Resumen del contenido incluido en la página 1
HP VP6100 Series
Digital Projector
User’s Guide
Resumen del contenido incluido en la página 2
Notice Copyright © 2004 by Hewlett-Packard. All rights reserved. No part of this publication may be reproduced, transmitted, transcribed, stored in a retrieval system or translated into any language or computer language, in any form or by any means, electronic, mechanical, magnetic, optical, chemical, manual or otherwise, without the prior written permission of HP. HP makes no representations or warranties, either expressed or implied, with respect to the contents hereof and specifically di
Resumen del contenido incluido en la página 3
User’s Guide Table of Contents Introduction . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Safety Instructions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .5 Shipping Contents . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .6 Projector Description . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Resumen del contenido incluido en la página 4
User’s Guide Status Messages . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .29 Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 Projector Specifications . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 30 Timing Chart . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .31 Dim
Resumen del contenido incluido en la página 5
User’s Guide INTRODUCTION Warning TO PREVENT SHOCK, DO NOT OPEN THE CABINET. NO USER –SER- VICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL. PLEASE READ THIS USER’S GUIDE BEFORE YOU OPER- ATE YOUR PROJECTOR. SAVE THIS USER’S GUIDE FOR FUTURE REF- ERENCE . Safety Instructions 1. Read this user’s guide before you operate your projector and save it for future reference. 2. The lamp becomes extremely hot during operation. Allow the projector to cool for approximately 45 minut
Resumen del contenido incluido en la página 6
User’s Guide Shipping Contents The projector is shipped with the cables required for connection to standard PC or laptop computers. Carefully unpack and verify that you have all the items shown below. If any of these items are missing, please contact personnel at the place of purchase. Warranty and Support Quick Setup Guide Projector Audio/ Video Cable Audio Cable Remote Control User’s Guide CD VGA Cable Power Cord 6 Introduction
Resumen del contenido incluido en la página 7
User’s Guide Projector Description Projector External control panel Audio/ Video connector 11 1 (see next page) Projection lens Audio jack 12 2 Front adjuster USB mouse connector 13 3 IR remote sensor S-Video jack 4 14 Ventilation grill RS 232 control port 5 15 Speaker Rear adjuster feet 16 6 Focus and zoom adjusters Kensington lock slot 17 7 AC power cord inlet VGA signal input (PC) 8 18 VGA signal output Main power switch 9 19 YPBPR connector Lamp door 10 20 Introduction 7
Resumen del contenido incluido en la página 8
User’s Guide External Control Panel Power Lamp Indicator 1 8 Turns the projector on or off. The Lamp Indicator will light up when the lamp needs service, Auto Sync 2 cooling or replacement. See “Lamp Automatically determines the best Information” on page 25 for more picture settings for current received detailed information. signals. Temp indicator 9 3 5 4 6 < > ^ v The Temp indicator will light up Menu when the system temperature is 7 too high, which may occur if the Menu displa
Resumen del contenido incluido en la página 9
User’s Guide Adjuster The projector is equipped with 2 quick-release adjuster feet. Push the buttons to adjust its tilt angle. 1. Lift the projector up and press the adjuster button to release the adjuster. 2. The adjuster will drop into position and be locked. Projector Features The projector integrates high-performance optical engine projection and a user-friendly design to deliver high reliability and ease of use. The projector offers the following features: Small and light for port
Resumen del contenido incluido en la página 10
User’s Guide Remote Control Description Hide/ Show image Power Resync (Auto-sync) Source Menu Keystone Keystone Remote Control Effective Range The remote sensors are located on the front and the back of the projector. It can function in a range of 30 degrees horizontally and 30 degrees vertically relative to a line that is a right angle to the remote sensors. The distance between the remote control and the remote sensors must be shorter than 6 meters (19.5 feet). Removing the Battery Pro
Resumen del contenido incluido en la página 11
User’s Guide Replacing the Battery Push the holder Insert the new Pull out the battery 2 3 1 into the remote battery in the holder. control. holder. Caution Avoid excessive heat and humidity. There may be danger of an explosion if batteries are incorrectly replaced. Replace only with the same or equivalent type recommended by the manufacturer. Dispose of used batteries accord- ing to the manufacturer’s instructions. Introduction 11
Resumen del contenido incluido en la página 12
User’s Guide INSTALLATION Screen Size Place the projector at the required distance from the screen according to the desired picture size (see the table below). Projection Distance VP6120, VP6121 (XGA) screen size chart Diagonal measurement Diagonal measurement Distance from Distance from Minimum Maximum screen screen Minimum zoom Maximum zoom zoom zoom feet inches feet inches feet inches meters cm meters cm meters cm 4 48 2.49 29.9 3.05 36.6 1 100 0.62 62.2 0.76 76.2 6 72 3.73 44.8 4.
Resumen del contenido incluido en la página 13
User’s Guide VP6110, VP6111 (SVGA) screen size chart Diagonal measurement Diagonal measurement Distance from Distance from Minimum Maximum screen screen Minimum zoom Maximum zoom zoom zoom feet inches feet inches feet inches meters cm meters cm meters cm 4 48 1.96 23.5 2.40 28.7 1 100 0.49 48.9 0.60 59.9 6 72 2.93 35.2 3.59 43.1 1.5 150 0.73 73.4 0.90 89.8 8 96 3.91 47.0 4.79 57.5 2 200 0.98 97.8 1.20 119.8 10 120 4.89 58.7 5.99 71.9 2.5 250 1.22 122.3 1.50 149.7 12 144 5.87 70.4 7.19 86.2
Resumen del contenido incluido en la página 14
User’s Guide Connecting to Various Equipment It only takes a few seconds to connect your projector to your desktop or notebook computer, VCR, or other systems. However, a Mac adapter is needed for connection to Macintosh computers. 1. Computer The USB cable is not needed unless you have a remote control with mouse functions. 2. DVD player or HDTV 3. S-video device 14 Installation
Resumen del contenido incluido en la página 15
User’s Guide 4. Video device or VCR 5. Output monitor Installation 15
Resumen del contenido incluido en la página 16
User’s Guide OPERATION Start Up 1. Plug the power cord into the projector and into a wall socket. 2. Turn on the main power switch. 3. Press and hold POWER to start the unit. The back-lit POWER key flashes blue and stays blue when the power is turned on. Remote Control Projector (When the power is turned off, there is a 120-second cooling period before the projector can be re-started.) 4. Switch on all connected equipment. 16 Operation
Resumen del contenido incluido en la página 17
User’s Guide Digital Keystone Correction Keystoning refers to the situation where the projected image is noticeably wider at either the top or bottom. To correct this, press KEYSTONE / (hot key) on the control panel of the projector or on the remote control, and then adjust the sliding bar labeled Keystone, as needed. Press if the top of the image is too wide. Press if the bottom of the image is too wide. Projector menu Remote control keystone Auto Adjustment In some cases, you may need
Resumen del contenido incluido en la página 18
User’s Guide Source Selection When several input sources are available, press the SOURCE key to make a selection from the remote control or from the menu system. Remote control Projector Video and Audio Adjustments -- the Menu System 1. On the projector or remote control, press the Menu button. 2. Press < or > to select the desired menu. 3. Press v or ^ to select the desired parameter. 4. Press < or > to change the setting or open a sub-menu. 5. To change another parameter, press v or ^ t
Resumen del contenido incluido en la página 19
User’s Guide Quick Tab FUNCTION DESCRIPTION Selects picture source. Source *The operation of this function depends on the Source Scan setting. Corrects slanted edges of the image. Keystone Adjusts picture for type of input. Picture mode Synchronizes with input signal. Auto-sync Selects proportions of the image. Aspect ratio Operation 19
Resumen del contenido incluido en la página 20
User’s Guide Adjust Tab FUNCTION DESCRIPTION Brightens or darkens the image. Brightness Sets difference between light and dark areas. Contrast Adjusts timing relative to input signal. Frequency *This function is available only when the input source is PC. Adjusts synchronization to input signal. Tracking *This function is available only when the input source is PC. Shifts image up or down. V position *This function is available only when the input source is PC. Adjusts intensity of colors.
