Resumen del contenido incluido en la página 1
SM-CMD3006
MULTIMEDIA DVD/CD/MP3 RECEIVER WITH BUILT-IN 4” TFT DISPLAY
AND TV TUNER
Instruction manual
DVD/CD/MP3- 4” TFT-
Resumen del contenido incluido en la página 2
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents..............................................................................................................................2 Important safeguards .......................................................................................
Resumen del contenido incluido en la página 3
Important safeguards - Using the device at temperature below -10º may cause the breakage of the device. BEFORE USING PLEASE HEAT UP THE PASSENGER COMPARTMENT TO THE RECOMMENDED TEMPERATURE! - Read carefully through this manual to familiarize yourself with this high-quality sound system. - Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. - When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage ra
Resumen del contenido incluido en la página 4
Installation/connection First complete the electrical connections, and then check them for correctness. Installation way It is an anti-theft installation way. The chassis wear a metal sliding housing. Please have the wiring connection of the power supply, speakers and antenna as for the requirement of the manual, and then install the metal sliding housing into the car according to the diagram. 4
Resumen del contenido incluido en la página 5
5
Resumen del contenido incluido en la página 6
Detachable control panel Detaching the front panel Press the REL button to remove the panel. Attaching the control panel 1. Insert the left side of the control panel into the main unit. 2. Press the control panel on to the right side of middle of it until a “click” sound is heard. Caution: DO NOT insert the control panel from the right side. It can damage the control panel. The control panel can easily be damaged by shocks. After removing it, place it in a protective case and be careful not to d
Resumen del contenido incluido en la página 7
Electrical connection Notes: 1. Only speakers with 4 ohms impedance may be used. 2. Ensure that the blue auto antenna cable does not make contact with any ground connection. 3. For your driving safety, please link your parking wire with low power level, and keep it controlled by manual brake switch. Wire should be high power level and the unit cannot play video disc. Caution: Do not interchange the connection of the wiring!!! For some car models you may need to modify wiring of the supplied powe
Resumen del contenido incluido en la página 8
Using the ISO Connector 1. If your car is equipped with the ISO connector, then connect the ISO connectors as illustrated. 2. For connections without the ISO connectors, check the wiring in the vehicle carefully before connecting, incorrect connection may cause serious damage to this unit. 3. Cut the connector, connect the colored leads of the power cord to the car battery as shown in the color code table below for speaker and power cable connections. Function Connector A Connector B 1 7 Rear
Resumen del contenido incluido en la página 9
Panel controls Front panel 1. PWR/MU button Press PWR/MU button to turn the power on, press and hold for 2 seconds to turn the power off. When the power is on press it to cut down the volume output, press it again to resume volume. 2. ANG button Use it to adjust the panel angle. 3. REL button Press it to detach the front panel. 4. MOD button Press it to select the mode: =>TUNER (radio) => DISC (the type of disc in the unit) => USB => SD/MMC => AUX => TV=>. 5. In TUNER mode press the TA button to
Resumen del contenido incluido en la página 10
Rotate VOL knob clockwise to increase the volume level; rotate anticlockwise to decrease the volume level. Press SEL repeatedly to select the modes: => VOL => BAS => TRE => BAL => FAD =>. Rotate VOL knob to adjust each mode. 7. In TUNER mode press the AF button to activate/deactivate the Alternative frequencies function. 8. TFT display 9. Infra red sensor 10. BND button In TUNER mode press it repeatedly to select your desired radio band. In DVD mode press it to choose TV mode: => PAL => PAL -M =
Resumen del contenido incluido en la página 11
In Tuner mode use it as tuner preset button. In MP3/WMA mode, long press it to go to the next 10 track. 20. USB jack 21. RESET button Press the RESET button to erase the users settings. 11
Resumen del contenido incluido en la página 12
Description of the Unit Chassis Facet After removing the Front Panel Description of the Unit Chassis Facet After Sliding Down the Front Panel 12
Resumen del contenido incluido en la página 13
Remote control 1. EQ button – press to select the corresponding equalizer preset modes to adjust the sound quality. 2. PWR button - press it to turn the power on, press again to turn the power off. 3. MODE button - press it to select the mode: => TUNER => DISC (the type of disc in the unit) => USB => SD/MMC => AUX => TV =>. 4. MU button - press it to cut down the volume output, press it again or press +/- buttons to resume volume. 5. SEL button - press SEL button repeatedly to select the modes:
Resumen del contenido incluido en la página 14
20. TILT button – use it to adjust the panel angle. 21. MENU button - In DVD mode press it to enter the disc menu. 22. cursor buttons / OK button - Use these buttons to navigate through menus and lists. Use OK to confirm. 23. / buttons - In Disc mode press these buttons to go to previous/next track. Press and hold for 2 seconds to start fast backward/forward playing. In TUNER mode press these buttons to start manual stations searching. Press them and hold for 2 seconds to start automatic station
Resumen del contenido incluido en la página 15
Changing the battery 1. Press the catch and at the same time pull out the battery tray. 2. Insert the 1 x lithium battery, type CR 2025 3V battery with the stamped (+) mark facing upward. Insert the battery tray into the remote control. Warning: Store the battery where children cannot reach. If a child accidentally swallows the battery, consult a doctor immediately. Do not recharge, short, disassemble or heat the battery or dispose it in a fire. Do not expose or bring into contact the battery wi
Resumen del contenido incluido en la página 16
General operation Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press the RESET button on the panel to restore the unit to the original factory settings. Power on/off Press PWR/MU button on the panel or PWR button on the RC to turn the unit on. Long press the PWR/MU button on the front panel or briefly press the PWR button on the RC to turn the unit off. Note: After the unit is off, the volume level and radio current settings wi
Resumen del contenido incluido en la página 17
Loud mode Press the LOUD button on the RC to turn on/ off LOUD mode. When turning on LOUD mode, it will enhance bass level immediately when the bass is not enough. Equalizer mode Press the EQ button on the RC to select the preset music equalizer curves: => POP => ROCK => CLAS => FLAT =>. The sound effect will be changed. Panel angle adjusting Press the TILT button on the RC or ANG button on the panel repeatedly to select a optical angle: => ANGLE0 => ANGLE1 => ANGLE2 => ANGLE3 => ANGLE4 =>. 17
Resumen del contenido incluido en la página 18
Digital tuner Note: RDS (Radio Data System) service availability varies with areas. Please understand if RDS service is not available in you area, the following service is not available, either. Band selection Press the MOD button on the panel or MODE button on the RC to select the TUNER mode. Press P/N / BAND button on the RC or BND button on the panel once or more to select: FM1, FM2, FM3, AM1, AM2. Display will show the wave band, frequency and preset station number if already stored. Manual/
Resumen del contenido incluido en la página 19
Local radio station search Press the LOC button on the RC shortly to turn the LOCAL function ON or OFF. When the LOCAL function is on the local stations (stations with weak radio signal) can be played. When the LOCAL function is off both local and distant stations (stations with strong radio signal) can be played. Press the button again to turn it of. RDS function There are the PI, PS, TP, PTY, TA, AF, DATA. PI: Program Identification Code – for identifying code. PS: Program Service Name Broadca
Resumen del contenido incluido en la página 20
Disc operations Disc glossary PBC (PlayBack Control) PBC is a menu recorded on the disc with SVCD or VCD2.0 format. For the discs contained PBC, it can playback interactive software with the menu displayed on TV. And if the disc contains still images, it can playback high definition of still image. Title The title is the important part of DVD disc. The memory volume of the disc is rather big, that makes possible to record several films on one disc. For example, if a disc contains three films, th
