Resumen del contenido incluido en la página 1
User Manual
EURORACK
UB1202/UB1002
Ultra-Low Noise Design 12/10-Input 2-Bus Mic/Line Mixer
UB802/UB502
Ultra-Low Noise Design 8/5-Input 2-Bus Mixer
Resumen del contenido incluido en la página 2
2 EURORACK UB1202/UB1002/UB802/UB502 User Manual Table of Contents Important Safety Instructions ...................................... 3 Legal Disclaimer ............................................................. 3 Limited Warranty ........................................................... 3 1. Introduction ............................................................... 5 1.1 General mixing console functions ................................ 5 1.2 The user’s manual .......................
Resumen del contenido incluido en la página 3
3 EURORACK UB1202/UB1002/UB802/UB502 User Manual 9. Do not defeat the safety purpose of the polarized UNDERTAKING OR REPRESENTATION. THIS MANUAL Important Safety or grounding-type plug. A polarized plug has two blades IS COPYRIGHTED. NO PART OF THIS MANUAL MAY Instructions with one wider than the other. A grounding-type plug BE REPRODUCED OR TRANSMITTED IN ANY FORM has two blades and a third grounding prong. The wide OR BY ANY MEANS, ELECTRONIC OR MECHANICAL, blade or the third prong are pr
Resumen del contenido incluido en la página 4
4 EURORACK UB1202/UB1002/UB802/UB502 User Manual “Support” at behringer. com. If your country is not • connection or operation of the unit in any way (3) This warranty does not detract from the seller’s listed, please check if your problem can be dealt with that does not comply with the technical or safety obligations in regard to any lack of conformity of the by our “Online Support” which may also be found under regulations applicable in the country where the product and any hidden defect. “
Resumen del contenido incluido en la página 5
5 EURORACK UB1202/UB1002/UB802/UB502 User Manual 1. Introduction ◊ The block diagram supplied with the mixing console gives you an overview of the connections between the inputs and outputs, as well Congratulations! In purchasing our EURORACK UB502/UB802/UB1002/UB1202 as the associated switches and controls. you have acquired a mixing console whose small size belies its incredible versatility and audio performance. For the moment, just try and trace the signal path from the microphone input
Resumen del contenido incluido en la página 6
6 EURORACK UB1202/UB1002/UB802/UB502 User Manual 2. Control Elements and Connectors EQ This chapter describes the various control elements of your mixing console. The upper (HI) and the lower band (LO) are shelving filters that increase or All controls, switches and connectors will be discussed in detail. decrease all frequencies above or below their cut-off frequency. The cut-off frequencies of the upper and lower band are 12 kHz and 80 Hz respectively. 2.1 Mono channels The mid band (UB80
Resumen del contenido incluido en la página 7
7 EURORACK UB1202/UB1002/UB802/UB502 User Manual 2.2 Stereo channels BAL The BAL(ANCE) control determines the levels of left and right input signals 2.2.1 Stereo line inputs relative to each other before both signals are then routed to the main stereo mix bus. If a channel is operated in mono via the left line input, this control has the same function as the PAN control used in the mono channels. LEVEL The LEVEL control determines the volume of the channel being sent to the main mix. Fig.
Resumen del contenido incluido en la página 8
8 EURORACK UB1202/UB1002/UB802/UB502 User Manual 2.3.2 Monitor and main mix Alternatively the line or tape output of a hi-fi amplifier with source selection switch could also be hooked up here, allowing you to easily listen to additional sources. TAPE OUTPUT These connectors are wired in parallel with the MAIN OUT and carry the main mix signal (unbalanced). Connect the TAPE OUTPUT to the inputs of your recording device. The output level is adjusted via the high-precision MAIN MIX fader or
Resumen del contenido incluido en la página 9
9 EURORACK UB1202/UB1002/UB802/UB502 User Manual +48 V 3.2 Audio connections The red +48 V LED lights up when phantom power is on. The PHANTOM switch You will need a large number of cables for different applications. The illustrations activates the phantom power supply on the XLR connectors of all mono channels. below show how the connectors should be wired. Be sure to use only high-grade cables. ◊ Please do not connect microphones to the mixer (or the stagebox/wallbox) as long as the phanto
Resumen del contenido incluido en la página 10
10 EURORACK UB1202/UB1002/UB802/UB502 User Manual 4. Specifications Balanced ¼" TRS connector strain relief clamp Mono Inputs sleeve ring Microphone Inputs (IMP “Invisible” Mic Preamp) tip Type XLR connector, electronically balanced, discrete input circuit 1 sleeve Mic E.I.N. (20 Hz - 20 kHz) ground/shield @ 0 Ω source resistance -134 dB / 135.7 dB A-weighted ring cold (-ve) @ 50 Ω source resistance -131 dB / 133.3 dB A-weighted tip hot (+ve) @ 150 Ω source resistance -129 dB / 130.5 dB A
Resumen del contenido incluido en la página 11
11 EURORACK UB1202/UB1002/UB802/UB502 User Manual Power Supply Equalizer EQ Mono Channels Power Consumption LOW 80 Hz / ±15 dB UB1202: 23 W MID 2.5 kHz / ±15 dB UB1002: 18 W HIGH 12 kHz / ±15 dB UB802: 17 W EQ Stereo Channels UB502: 13 W LOW 80 Hz / ±15 dB Mains Voltage MID 2.5 kHz / ±15 dB USA/Canada 120 V~, 60 Hz, MXUL5 adapter HIGH 12 kHz / ±15 dB U.K./Australia 240 V~, 50 Hz, MXUK5 adapter Europe 230 V~, 50 Hz, MXEU5 adapter Send / Return Japan 100 V~, 60 Hz, MXJP5 adapter Aux
Resumen del contenido incluido en la página 12
We Hear You
