Manual de instrucciones de American Music & Sound Warp 250

Resumen del contenido incluido en la página 1

Warp 250™ Introduction
Unpacking: Thank you for purchasing the Warp 250™ by American
DJ®. Every Warp 250™ has been thoroughly tested and has been
shipped in perfect operating condition. Carefully check the shipping
carton for damage that may have occurred during shipping. If the
carton appears to be damaged, carefully inspect your fixture for any
damage and be sure all accessories necessary to operate the unit
have arrived intact. In the event damage has been found

Resumen del contenido incluido en la página 2

Warp 250™ Contents Warp 250™ General Instructions To optimize the performance of this product, please read these Introduction..........................................................................2 operating instructions carefully to familiarize yourself with the basic Features................................................................................3 operations of this unit. These instructions contain important safety Safety Precau

Resumen del contenido incluido en la página 3

Warp 250™ Operation Warp 250™ Operation ™ programs. Any unit can act as a master or a slave. Operating Modes: You can operate the Warp 250 in two different 1. Using standard XLR microphone cables, daisy chain your ADS modes: units together via the XLR connectors on the rear of the unit. • Stand-Alone mode (Usually for single unit operation) - The unit will Remember the Male XLR connector is the input and the Female react to sound, chasing through the built-

Resumen del contenido incluido en la página 4

Warp 250™ Set Up Warp 250™ Reset Breaker This unit uses a protective breaker to protect the unit in the event of Data Cable Requirements (For DMX and Master/Slave Oper- power surges or fluctuations. To reset the breaker, push the breaker ation): Your unit excepts 3-pin XLR connector for data input and button in until you hear it pop back in to place. If the breaker contin- data output (Figure 5) when linking for Master-Slave operation. If you

Resumen del contenido incluido en la página 5

Warp 250™ Trouble Shooting Warp 250™ Warranty Trouble Shooting: 1-YEAR LIMITED WARRANTY Listed below are a few common problems that you may encounter, A. American DJ® hereby warrants, to the original purchaser, American DJ® products to be with solutions. free of manufacturing defects in material and workmanship for a period of 1 Year (365 days) from the date of purchase. This warranty shall be valid only if the product is pu

Resumen del contenido incluido en la página 6

MODEL: WARP 250™ SPECIFICATIONS: 120V~60Hz / 220V~50Hz VOLTAGE*: LAMP: ZB-ELC 24V/250W DIMENSIONS: 11.5"(L) x 10"(W) x 4.5"(H) WEIGHT: 11 LBS BREAKER: 120V = 5 AMP GMA 220V = 2 AMP GMA WORKING POSITION: ANY SAFE POSITION DUTY CYCLE: NONE GOBOS: 11 COLORS: 10 PLUS WHITE WARRANTY: 1 YEAR (365 DAYS) * Voltage is preset at the factory Please Note: Specifications and improvements in the design of this unit and this manual are subject to change without an