Manual de instrucciones de AMX Wireless Compact Flash Card NXA-WC80211GCF

Resumen del contenido incluido en la página 1

Installation Guide
NXA-WC80211GCF Wireless Compact Flash Card
For more detailed installation and operating instructions, refer to the related
NXA-WC80211GCF Specifications (Cont.)
MVP, CV7, and CV10 Instruction Manuals, available on-line at www.amx.com.
Power • @ 802.11b communication:
Consumption: - RX: 270 mA
- TX: 435 mA
- Standby: 240 mA
• @ 802.11g communication:
- RX: 270 mA
- TX: 460 mA
- Standby: 240 mA
PIFA antenna
with metal plate
Radio Data Rate: • 802.11g compliant: 1, 2, 5.5,

Resumen del contenido incluido en la página 2

Step 2: Install the new 802.11g CF Card and Antenna (MVPs) NXA-WC80211GCF Card and Antenna Overview 1. Discharge any static electricity from your body by touching a grounded This upgrade kit requires that pre-existing panels first be removed from their current location (surface, wall or docking station) before an installer can access metal object and then locate the wireless card slot on the main board (FIG. 3). the internal circuit boards and upgrade a pre-existing 802.11b wireless CF car

Resumen del contenido incluido en la página 3

Installation Guide NXA-WC80211GCF Wireless Compact Flash Card 8. Grab the battery cover and align it over the edges of the battery compart- ment. Apply downward pressure to the traction grooves on the Battery Compartment cover and slide it back towards the metal plate to reinstall the Mounting cover (FIG. 5). Template Note: Once the Wireless CF Card has been installed, be careful opening the Cutout MVP’s housing so that the CF card’s antenna (mounted to the inside of the bottom housing) is

Resumen del contenido incluido en la página 4

6. Locate the two screw holes at either sides of the front speaker grill and Caution: Use care when re-installing the outer housing. Improper then use a grounded Phillips-head screwdriver to remove the two Tilt re-installation can cause damage to the internal speakers. Bracket Screws (FIG. 7). 5. While holding the circuit board cover in place, turn the panel back over until the LCD lies facedown on a soft cloth and the under-side of the base This procedure both loosens the rear Tilt Bracke

Resumen del contenido incluido en la página 5

Installation Guide NXA-WC80211GCF Wireless Compact Flash Card Note: This information can be found in either the Workspace - System name > Caution: Speaker wires come Define Device section of your code (that defines the properties for your panel), or connected to this side of the main in the Device Addressing/Network Addresses section of the Tools > NetLinx board. Use caution when removing Diagnostics dialog. the back box. 7. From within the Wireless Security section, press/toggle On the Open

Resumen del contenido incluido en la página 6

9. Press the optional Host Name field to open an on-screen Keyboard and • The card should be given the SSID used by the target WAP. If this field is enter the Host Name information. left blank, the unit will attempt to connect to the first available WAP. By default, all WAP250Gs use AMX as their assigned SSID value. 10. Press Done after you are finished assigning the alpha-numeric string of the host name. • One of the most common problems associated with connection to a WAP 11. Press the Pr