Manual de instrucciones de Hans Grohe Axor Installation / Warranty Starck X

Resumen del contenido incluido en la página 1

Installation / Warranty
Starck X
10074001
03/2005
9.05739.01

Resumen del contenido incluido en la página 2

Starck X Wall Mount Lavatory Mixer 10074001


  Lavatory shown: Duravit Starck X 700 The installation height must be individually adjusted to the basin. Technical Data Flow rate 2.2 gpm Maximum water pressure 145 psi Recommended water pressure: 14.5 - 75 psi o o Recommended hot water temp.: 120 F - 140 F* o *Many municipalities require that the water heater be set no higher than 120 F. Know and follow all applicable local plumbing codes when setting the temperature on the water hea

Resumen del contenido incluido en la página 3

Prepare to install the faucet: This faucet requires 2 1/2” female threaded fittings, 3 1/8” apart (on center) for the hot and cold supplies. For proper operation of the faucet, the hot supply should be to the left, the cold to the right. These should be recessed 3/8” behind the surface of the finished wall. Finish and seal the wall before installing the faucet. Your local plumbing codes may require supply stops for the hot and cold water supplies. These should be installed in an easily accessi

Resumen del contenido incluido en la página 4

• Use the guide to adjust the offset adapters. The rear of the adapter should be no more than 5 mm (3/16”) in front of the surface of the finished wall. Make sure that the adapters are level! • Position the faucet over the offset adapters. Press firmly into place. Install and tighten the set screws, using the enclosed allen wrench.

Resumen del contenido incluido en la página 5

User Instructions: Pull the handle down to turn the water off. Push it up to turn the water on. Push the handle to the right for cooler water, to the left for warmer water. Replacement Parts 7 4 6 3 2 1 5 1 flange 96671000 2 handle 10092000 3 nut 96394000 4 cartridge cpl. 96339000 5 aerator cpl. 94005000 6 noise reduction (2) 94073000 7 ball S - unions (2) 94136001

Resumen del contenido incluido en la página 6

Cleaning Recommendation for Hansgrohe Products Modern faucetry and shower products utilize a combination of materials to comply with the needs of the market with regard to design and functionality. To avoid damage, it is necessary to use some caution when cleaning. Damage caused by improper treatment is not covered under the Hansgrohe warranty. Cleaning Materials for Faucets and Showers • To remove lime scale, use only products made specifically for that purpose. Always follow the manufacturer’

Resumen del contenido incluido en la página 7

THIS WARRANTY DOES NOT COVER, AND HANSGROHE WILL NOT PAY FOR: A. Conditions, malfunctions or damage not resulting from defects in material or workmanship. B. Conditions, malfunctions or damage resulting from (1) improper installation, improper maintenance, misuse, abuse, negligence, accident or alteration, or (2) the use of abrasive or caustic cleaning agents or “no rinse” cleaning products, or the use of the product in any manner contrary to the product instructions. C. Labor or other expenses

Resumen del contenido incluido en la página 8

Hansgrohe Inc. 1490 Bluegrass Lakes Parkway Alpharetta GA 30004 770 360 9880 website: www.hansgrohe-USA.com