Resumen del contenido incluido en la página 1
Bogen Enhancer
Instruction Manual
© 2005 Bogen Communications, Inc.
All Rights Reserved.
54-2141-01D 0804
Resumen del contenido incluido en la página 2
Contents Introduction ....................................................................................................................................................................... 3 Using This Manual ............................................................................................................................................................ 3 Enhancer System Contents ..........................................................................................................
Resumen del contenido incluido en la página 3
Introduction The Bogen Enhancer is an infrared wireless microphone system offering professional performance and operating features. Infrared transmission is used to reduce room-to-room interference while sending a sig- nal from a presenter’s microphone to a dual-channel receiver. The receiver works in tandem with an amplifier and speaker(s) to reduce the effects of poor room acoustics and the weakening effect of voice traveling through air. Using This Manual This manual provides instructions for
Resumen del contenido incluido en la página 4
System Features BCWR Dual-Channel Wireless Microphone Receiver • Dual Receiver, Simultaneous 2-Channel Operation for 2 Transmitters (Ch. A, Ch. B) • Infrared (IR) Signal Reception LED Indicators • Channel A/B Mixed Audio Output RCA-type Connector • Separate Channel A and Channel B Volume Controls • Two IR Sensor Coaxial-type Inputs BCWBT Body-Pack Transmitter • Multiple Emitter Array of High-Efficiency Infrared Emission LEDs for Optimum IR Transmission • "Power On" LED • Channel A/B Selector Swi
Resumen del contenido incluido en la página 5
BCWR Receiver 2 1 Front 3 4 5 6 16V AC POWER INPUT Rear Connecting the Audio Output The BCWR Receiver provides an unbalanced, line-level mixed output to the RCA Jack (3). This can be connected to a mixer or a P.A. system using the supplied RCA to RCA audio cable. The audio of both Channels A and B are mixed together at this output. The Channel A and B mix is dependent on the sepa- rate Channel A and Channel B Volume Control (4) settings located on the back panel of the receiver. Always make sure
Resumen del contenido incluido en la página 6
BCIRS Infrared (IR) Sensors Operation The IR Sensors act as "antennae" for your infrared wireless microphone system. A multiple array of wide-angle IR-sensitive LEDs (behind the front panel receptors) receive the infrared signal emitted 1 1 by your IR Transmitter. Connect each BCIRS Sensor 2 2 to the rear jacks on the BCWR (labeled IR In), then turn the BCWR Receiver ON. The Sensor Power LED (1) will light to indicate that the sen- sor is properly connected to the BCWR Receiver. The Channel A an
Resumen del contenido incluido en la página 7
BCWBT Body-Pack Transmitter Transmitter Setup 8 9 Slide down the Battery Compartment Cover (1), as shown, exposing the battery compartment. Insert 2 fresh AA alkaline batter- ies or the optional BCBRBP Battery Pack NiMH rechargeable batter- ies while observing the correct polarity as marked. Set the Channel . 4 5 Selector Switch (2) to the desired channel of operation and slide the cover back into position on the unit. (Note: Make sure the trans- 6 7 mitter is OFF when changing the batteries
Resumen del contenido incluido en la página 8
BCHM Headset Microphone Operation 3 2 a. The BCHM is provided with a 3.5mm Locking Connector (1) for connecting the microphone to the BCWBT Transmitter. Plug in the microphone’s connec- tor and secure the connection by turning the metal slip ring clockwise to thread it on the jack. To unplug, reverse the process. b. Wear Headset (2) so that it wraps around the back of the head. The curved Earpieces (3) will fit over the ears. 1 4 c. While wearing the Headset, adjust the Boom Arm (4) so that the
Resumen del contenido incluido en la página 9
BCWHT Handheld Microphone Transmitter Transmitter Setup Unscrew and remove the Battery Compartment Cover (1) by sliding it down off the microphone to expose the battery holder. Insert 2 fresh AA alkaline batteries or the optional BCHRBP Battery Pack NiMH 3 3 rechargeable batteries, while observing the correct 2 2 polarity as marked, and screw the cover back on the battery compartment. (Note: Make sure the transmitter is OFF when changing the batteries.) Operation Slide the Power Switch (2) to
Resumen del contenido incluido en la página 10
Specifications BCWR Receiver: Mode Infrared Frequency Modulated Receiving Channels Dual-Channels A & B Carrier Frequency Ch. A: 2.0 MHz; Ch. B: 2.6 MHz Audio Frequency Response 60 Hz-12 kHz S/N Ratio > 90 dB Audio Mix Output 400 mV Range (line-of-sight) Up to 30 ft. Controls Power ON/OFF (front); Ch. A and B Volume (rear) Connectors IR Sensor Coaxial-type Jacks, Ch. A/B (rear); AC Power input jack (rear); Audio Mixed output RCA-type Jack (rear) Power Requirements 16V AC, 600mA (via AC adapter) P
Resumen del contenido incluido en la página 11
Limited Warranty Bogen Enhancer products (BCWR Receiver, BCWBT Transmitter, BCLM Lavaliere Microphone, BCHM Headset Microphone, BCBM Body-Pack Microphone, BCIRS Infrared Sensors, BCYA Multiple Sensor Adapter, BCWHT Transmitter/Microphone, BCBRBP Battery Pack, BCHRBP Battery Pack, BCBRA Battery Charger and BCBC Battery Charger) are warranted to be free from defects in material or workmanship for one (1) year from the date of sale to the original purchaser. Any part of the product covered by this
Resumen del contenido incluido en la página 12
50 Spring St. Ramsey, N J 07446 Tel: 201-934-8500, Fax: 201-934-9832 www.bogen.com
