Manual de instrucciones de HP (Hewlett-Packard) LaserJet RG5-1557

Resumen del contenido incluido en la página 1

800-551-1943

HP LaserJet 4V | 4MV Series Maintenance Kit Instructions Page 1

LJ 4V | 4MV Series Maintenance Kit:
1 HP RG5-1557 Fusing Assembly
1 HP RF5-0302 Separation Pad
1 HP RB1-1411 MP Pickup Roller
1 HP RG5-1410 Transfer Roller
2 HP RB1-1386 Dual Pickup Roller


Please Note: Turn the printer off, unplug it, and allow it to sit for 30 minutes before
performing these maintenance procedures.

This printer maintenance kit provides you with the parts most commonly us

Resumen del contenido incluido en la página 2

800-551-1943 HP LaserJet 4V | 4MV Series Maintenance Kit Instructions Page 2 To Reinstall: Be sure that the non-gear end of the shaft is to the right. Also make sure that the alignment slot (plastic tab) on the underneath side of the Transfer Roller slips over the locator pin (callout 2). CAUTION Do not remove two screws indicated in by the null symbol 2). Remove five machine shoulder screws (callout 3). a). Pull outward on the edges of the Front Door assembly to release the sh

Resumen del contenido incluido en la página 3

800-551-1943 HP LaserJet 4V | 4MV Series Maintenance Kit Instructions Page 3 2) Remove right side cover a. Release one tab towards top of cover and remove cover. 1). The Cassette Pickup Roller assembly is located under the Cartridge Guide. The removal of this assembly requires prior removal of the top and right side covers and will require a stubby Phillips screwdriver. a). Remove Paper Cassette and Cartridge Guide. The Cartridge Guide is located directly under the toner cartri

Resumen del contenido incluido en la página 4

800-551-1943 HP LaserJet 4V | 4MV Series Maintenance Kit Instructions Page 4 Cassette Pickup Roller Assembly To Reinstall: e). Thread the Pickup Roller Clutch Cable underneath the MP Drive Gears on the right end while sliding the shaft into position. CAUTION The next step is very important. If the clutch is not aligned properly, Paper will not feed. f). Be certain to align the alignment tabs with the notch on both the registration roller clutch and the pickup roller clutch.