Resumen del contenido incluido en la página 1
Initial Setup TV Operation
Basic Operation Timer Operation Advanced Operation For Your Information
LSQT0620A
Professional/ Industrial Video
TV / DVD / VCR Combination
Operating Instructions
Model No. AG-527DVDE
• Initial Setup and Connection Procedures are on pages 11 to 17.
As an ENERGY STAR Partner, Matsushita Electric Corporation of America
has determined that this product or product model meets the ENERGY STAR
guidelines for energy efficiency.
Please read these instructions carefully before
Resumen del contenido incluido en la página 2
Important Safeguards and Precautions OUTDOOR ANTENNA INSTALLATION READ AND RETAIN ALL SAFETY AND OPERATING INSTRUCTIONS. HEED ALL 1 SAFE ANTENNA AND CABLE CONNECTION An outside antenna or cable system must be properly WARNINGS IN THE MANUAL AND ON UNIT grounded to provide some protection ANTENNA INSTALLATION against built up static charges LEAD IN WIRE and voltage. Section 810 GROUND CLAMP 1 POWER SOURCE CAUTION ANTENNA of the National Electrical Code, DISCHARGE UNIT Operate only from power sou
Resumen del contenido incluido en la página 3
Safety Precautions/Mesures de sécurité Warning : To prevent fire or shock hazard, do not expose this equipment to rain or moisture. Caution : To prevent electric shock, match wide blade of plug to wide slot, fully insert. Avertissement : Afin de prévenir tout risque d’incendie ou de chocs électriques, ne pas exposer cet appareil à la pluie ou à une humidité excessive. Attention :Pour éviter les chocs électriques, introduire la lame la plus large de la fiche dans la borne correspondante de la pri
Resumen del contenido incluido en la página 4
Before Using Congratulations Loading the Batteries on your purchase of one of the most sophisticated and reliable products on the 1) Open the cover. market today. Used properly, it will bring you and your family years of enjoyment. Please fill in the information below. The serial number is on the tag located on the back of your unit. 2) Insert batteries as marked. Date of Purchase 3) Close the cover. Dealer Purchased From Dealer Address Battery replacement caution Dealer Phone No. Do not mix o
Resumen del contenido incluido en la página 5
Initial Setup TV Operation Basic Operation Timer Operation Advanced Operation For Your Information Table of Contents Initial Setup Important Safeguards and Precautions / Safety Precautions ........ 2 - 3 TV / VCR Before Using ........................................................................................ 4 Information (Unit, Cassette, Disc) .................................................. 6 - 7 Location of Controls .....................................................................
Resumen del contenido incluido en la página 6
Information (Unit, Cassette, Disc) Head Cleaning Specifications Display Playing older or damaged tapes may eventually Picture Tube: 27 inch measured cause video heads to become clogged. diagonal 100° deflection Head Clog Sensor Picture Tube VCR V I DEO HEADS MAY During playback this NEED CLEAN I NG Video Recording System:4 rotary heads helical screen appears if clogging PL EASE I NSERT HEAD CLEAN I NG CASSETTE scanning system is detected. To remove OR REFER TO MANUAL Audio Track:
Resumen del contenido incluido en la página 7
Initial Setup Disc formats supported by this unit Disc Handling The unit can play back discs bearing any of the following marks: Handling precautions DVD Only hold disc by edges as shown. 3” (8 cm) disc / 5” (12 cm) disc Fingerprints, dirt, and scratches can cause skipping and distortion. Video CD Do not write on label 3” (8 cm) disc / 5” (12 cm) disc side of disc. Never use record CD cleaning sprays, benzine, 3” (8 cm) disc / 5” (12 cm) disc thinner, static electricity prevention liquids,
Resumen del contenido incluido en la página 8
Location of Controls Remote Control Buttons EJECT/OPEN/CLOSE DVD See next page. Sets to DVD mode. POWER LIGHT Turns the unit on or off. See next page. TV/VCR DSS/CABLE Sets to TV/VCR mode. Sets the remote to control some basic DDS or Cable box functions. MUTE Mutes the sound instantly. FM Receives FM radio signal. CHANNEL UP/DOWN Selects a channel. VOLUME UP/DOWN Adjusts volume. SURROUND RAPID TUNE Creates a deeper, 3-D sound effect. Displays the last channel NUMBER Keys you were watching. S
Resumen del contenido incluido en la página 9
Initial Setup ® Universal Light Tower Illuminated Remote Control LIGHT button: When LIGHT is pressed, (DVD, , DSS/CABLE, CH UP/DOWN, VOL UP/DOWN) buttons will light for 5 seconds for easy button location. If no button is pressed in 5 seconds, the light goes out to conserve the batteries. EJECT/OPEN/CLOSE button: When this button is pressed in TV-VCR mode, the tape is ejected. This button is inoperative if pressed during recording. If pressed in DVD mode, the disc tray opens or closes. Indicators
Resumen del contenido incluido en la página 10
Location of Controls (continued) Front View of the unit If the disc cannot be removed... First, unplug unit. Then, prepare a rigid wire (e.g. an extended paper clip) and, applying moderate force, insert it straight into the hole at the base of the tray. The tray will eject a little. Now, pull the tray all the way out and remove the disc. Disc Tray Cassette Compartment DVD PHONES Built-In SpeakerX2 Connect an earphone or headphones. CHANNEL UP/DOWN (See page 8.) AUDIO/VIDEO IN TRACKING UP/DOWN
Resumen del contenido incluido en la página 11
Initial Setup Rear View of the unit Audio Output Connector (L/R) Pg. 12 VHF/UHF Antenna Input Terminal See below. Optical digital audio output connector VHF/UHF DIGITAL AUDIO OUT AUDIO OUT R L (PCM/BITSTREAM) OPTICAL Pg. 13 AC Power Plug When plugged into an AC outlet, this unit consumes 3.5 W of electric power in OFF condition. Connections For ANT./Cable Connect the cable from VHF/UHF Antenna/Cable to the VHF/UHF terminal on the unit. VHF/UHF DIGITAL AUDIO OUT AU R L DI
Resumen del contenido incluido en la página 12
Connections (continued) Ready Checklist Audio connections Turn down the volume, then turn this unit, as well as other equipment to be connected, off before proceeding with connection. Unit ➛ ➛ ➛ ➛ ➛ Amplifier ➛ ➛ ➛ ➛ ➛ Speaker Do not block ventilation holes of any of the equipment and arrange them so that air can circulate freely. Unit Read through the instructions before connecting other equipment. Ensure that you observe the color coding when connecting audio and video cables. Enjoying digit
Resumen del contenido incluido en la página 13
Initial Setup Unit ➛ ➛ ➛ ➛ ➛ Dolby Digital Decoder ➛ ➛ ➛ ➛ ➛ Amplifier ➛ ➛ ➛ ➛ ➛ Speaker or Unit ➛ ➛ ➛ ➛ ➛ dts (digital theater systems) Decoder ➛ ➛ ➛ ➛ ➛ Amplifier ➛ ➛ ➛ ➛ ➛ Speaker When DVDs recorded in Dolby Digital or dts are played, Dolby Digital bitstream or dts bitstream is output from the unit Optical digital audio output connector. When the unit is connected to a Dolby Digital decoder or dts decoder, you can enjoy theater-quality audio in your home. [An optical digital audio cable (op
Resumen del contenido incluido en la página 14
Initial Setup (Ready to Play) Please make all cable or antenna connections before powering on. Initial Setup (Ready to Play) Press on the remote for TV-VCR mode. Plug the unit power cord into an AC wall outlet. 1 Press POWER* on the remote or unit. The unit 2 comes on and auto channel and clock set starts. POWER CH AUTO SET PROCEEDING TV-VCR If you use a cable box, turn it on and set it to the Public Broadcasting Service (PBS) channel in your time zone. If you use a DSS receiver, it must be t
Resumen del contenido incluido en la página 15
Initial Setup Important: If a remote control button does not work when pressed, press the button on the remote * and try the button again. Manual Clock Set Reset all unit Memory Functions If AUTO CLOCK SET was incomplete, manually When moving unit to a new location, or if a set the clock as follows. mistake was made in the Initial Setup section. Make sure a tape is not inserted in the unit. Press ACTION on the Remote to display SET CLOCK Menu screen. 1 SET CLOCK DST : ON SELE CT MONTH SELEC
Resumen del contenido incluido en la página 16
Reset Language, Channels, Clock, M A I N MENU Press ACTION* to display MAIN MENU. 1 DVD LOCK LANGUAGE 1 3 5 CH TV CLOCK SELECT : SET : SET END : ACT I ON Language Channels Clock 2 1) Press to 1) Press to 1) Press select “CH.” select “CLOCK.” to select language icon. M A I N MENU M A I N MENU M A I N MENU DVD LOCK LANGUAGE DVD LOCK LANGUAGE 1 1 3 3 5 5 DVD LOCK LANGUAGE 1 TV CLOCK CH TV CLOCK CH 3 5 SELECT : SET : SET SEL
Resumen del contenido incluido en la página 17
Initial Setup Important: If a remote control button does not work * when pressed, press the button on Time Zone Adjust the remote and try the button again. Time Zone Adjust 4)Press and (Only when Auto Clock is set.) NUMBER press SET to select 1) Press to keys and set the month, select “CLOCK.” date, year, time, and M A I N MENU ADD/DLT DST (Daylight Saving SELECT Time). LOCK LANGUAGE DVD 1 3 5 To Make Corrections, SET TV CLOCK CH repeatedly press SELECT : SE
Resumen del contenido incluido en la página 18
Playback a Tape Record On a Tape Insert a tape with record tab. Ready Checklist The unit power comes on automatically. All connections are made. 1 Your unit is plugged in. Press CH or number keys to Insert a tape. Select Channel. 2 The unit power comes For “LINE” input, see bottom of next page. 1 on automatically. Press SPEED to select recording Record tab speed (see page 4). 3 SP = Standard Play To prevent tape jam, LP = Long Play remove loose or peeling SLP = Super Long Play labels from
Resumen del contenido incluido en la página 19
Basic Operation Important: If a remote control button does not work * when pressed, press the button on Copy Your Tapes (Dubbing) the remote and try the button again. Recording (Editing) unit Connections you’ll need to make Playing (Source) VCR R-AUDIO-L VIDEO IN FROM OUT ANT. VIDEO IN L-AUDIO IN-R MONO OUT TO IN TV Playback (Source) Recording (Editing) unit Insert blank tape Insert pre- recorded tape. with record tab. 1 Dubbing tapes protected with Copy Guard will have poor quality results.
Resumen del contenido incluido en la página 20
Basic DVD Operation Ready Checklist Press POWER* on the remote or unit. 1 All connections are made. (See pages 11-13.) Your unit is plugged in. Insert a disc. If unit is connected to an audio amplifier, If a disc is already inserted, go to step 3. turn the stereo system’s power on. 2 (Depending on the disc, playback may start automatically.) 1) Press OPEN/CLOSE. 2) Place disc into disc tray. Hold disc by its edges only (page 7) with printed side up and use guides to place into 1 tray. Use 1
