Manual de instrucciones de Panasonic RC-CD600

Resumen del contenido incluido en la página 1

MODE
Specifications
Frequency range
CD Clock Radio
FM: 87.9–107.9 MHz (200 kHz steps)
Operating Instructions
87.5–108.0 MHz (100 kHz steps)
AM: 520–1710 kHz (10 kHz steps)
Model No. RC-CD600
Sampling frequency 44.1 kHz
Decoding 16 bit linear
Beam source Semiconductor laser
(wavelength 780 nm)
No. of channels 2 channel, stereo
Wow and flutter Less than possible measurement data
+
DA converter MASH (1 bit DAC)
VOL
-
Speakers 8 cm (3q) 6 ≠k2
Í/ I SLEEP RADIO CD
Jacks SLEEP SPEAKER MODE POWER FM/

Resumen del contenido incluido en la página 2

Setup Put the main and sub units either side of the bed. 1 1 Open the back panel of the sub unit and take out enough cord for R L 2 the distance between the units. 2 Close the panel, ensuring the cord fits into the slit at the bottom of the compartment. 1 Back of sub unit 2 Connect the cables to the terminals of the same 3 color, so + and - are correct. Never allow the exposed wires to contact each other Connect the AM loop antenna. when connected. Incorrect connection can damage 4 Stand the an

Resumen del contenido incluido en la página 3

PUSH OPEN/CLOSE Setting the time This is a 12-hour clock. This example shows how to set the clock for 3:30 P.M. Reset the clock regularly to maintain accuracy. (Monthly accuracy i/j 30 seconds.) TIME SET Press and hold [TIME SET] until the clock starts flashing. 1 1 Main unit Press [i, j, TUNE/CLOCK] to set the time. 2 [i]: increases the time in one-minute units [j]: decreases the time in one-minute units Press and hold to change the time faster. ENTER 3 Press [ENTER] to complete. TUNE/CLOCK 3 2

Resumen del contenido incluido en la página 4

^----------------------------------} MODE MODE MODE Í/ I POWER Í/I POWER Í/ I POWER SLEEP SLEEP SLEEP FM/AM FM/AM FM/AM RADIO CD RADIO CD RADIO CD + VOL - + VOL - + VOL - 1 2 3 4 5 1 2 3 4 5 1 2 3 4 5 MEMO MEMO MEMO Listening to the radio Manual tuning RADIO Press [FM/AM, RADIO] to select the band. DUAL FM/AM 1 1 FM FM 1 1 Each time you press the button: Main unit FM 1 ) FM 2 ) AM 1 ) AM 2 ^--------------------------------------------------} 2 TUNE/CLOCK EQ Press [i, j, TUNE/CLOCK] to tune to a

Resumen del contenido incluido en la página 5

^-------------------} ^-----------------} MODE MODE Í I POWER Í POWER / / I SLEEP SLEEP FM/AM FM/AM RADIO CD RADIO CD + VOL - + + VO VOL L - - 1 2 3 4 5 1 2 3 4 5 MEMO MEMO Using the alarms You can set the unit to play either a CD or the radio with ALARM 1, or to sound a buzzer with ALARM 2. You can set the two alarms separately and choose which unit the alarms are to sound from. Setting the CD/Radio alarm (ALARM 1) Setting the buzzer alarm (ALARM 2) ALARM OFF ALARM OFF DOZE DOZE TUNE/CLOCK TUN

Resumen del contenido incluido en la página 6

MODE / OW R Í I P E SLEEP FM/AM RADIO CD + VOL - 1 2 3 4 5 MEMO Control guide 13 2 4 5 K L 6 7 @ A CD CLOCK RADIO SUB SPEAKER UNIT 8 9 B : ; C < D J = > M ? E Sub unit 1 K DOZE:to shut off the alarm temporarily when speaker mode is DUAL F 5/9 2 or SUB L ALARM OFF: to shut off the alarm when speaker mode is DUAL or I G :/6 3 SUB M Speaker H MODE 4 5 Main unit SLEEP SPEAKER MODE 1 Clock @ 7 BRIGHTNESS 2 PUSH, OPEN/CLOSE: to open or close the CD lid A 9 3 DOZE: to shut off the alarm temporarily whe

Resumen del contenido incluido en la página 7

S E I R • T A S S U S D O N I C IMPORTANT SAFETY INSTRUCTIONS Read these operating instructions carefully before using the unit. Follow Care of the CD lens the safety instructions on the unit and the safety precautions listed below. Keep these operating instructions handy for future reference. Open the lid and clean the lens. Use a cotton swab to gently wipe off any finger-prints. Recommended product: Safety Lens cleaner kit (SZZP1038C) 1. Power source—Connect the unit to a power source of the t

Resumen del contenido incluido en la página 8

CAUTION! Product Service THIS PRODUCT UTILIZES A LASER. USE OF CONTROLS OR ADJUSTMENTS OR PERFORMANCE OF 1. Damage requiring service—The unit should be serviced by qualified service personnel if: PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY 1. (a) The AC power supply cord or AC adaptor has been damaged; or RESULT IN HAZARDOUS RADIATION EXPOSURE. 1. (b) Objects or liquids have gotten into the unit; or DO NOT OPEN COVERS AND DO NOT REPAIR YOURSELF. 1. (c) The unit has been exposed to rain; or