Manual de instrucciones de 3Com 3CRWE920G73

Manual de instrucciones del aparato 3Com 3CRWE920G73

Aparato: 3Com 3CRWE920G73
Categoría: Router
Fabricante: 3Com
Tamaño: 0.37 MB
Fecha de añadido: 5/7/2013
Número de páginas: 13
Imprimir el manual

Descargar

¿Cómo se utiliza?

Nuestro propósito es proporcionarte el acceso más rápido posible a los contenidos incluidos en los manuales de instrucciones del aparato 3Com 3CRWE920G73. Utilizando la vista previa online, puedes ver rápidamente el índice de contenidos y pasar a la página donde encontrarás la solución a tu problema con 3Com 3CRWE920G73.

Para tu comodidad

Si ver los manuales de instrucción de 3Com 3CRWE920G73 directamente en esta página no es cómodo para ti, puedes utilizar dos soluciones posibles:

  • Vista en pantalla completa – Para ver cómodamente los manuales de instrucciones (sin descargarlos en tu ordenador) puedes utilizar el modo de vista en pantalla completa. Para activar la vista del manual 3Com 3CRWE920G73 en pantalla completa, utiliza el botón Pantalla completa
  • Descargar al ordenador – también puedes descargar el manual de instrucciones de 3Com 3CRWE920G73 a tu ordenador y guardarlo en tu colección. Sin embargo, si no quieres ocupar espacio en tu dispositivo, siempre podrás descargarlo de ManualsBase.
3Com 3CRWE920G73 Manual de instrucciones - Online PDF
Advertisement
« Page 1 of 13 »
Advertisement
Versión impresa

Muchas personas prefieren no leer el documento en la pantalla, sino en versión impresa. La opción de impresión también está prevista y puedes utilizarla haciendo clic en el enlace más arriba - Imprimir el manual. No tienes que imprimir el manual completo de 3Com 3CRWE920G73, solo las páginas que elijas. Ahorra papel.

Resúmenes

A continuación encontrarás resúmenes de los contenidos incluidos en las páginas posteriores del manual de instrucciones para 3Com 3CRWE920G73. Puedes utilizarlos si quieres ver rápidamente el contenido que se encuentra en la siguientes páginas del manual.

Resúmenes de contenidos
Resumen del contenido incluido en la página 1

Quick Start Guide



802.11g 54Mbps WLAN Building to Building
Bridge



Outdoor: 3CRWEASYG73

Indoor: 3CRWE920G73















http://www.3com.com/

Published July 2005
Quick Start guide version2.0.1

Resumen del contenido incluido en la página 2

1 Introduction Thank you for choosing the 3Com Corporation 802.11g 54Mbps Wireless LAN Building to Building Bridge. The outdoor version of 3Com 802.11g Wireless Bridge is ideal for rough outdoor environments and covering long distances, whereas the indoor version has a smaller profile to be unobtrusive and can be customized to the application with a variety of antenna selections. They can be configured as an inter-building wireless bridge with maximum 54Mbps transmission rate. This manu

Resumen del contenido incluido en la página 3

2 Package Contents Please ensure that the package is complete before beginning with the installation. The package should include the following components: 3CRWE920G73 3CRWEASYG73 Indoor 802.11g 54Mbps Building to Building Bridge Outdoor 802.11g 54Mbps Building to Building Bridge • 3Com 802.11g Wireless indoor Bridge • 3Com 802.11g Wireless Outdoor Bridge • Mounting kit for wall or ceiling mount • Mounting kit for wall or mast mount • CD-ROM containing software and documentation • CD

Resumen del contenido incluido en la página 4

3 Hardware Installation Installing the 3CRWE920G73 Indoor Wireless Bridge On a flat surface 1 Find a surface that is clear of debris. 2 Set the bridge down on its four rubber feet. On a wall 1 Use the mounting template as a guide to make two marks 7.40cm (2.91 inches) apart on the wall. Use the vertical line on the template to ensure that the placement of the marks is plumb to the wall. 2 Drill holes at the marks. Use a 5-mm (3/16-inch) drill bit if using the provided screw anch

Resumen del contenido incluido en la página 5

Connect the antenna 1 Connect one end of the antenna cable to the antenna. 2 Connect the free end of the antenna cable to the connection on the bridge. Follow the instructions that come with the antenna and follow these general guidelines: For best performance, place the antenna using the mounting hardware provided with the antenna. Outdoor placement is especially important if the building is of metal construction or has metal siding. If necessary, you can mount an antenna inside

Resumen del contenido incluido en la página 6

Installing the 3CRWEASYG73 Outdoor Wireless Bridge Mount the Unit to a Mast Follow the instructions that come with the bridge mounting hardware and follow the general guidelines listed below. NOTE: Mast should extend above bridge 1 meter (3 ft) Recommended Pole Diameter = 2’’ -- 2.5’ - ’ Maximum Pole Diameter = 3’’ Bridge may be installed to freestanding or roof mounted mast For best performance, place the antenna outdoors using the mounting hardware provided with the a

Resumen del contenido incluido en la página 7

Align and Polarize the Units For optimal performance, position the antenna so that there are minimal obstacles between it and any other antenna with which it will communicate. While maintaining a direct line of sight between antennas is not strictly necessary, such a configuration helps to ensure a strong signal. As mentioned earlier, this is not always possible in long distance configurations. Any two bridge units that are to communicate with each other must be set for the same polarizat

Resumen del contenido incluido en la página 8

Antenna Specification The following antennas and cables are available from 3Com Corporation: Antennas 3CWE591 - 6/8dBi Dual-Band 3CWE598 - 8/10dBi Dual-Band Panel 3CWE495 13 dBi Sector-Panel Omni directional Antenna Antenna Directional 3CWE596 - 18/20dBi Dual-Band Ultra Low Loss Coaxial Panel Antenna Antenna Cables: 3CWE580 (6 foot) 3CWE581 (20 foot) 3CWE582 (50 foot) NOTE: Because of power level restrictions, use of the 3CWE495 13dBi and 3CWE596 18d

Resumen del contenido incluido en la página 9

Connect to the Power Source and the Local Network 3CRWE920G73 Indoor Wireless Bridge Connect a twisted pair CAT5 Ethernet cable from the ’’To Hub/Switch’’ port of the PoE Adapter to a free port on the hub or switch within the local network 3CRWEASYG73 Outdoor Wireless Bridge NOTE: 3Com recommends that you use a weatherproof and shielded CAT5 cable to help protect the Bridge and your network equipment from lightning and power surges. If the Bridge failed to power on or if it

Resumen del contenido incluido en la página 10

LED Indicators After the correct connection, the Power LED and the Ethernet link LED of the 3CRWE920G73 indoor bridge should light up. On the front of the Wireless Bridge you will find three LEDs POWER WIRELESS ETHERNET 1 POWER LED Off: Power supply connection not available or broken On: Power supply connection OK 2 WIRELESS activity LED Off: No activity Blinking: Sending and receiving data 3 ETHERNET LAN link LED Off: No LAN connec

Resumen del contenido incluido en la página 11

5 Find your New Wireless Bridge To find your new Wireless Bridge you will need to connect the Wireless Bridge to the same physical LAN network as your PC. By default, the Wireless Bridge will use DHCP Client mode to get an IP address from a DHCP Server. If your network does not have a DHCP server, the Bridge uses a default IP address of 169.254.X.Y, where the X and Y is the last two bytes of the MAC address in decimal value respectively. You can use that default IP address to configure the

Resumen del contenido incluido en la página 12

If 3Com Wireless Infrastructure Device Manager (WIDMAN) finds that your PC cannot connect to the Wireless Bridge by IP, it would pop-up a dialog requesting that you change the IP address of the device. Then the utility will prompt you to enter the password of the bridge. [Note: default password is ‘‘blank’’] If the password is correct, you will be able to configure it through the WEB UI. [NOTE: It can take up to 60 seconds for the 3Com Building to Building Bridge to boot up after power

Resumen del contenido incluido en la página 13

6 Default Settings. Property Default Setting Device Name 3Com Building-to-Building Bridge Country For U.S. version, United States For non-U.S version, set by the user IP Network Setting Obtain IP address automatically IP Address Obtained automatically (with a DHCP server) 169.254.X.Y (without a DHCP server) Subnet Mask Obtained automatically (with a DHCP server) 255.255.0.0 (without a DHCP server) Default Gateway Obtained automatically (with a DHCP server) 0.0.0.0 (without a DHC


Manuales de instrucciones similares
# Manual de instrucciones Categoría Descargar
1 3Com 10014303 Manual de instrucciones Router 3
2 3Com 3C840 Manual de instrucciones Router 2
3 3Com 3CRWE454A72 Manual de instrucciones Router 32
4 3Com 3C13759 Manual de instrucciones Router 0
5 3Com 3C13636 Manual de instrucciones Router 1
6 3Com 3C13751 Manual de instrucciones Router 0
7 3Com 3CRWER100-75 Manual de instrucciones Router 287
8 3Com 3C13880 Manual de instrucciones Router 0
9 3Com AP3750 Manual de instrucciones Router 31
10 3Com 3CRWE754G72-A Manual de instrucciones Router 1
11 3Com WL-575 Manual de instrucciones Router 6
12 3Com MSR 50 Manual de instrucciones Router 8
13 3Com 6000 Manual de instrucciones Router 0
14 3Com WBR-6000 Manual de instrucciones Router 1
15 3Com MSR 30 Manual de instrucciones Router 5
16 Sony BKS-R3202/R3210/R3220 Manual de instrucciones Router 77
17 Sony DVS-V3232B/V3232M Manual de instrucciones Router 3
18 Sony BVS-V3232 Manual de instrucciones Router 8
19 Sony DMX-WL1 Manual de instrucciones Router 6
20 Sony BVS-A3232 Manual de instrucciones Router 6