C and D). Option 3: Waste disposer and drain air gap AB A B
Resumen del contenido incluido en la página 12
Make Electrical Connection WARNING WARNING Electrical Shock Hazard Electrical Shock Hazard Disconnect electrical power at the fuse box or circuit Electrically ground dishwasher. breaker box before installing dishwasher. Connect ground wire to green ground connector in Failure to do so can result in death or electrical shock. terminal box. Do not use an extension cord. 1. Remove screw securing the electrical box cover. Remove Failure to follow these instructions can result in death, cover. fi
Resumen del contenido incluido en la página 13
2 2 1 1 4. Rest trim strip on floor and mark trim at the top of the frame 5. Reinstall electric box cover with all wires contained inside the flange height. Pick the closest groove to the mark. If the mark terminal box. is between two grooves, choose the groove that makes the trim strip the shortest. On a protective surface, cut the trim strip at the selected groove. 5. Attach the toe kick bracket to the frame. Install T rim Pieces 1. Open bottom drawer. 2. Push in clips and slide rails bac
Resumen del contenido incluido en la página 14
2 2 7. Attach toe kick bracket on the opposite side. 3. Adjust legs with a ³⁄₁₆" socket wrench to level the dishwasher. A 8. Place flexible side trim strips on both sides as shown. A. Adjust legs. 4. Remove top drawer (same procedure as followed to remove bottom drawer) and set drawer on bottom drawer separated with corner packaging. Level and Secure Dishwasher 1. Slide the dishwasher into position in the cabinet opening. Check to ensure that the drain hose and electrical wiring are not kink
Resumen del contenido incluido en la página 15
1 1 2 2. Pull slide rails forward until they snap into position. Option 1: Solid surface countertop Attach dishwasher to the side cabinet mounting brackets (installed earlier). A 3. Push top drawer in and repeat above steps for bottom drawer. 4. In the cabinet under the sink, coil excess drain hose and wrap with a zip tie. Plug in dishwasher or reconnect the power. A. Attach dishwasher to side cabinet mounting brackets. Option 2: Wood countertop Attach the dishwasher to the countertop using
Resumen del contenido incluido en la página 16
OVERLAY PANEL INSTALLATION INSTRUCTIONS Custom Overlay Drawer Panels Preparing Custom Panels If you plan to install custom wood panels, you will need to 1. Lay the custom panels (top and bottom) face down on a create the panels yourself or consult a qualified cabinetmaker or clean, soft work surface. carpenter. See dimension drawings for panel specifications. 2. Using a pencil, mark the centerpoints for the two panel IMPORTANT: fastener pilot holes and six pilot holes needed for the upper pan
Resumen del contenido incluido en la página 17
3. Using the screws provided, secure the overlay panel to the inner door by screwing through the inner door and into the ¹⁄₈" Install Panel Fasteners (3.175 mm) pilot holes. 1. Remove the two panel fasteners from the face of the inner door of the upper drawer. 2. Screw the two panel fasteners into the panel fastener pilot holes of the overlay panel. 3. Repeat steps 1 and 2 for the lower drawer. Mount the Overlay Panel 1. Mount the upper overlay panel to the drawer by aligning the panel fas
Resumen del contenido incluido en la página 18
Notes 18
Resumen del contenido incluido en la página 19
SEGURIDAD DE LA LAVAVAJILLAS Su seguridad y la seguridad de los demás es muy importante. Hemos incluido muchos mensajes importantes de seguridad en este manual y en su electrodoméstico. Lea y obedezca siempre todos los mensajes de seguridad. Este es el símbolo de advertencia de seguridad. Este símbolo le llama la atención sobre peligros potenciales que pueden ocasionar la muerte o una lesión a usted y a los demás. Todos los mensajes de seguridad irán a continuación del símbolo de advertencia d
Resumen del contenido incluido en la página 20
■ Instalar esta lavavajillas como se especifica en estas Usted necesita: instrucciones. ■ Abrir despacio el cajón de la lavavajillas mientras otra persona agarra la parte posterior de la lavavajillas. Quite el ■ Tener todo lo necesario para instalar la lavavajillas material de transporte. Cierre el cajón de la lavavajillas. Cierre adecuadamente. y asegure el cajón de la lavavajillas. ■ Ponerse en contacto con un instalador calificado para ■ Observar todos los códigos y reglamentos aplicabl
