Manual de instrucciones de Chief Manufacturing Direct Attach Ceiling Mount JHS Series

Resumen del contenido incluido en la página 1

INSTALLATION INSTRUCTIONS
Instrucciones de instalación Istruzioni di installazione
Installationsanleitung Installatie-instructies
Instruções de Instalação Instructions d´installation
Direct Attach Ceiling Mount
Spanish Product Description
German Product Description
Portuguese Product Description
Italian Product Description
Dutch Product Description
French Product Description
JHS SERIES

Resumen del contenido incluido en la página 2

JHS SERIES Installation Instructions DISCLAIMER Milestone AV Technologies, Inc., and its affiliated corporations CAUTION: A CAUTION alerts you to the possibility of and subsidiaries (collectively, "Milestone"), intend to make this damage or destruction of equipment if you do not follow the manual accurate and complete. However, Milestone makes no corresponding instructions. claim that the information contained herein covers all details, conditions or variations, nor does it provide for every pos

Resumen del contenido incluido en la página 3

Installation Instructions JHS SERIES LEGEND Tighten Fastener Phillips Screwdriver Apretar elemento de fijación Destornillador Phillips Befestigungsteil festziehen Kreuzschlitzschraubendreher Apertar fixador Chave de fendas Phillips Serrare il fissaggio Cacciavite a stella Bevestiging vastdraaien Kruiskopschroevendraaier Serrez les fixations Tournevis à pointe cruciforme Loosen Fastener Hex-Head Wrench Aflojar elemento de fijación Llave de cabeza hexagonal Befestigungsteil lösen Sechskants

Resumen del contenido incluido en la página 4

JHS SERIES Installation Instructions Display Installation INSTALLATION 1. Determine mounting pattern on display. Mount Installation IMPORTANT ! : The following installation instructions WARNING: IMPROPER INSTALLATION CAN LEAD TO assume that a 1-1/2" NPT pipe has been properly EQUIPMENT FALLING CAUSING SERIOUS PERSONAL installed and is in place. INJURY AND DAMAGE TO EQUIPMENT! DO NOT 1. Thread mount (A) onto 1-1/2" NPT pipe until hand tight. substitute hardware. Use only hardware supplied by 2. A

Resumen del contenido incluido en la página 5

Installation Instructions JHS SERIES Adjustments To adjust display Roll, Pitch, and YAW tension: 1. Disconnect all wires and cable from the display. 2. Remove two Lower screws securing display to Centris cup. 3. Loosen two Upper screws securing display. 4. Lift display upward and away from mount. 5. Using a hex head wrench turn the tension adjustment screw clockwise to increase tension, or counter-clockwise to decrease tension. (See Figure 5) 6. Re-install display. 1 x2 Figure 3 2. Align two scr

Resumen del contenido incluido en la página 6

JHS SERIES Installation Instructions USA/International A 8401 Eagle Creek Parkway, Savage, MN 55378 P 800.582.6480 / 952.894.6280 F 877.894.6918 / 952.894.6918 Europe A Fellenoord 130 5611 ZB EINDHOVEN, The Netherlands Chief Manufacturing, a division of P +31 (0)40 2668620 Milestone AV Technologies F +31 (0)40 2668615 Asia Pacific A Room 24F, Block D, Lily YinDu International Building LuoGang, BuJi Town, Shenzhen, CHINA. 8805-000220 Rev A 2008 Milestone AV Technologies P +86-755-8996 9226 www.ch