Manual de instrucciones de Dakota Digital MCL-3204

Resumen del contenido incluido en la página 1

7
6
5
4




MODEL MCL-3204
3-3/8” SPEEDOMETER/TACHOMETER for 2004 – up

IMPORTANT NOTE! This gauge has an odometer preset option that is only available one time in the first 100 miles
(160km) of operation. See “Odometer preset” for instructions.


GAUGE SETUP AND CALIBRATION
The setup menus are entered by holding the switch in while turning the key
on. The menus are as follows:
Menu Description
dIag read diagnostic codes
ADJUST adjust calibrate speed
vnIt select speed uni

Resumen del contenido incluido en la página 2

MOUNTING The gauge will mount using the original housing, grommet, and screws. Unbolt the two screws from the back plate at the back of the gauge housing, then unplug the factory gauge, noting the position of the grommets. There is one grommet on the front between the gauge and housing and one on the back between the housing and the back plate. Install the Dakota Digital gauge in reverse order installing grommets and then plugging into the factory plug and securing with the two screws.

Resumen del contenido incluido en la página 3

n n n nI I I Ig g g gH H H Ht t t t Night Dimming Your display system has a dimming feature that dims the display intensity automatically at night. Normally the system is at full brightness for daytime viewing. To have the system at full brightness all of the time, go into the setup menu as described above and select “ngt” (night). Press and release the function switch to select “OFF” instead of “on”. Press and hold the function switch to save the new setting. • Press and release the s

Resumen del contenido incluido en la página 4

P P P PE E E ER R R RF F F F Performance menu setup The performance readings can be turned on or off. When they are turned off the odometer display will only toggle through the mileage readings. • Press and release the switch until “PErF” is displayed, then press and hold the switch until “ - ” is displayed. • Release the switch. The current setting will be displayed (on or oFF). • Press and release the switch until the desired setting is displayed. • Press and hold the switch until “

Resumen del contenido incluido en la página 5

Troubleshooting guide Problem Possible cause Solution Gauge will not light up. Orange/White wire does not have power. Inspect and repair stock harness. Brown/Gray wire does not have power. Inspect and repair stock harness. Black wire is not getting a good ground. Inspect and repair stock harness. Gauge is damaged. Return gauge for repair. (see instructions) Clock resets when key is off. Brown/Gray wire does not have constant power. Inspect and repair stock har