Manual de instrucciones de Chamberlain CWA2000C

Resumen del contenido incluido en la página 1

®
Models CWA2000 & CWA2000C
WIRELESS MOTION ALERT
Overview
The Wireless Motion Alert uses a Passive Infra-Red (PIR) Motion Sensor to detect movement of people and vehicles, while allowing
small animals to pass through undetected. The Base Station is powered by the AC adapter and the 4 AA batteries supply power in case
of a power outage.
NOTE: The Base Station is intended for indoor use only.
Carton Inventory
Swivel Bushing
Sun/Rain Shield Mounting Plate AC Adapter
Base Station Passive Infra-R

Resumen del contenido incluido en la página 2

Assembly & Programming 1 4 A Ensure Base Station and PIR Learn Button Attach PIR Motion Sensor box Motion Sensor are in close to mounting plate with large proximity to each other. silver screw. Tighten screw Press and release Learn until PIR Motion Sensor stays Button on Base Station. in place when repositioned. Buzzer will sound. B Within 60 seconds, press the Learn Button 2 Install 4 AA Alkaline Learn Button on the inside of batteries. (Lithium batteries the PIR Motion Sensor. L

Resumen del contenido incluido en la página 3

Troubleshooting The PIR Motion Sensor lights up, but the Base Station does Base Station beeps every 30 minutes. not respond. The batteries in the Base Station or the PIR Motion Sensor(s) The PIR Motion Sensor must be programmed to Base Station are low. Replace the 4 AA batteries. Check the PIR Motion (See Step 4). Ensure Base Station is on and the volume is Sensor(s), if the LED illuminates on all of the PIR Motion turned up. Sensors, change the batteries in the Base Station. PIR Motion Senso

Resumen del contenido incluido en la página 4

NOTICE: To comply with FCC and or Industry Canada rules (IC), adjustment or modifications of this receiver and/or transmitter are prohibited, except for changing the code setting or replacing the battery. THERE ARE NO OTHER USER SERVICEABLE PARTS. Tested to Comply with FCC Standards FOR HOME OR OFFICE USE. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference