Manual de instrucciones de American Standard Cadet 1.6 GPF Two-Piece Pressure Assisted Toilets 2366

Resumen del contenido incluido en la página 1

INSTALLATION INSTRUCTIONS
CADET 1.6 GPF TWO-PIECE PRESSURE-
ASSISTED TOILETS
- Model 2333 Elongated
- Model 2366 Round Front
- Model 2377 Elongated - 16-1/2" High Bowl
Thank you for selecting American Standard - the benchmark of fine quality for over 100 years. To ensure this
product is installed properly, please read these instructions carefully before you begin. (Certain installations may
require professional help.) Also be sure your installation conforms to local codes.
!
CAU

Resumen del contenido incluido en la página 2

4 5 WAX RING SEALANT NUT TAPERED WASHER FLANGE CLOSET BOLT INSTALL WAX SEAL Invert toilet on floor (cushion to prevent INSTALL TOILET ON FLANGE damage), and install wax ring evenly around a. Unplug floor waste opening and install toilet on closet flange waste flange (horn), with tapered end of ring so bolts project through mounting holes. facing toilet. Apply a thin bead of sealant b. Loosely install retainer washers and nuts. Side of washers around base flange. marked "THIS SIDE UP" must

Resumen del contenido incluido en la página 3

9 10 TANK SET SCREW 1/32" WATER INLET APPROX. WASHER FLEXIBLE COUPLING NUT SUPPLY VALVE NUT COMPRESSION COLLAR TRIM PLATE VALVE ADJUSTMENTS CAUTION: Overtightening of The flushometer tank is designed and factory-adjusted to provide a COUPLING NUT could result in consistent, safe seal depth in the bowl after each flush. Field refill breakage and potential flooding. adjustment is not required. The refill has been preset and locked. FLUSH ACTUATOR ADJUSTMENT - The spacing between the bellcr

Resumen del contenido incluido en la página 4

TROUBLESHOOTING GUIDE NOTE: The presence of a small amount of water in the bottom of the tank is normal. The air inducer is designed to leak for short periods during each flush cycle as a self-cleaning action. Drippage is drained into the bowl. If used on water system containing excessive sand and/or debris, a periodic cleanup of inlet strainer is recommended. (See enclosed instructions for strainer cleaning.) ! WARNING When servicing or replacing components of the flushometer