Manual de instrucciones de American Standard Williamsburg 2808.222

Resumen del contenido incluido en la página 1

Installation
Instructions
TM
2808.222
2908.222
Widespread Lavatory Faucet with the
Speed Connect™ Drain
Congratulations on purchasing your American Standard faucet with
the Speed Connect Drain, a feature found only on
American Standard faucets.
Certified to comply with ANSI A112.18.1
Speed Connect Drain*
US60385 Rev. 1.2
• 1/3 of the parts, installs in 1/3 of the time
• No tools needed
• Never needs adjustment
• Guaranteed to seal properly the first time, every time.
*Your new American Sta

Resumen del contenido incluido en la página 2

INSTALL POP-UP DRAIN 2 Fig. A. Fig. B. REAR OF SINK Remove CLEAR PLASTIC COVER (1). 1 Remove CARDBOARD SPACER (2) from under DRAIN POP-UP (3). Fig. A. 4 3 Drop DRAIN BODY (4) through sink drain 6 hole. Make sure WHITE FOAM GASKET (5) 5 is under flange of DRAIN BODY (4). Fig. B. SINK Note: No plumber’s putty or caulk is required. DRAIN 2 HOLE The CABLE ATTACHMENT POINT (6) must face towards the rear of the SINK. Fig. B. INSTALL BLACK GASKET 3 Install BLACK CONE GASKET (1) onto DRAIN BODY (2) fr

Resumen del contenido incluido en la página 3

ATTACH CABLE CONNECTOR 6 Fig. A. Fig. B. Thread CABLE CONNECTOR (1) clockwise onto DRAIN BODY CONNECTION (2) and 1 hand tighten. Fig. A. Your new POP-UP DRAIN installation is now complete. Fig. B. Note: Tailpeice on pop-up drain is 1-1/4” O.D. Fig. B. 1-1/4” O.D. 2 CHECK OPERATION OF POP-UP 7 Operate LIFT KNOB (1) to verify that STOPPER (2) opens and closes. 1 Note: If STOPPER (2) does not open and close properly then refer to the “troubleshooting section” of these instructions. 2 MAKE WATER SU

Resumen del contenido incluido en la página 4

INSTALLATION OF OPTIONAL METAL LEVER INSTALL HANDLES 9 6 HANDLES (Supplied with Faucet) 6 Push ADAPTER (1) on VALVE Thread PORCELIAN LEVER HANDLE (2) counter-clockwise STEM (2), so that the hole of the and remove INDEX BUTTON with MOUNTING ROD ASSEMBLY (1). 5 ADAPTER (1) without spline is facing up. Insert MOUNTING ROD ASSEMBLY (1) into METAL HANDLE (3) and HANDLE COLLAR (4). Thread HANDLE BASE (3) onto 4 VALVE ESCUTCHEON (7) Thread HANDLE ASSEMBLY (6) into ball of HANDLE BASE (5) and tighten