Manual de instrucciones de Sanyo PLC 8810

Resumen del contenido incluido en la página 1

Sanyo Installation Configuration and Connections
SYSTEM 4xi xi xi xi xi
PROJECTOR COMMUNICATIONS KIT
ATTENTION!
PLEASE READ THIS DOCUMENT FOR IMPORTANT
INSTALLATION INSTRUCTIONS
THIS KIT HAS BEEN SHIPPED WITH THE FOLLOWING COMPONENTS:
Kit Type: SANYO
Included Communications Adapter(s):
Quantity Part Number Description
1 26-467-01 ADP, UNV, “A”
1 26-489-01 ADP, UNV, “J”
THE TABLE BELOW LISTS THE POSSIBLE CONFIGURATION(S) AND CORRESPONDING
COMMUNICATIONS ADAPTER(S) FOR YOUR PROJECTOR MANUFACTURER’

Resumen del contenido incluido en la página 2

Sanyo Installation Configuration and Connections Connecting System 4xi xi xi xi xi to Sanyo PLC If the System 4xi is already configured for a Sanyo PLC projector, go to step 4. If it is not set up correctly, it will be necessary to change switch settings on the System 4xi ’s Main Controller Board. Begin at Step 1 to verify the correct configuration. 1. Use the Front Panel to display the Information Menu to verify that the System 4xi is already set up for the Sanyo PLC. Apply power to the System

Resumen del contenido incluido en la página 3

Extron Com Adapter 26-467-01 "A" or 26-489-01 "J" Sanyo Installation Configuration and Connections 5. The Sanyo PLC Comm Adapter (26-467-01) has a 9-pin male connector that accommodates the Comm Extension cable. The other end of the Comm Adapter plugs into the projector’s RS-232C port. 6. Plug the 15-pin HD connector of the Projector Communications Extension cable into the PJ Comm port on the System 4xi. ______ Secure all of the connector screws. 7. Plug the (4 or 5) BNC connectors from one en