Resumen del contenido incluido en la página 1
Compact Wall Mounted Type
PART NO.9332280012-02
Resumen del contenido incluido en la página 2
CONTENTS SAFETY PRECAUTIONS ......................................En-1 SWING OPERATION ..........................................En-11 FEATURES AND FUNCTIONS .............................En-2 ECONOMY OPERATION ....................................En-11 NAME OF PARTS .................................................En-3 MINIMUM HEAT OPERATION ...........................En-12 PREPARATION ......................................................En-5 MANUAL AUTO OPERATION ...........................En-1
Resumen del contenido incluido en la página 3
● Ensure that any electronic equipment is at least 3.3ft (1m) away from either the in- CAUTION! door or outdoor units. ● Avoid installing the air conditioner near a fi replace or other heating apparatus. ● When installing the indoor and outdoor unit, take precautions to prevent access to infants. ● Do not use infl ammable gases near the air conditioner. This appliance is not intended for use by persons (including children) with reduced ● physical, sensory or mental capabilities, or lack of exper
Resumen del contenido incluido en la página 4
NAME OF PARTS Fig. 1 Fig. 2 Fig. 3 Fig. 4 Fig. 5 Fig. 6 To facilitate explanation, the accompanying illustra- tion has been drawn to show all possible indica- tors; in actual operation, however, the display will only show those indicators appropriate to the cur- rent operation. En-3
Resumen del contenido incluido en la página 5
Fig. 1 Indoor Unit Fig. 5 Remote Controller 1 Operating Control Panel (Fig. 2) D Signal Transmitter 2 MANUAL AUTO button E MODE button ● When kept on pressing the MANUAL F MIN.HEAT button AUTO button for more than 10 sec- onds, the forced cooling operation will G ECONOMY button start. H SLEEP button ● The forced cooling operation is used at I TIMER MODE button the time of installation. Only for authorized service personnel's J FAN button use. K START/STOP button ● When the forced co
Resumen del contenido incluido en la página 6
PREPARATION CAUTION! Turn on the Power ● Take care to prevent infants from acci- dentally swallowing batteries. Turn on the circuit breaker 1 ● When not using the Remote Control- ler for an extended period, remove the batteries to avoid possible leakage and Load Batteries (AAA/R03/LR03 × 2) damage to the unit. ● If leaking battery fl uid comes in contact Press and slide the battery compartment lid on the with your skin, eyes, or mouth, imme- 1 reverse side to open it. diately wash with cop
Resumen del contenido incluido en la página 7
OPERATION To Select Mode Operation K Press the START/STOP button (Fig.5 ). 1 The indoor unit’s OPERATION Indicator Lamp (green) (Fig. 3 ) will 5 light. The air conditioner will start operating. E Press the MODE button (Fig.5 ) to select the desired 2 mode. Each time the button is pressed, the mode will change in the following order. ss s AUTO COOL DRY HEAT t FANt About 3 seconds later, the entire display will reappear. Example: When set to COOL. To Set the Thermostat N P
Resumen del contenido incluido en la página 8
OPERATION To Stop Operation K Press the START/STOP button (Fig. 5 ). The OPERATION Indicator Lamp (green) (Fig. 3 ) will go out. 5 About AUTO CHANGEOVER Operation AUTO: When AUTO CHANGEOVER operation fi rst selected, the fan will op- ● erate at very low speed for about a few minutes, during which time the indoor unit detects the room conditions and selects the proper operation mode. If the difference between thermostat setting and actual room tem- perature is more than +4 °F → Cooling or dr
Resumen del contenido incluido en la página 9
TIMER OPERATION Before using the timer function, be sure that the Remote Controller is set to the correct current time (☞ P. 5). To Use the ON timer or OFF timer To Cancel the Timer K Press the START/STOP button (Fig. 5 ) 1 Use the TIMER button to select “CANCEL”. (if the indoor unit is already operating, proceed to step 2). The indoor unit will return to normal opera- 5 The indoor unit’s OPERATION Indicator Lamp (green) (Fig. 3 ) will light. tion. To Change the Timer Settings Press the TIME
Resumen del contenido incluido en la página 10
SLEEP TIMER OPERATION Unlike other timer functions, the SLEEP timer is used to set the length of time until air conditioner operation is stopped. To Use the SLEEP Timer To Cancel the Timer: While the air conditioner is operating or stopped, press the Use the TIMER MODE button to select “CANCEL”. H SLEEP button (Fig. 5 ). The air conditioner will return to normal The indoor unit’s OPERATION Indicator Lamp (green) (Fig. 3 5) lights and the operation. 6 TIMER Indicator Lamp (orange) (Fig. 3 ) l
Resumen del contenido incluido en la página 11
1 2 3 4 5 6 ADJUSTING THE DIRECTION OF AIR CIRCULATION Vertical (up-down) direction of airfl ow is adjusted by pressing the Remote Controller's SET button. Horizontal (right-left) air- fl ow direction is adjusted manually, by moving the Air Flow Direction Louvers. Whenever making horizontal airfl ow adjustments, start air conditioner operation and be sure that the vertical air direction louvers are stopped. R DANGER! Vertical Air Direction Adjustment Never place fingers or foreign objects ● L
Resumen del contenido incluido en la página 12
SWING OPERATION Begin air conditioner operation before performing this procedure. To select SWING Operation M Press the SWING button (Fig. 5 ). The SWING Display (Fig. 6 Y) will light. In this mode, the Air Flow Direction Louvers will swing automatically to direct the air fl ow both up and down. To stop SWING Operation M Press the SWING button (Fig. 5 ) once again. The SWING Display (Fig. 6 Y) will go out. Airfl ow direction will return to the setting before swing was begun. About Swing Operation
Resumen del contenido incluido en la página 13
MINIMUM HEAT OPERATION To use MINIMUM HEAT OPERATION F Press the MIN. HEAT button (Fig.5 ) While MINIMUM HEAT OPERATION 5 The OPERATION indicator lamp (green) (Fig. 3 ) will go out, and the ECONOMY is in progress, only the following 7 indicator lamp (green) (Fig. 3 ) will light. operation can be used. � SWING � SLEEP To stop MINIMUM HEAT OPERATION Press the START/STOP button (Fig.5 K) Then the operation stops. ● Indicator Lamp About the MINIMUM HEAT Operation OPERATION � The Heating mo
Resumen del contenido incluido en la página 14
CLEANING AND CARE ● Before cleaning the indoor unit, be sure to turn it off and disconnect the Power Supply Cord. CAUTION! 8 ● Be sure the Intake Grille (Fig. 1 ) is installed securely. ● When removing or replacing the air fi lters, be sure not to touch the heat exchanger, as person- al injury may result. Cleaning the Intake Grille Cleaning the Air Filter 1. Remove the Intake Grille. 1. Open the Intake Grille, and remove the 1 Place your fingers at both lower ends of the grille air fi lter. pan
Resumen del contenido incluido en la página 15
CLEANING AND CARE 3. Replace them by two new Air cleaning Air Cleaning Filter Installation fi lters. 1. Open the Intake Grille and remove the Air 1 Remove the old air cleaning fi lters in reverse order of their installation. fi lters. 2 Install in the same way as for installation of the air 2. Attach the air cleaning fi lter to the frame cleaning fi lter set. of the front panel. 4. Install the two Air filters and close the ● Attach the fi lter on the inside of the tabs (6 places) Intake Grille.
Resumen del contenido incluido en la página 16
TROUBLESHOOTING In the event of a malfunction (burning smell, etc.), immediately stop operation, turn off the WARNING! electrical breaker and consult authorized service personnel. Merely turning off the unit’s power switch will not completely disconnect the unit from the power source. Always be sure to turn off the electrical breaker to ensure that power is completely off. Before requesting service, perform the following checks: Symptom Problem See Page Doesn’t operate immedi- ● If the indoor
Resumen del contenido incluido en la página 17
TROUBLESHOOTING Symptom Items to check See Page CHECK ONCE Doesn’t operate at all: ● Has the circuit breaker been turn off? MORE ● Has there been a power failure? — ● Has a fuse blown out, or a circuit breaker been tripped? ● Is the timer operating? 8 - 9 ● Is the Air Filter dirty? Poor Cooling (or Heating) performance: ● Are the air conditioner’s intake grille or outlet port blocked? ● Did you adjust the room temperature settings (thermostat) cor- rectly? ● Is there a window or door open? — ● I
Resumen del contenido incluido en la página 18
OPERATING TIPS AUTO Restart In Event of Power Interruption ● The power supply to the air conditioner is stopped by a ● If a power interruption occurs during TIMER operation, the power interruption. The air conditioner will then restart timer will be reset and the indoor unit will begin (or stop) automatically in its previous mode when the power is operation at the new time setting. In the event that this restored. kind of timer fault occurs, the TIMER Indicator Lamp will fl ash (see Page. 3)
Resumen del contenido incluido en la página 19
Resumen del contenido incluido en la página 20
