Manual de instrucciones de Rolls LIVEMIX MX34

Resumen del contenido incluido en la página 1

LIMITED WARRANTY
This product is warranted to the original consumer purchaser to be free
from defects in materials and workmanship under normal installation, use and
service for a period of one (1) year from the date of purchase as shown on the
purchaserís receipt.
The obligation of Rolls Corporation under this warranty shall be limited
MX34 LiveMix
to repair or replacement (at our option), during the warranty period of any part
which proves defective in material or workmanship under normal

Resumen del contenido incluido en la página 2

INTRODUCTION SPECIFICATIONS Thank you for purchasing the new MX34 LiveMix - two channel microphone mixer. Input Impedance: mic - 600 Ohms or greater XLR Although having many uses, this little mixer was originally designed with the video aux - 47K stereo 3.5mm camera operator in mind. Itís handy shoulder strap, easy-access microphone Level and Output Impedance: 50 Ohms Pan controls, and smart Input/Output jack placement make the MX34 ideal for the live THD + Noise: .02% recording enthusiast.

Resumen del contenido incluido en la página 3

SCHEMATIC DESCRIPTION FRONT PANEL LIVEMIX MX34 0 10 L R 0 10 L R 0 10 pan pan pwr OUTPUT LEVEL LEVEL LEVEL MIC 1 MIC 2 HEADPHONE MIC1 and MIC2 LEVEL: Adjusts the amount of signal of the indicated Microphone channel. PAN: Adjusts the relative level of signal from the channel to the Right/Left Output. pwr: When lit, indicates that the MX34 is on. A dim light indicates low battery voltage. HEADPHONE LEVEL: Adjusts the amount of signal from the Headph

Resumen del contenido incluido en la página 4

CONNECTION OPERATION Connect microphones to the MX34 via balanced XLR cables. Once your MX34 is properly connected, apply power by pressing in the POWER Stereo auxiliary sources such as the output from another mixer, AM/FM tuners, button on the rear panel. The blue pwr LED on the front panel should light. CD Players, and MP3 players may be connected to the AUX IN via a stereo 1/8î (3.5mm) Tip-Ring-Sleeve plug. If you are using condenser type microphones, apply the phantom power by Connect the ST