Resumen del contenido incluido en la página 1
GAS HOBS
ZGG 642
ZGG 782
INSTRUCTION BOOKLET
Please read this instruction booklet before using the appliance
GB
Resumen del contenido incluido en la página 2
Important Safety Information You MUST read these warnings carefully before installing or using the hob. If you need assistance, contact our Customer Care Department on 08705 727727 Installation Unstable or misshapen pans should not be used on This appliance must be installed and serviced by a the hob as unstable pans can cause an accident by competent person as stated in the Gas Safety ( tipping or spillage. Installation and Use) Regulations Current Editions and Never leave the hob unattende
Resumen del contenido incluido en la página 3
Contents For the User For the Installer Important safety requirements 9 Important Safety Information 2 Installation 10 Description of the Hob 4 Building In 11 Operation 5 Electrical connections 12 Maintenance and Cleaning 6 Wiring Diagram 13 Something Not Working? 7 Fault Finding 13 Service and Spare Parts 7 Commissioning 15 Guarantee/Customer Service 16 Conversion from Natural Gas to LPG 15 European guarantee 17 Guide to Use the instructions Environmental Information The following symbols will
Resumen del contenido incluido en la página 4
Description of the Hob ZGG 642 1 1 4 ZGG 782 1 3 2 3 2 1. Semi-rapid Burners 2. Rapid Burner 4 3. Auxiliary Burner 1 4. Control knobs 1 1. Semi-rapid Burners 2. Triple crown Burner 3. Auxiliary Burner 4. Control knobs 4
Resumen del contenido incluido en la página 5
Operation Hob burners To light a burner: push in the relevant control and turn it to maximum position; then adjust the flame as required. If the burner does not ignite, turn the control knob to zero, and try again. If you use a saucepan which is smaller than the recommended size, the flame will spread beyond the bottom of the vessel, causing the handle to overheat. Take care when frying food in hot oil or fat, as the overheated splashes could easily ignite. As soon as a liquid starts boiling
Resumen del contenido incluido en la página 6
Maintenance and Cleaning Before any maintenance or cleaning can be carried out, you must DISCONNECT the hob from the electricity supply. The hob is best cleaned whilst it is still warm, as spillage can be removed more easily than if it is left to cool. The Hob Top Regularly wipe over the hob top and the aluminium frame using a soft cloth well wrung out in warm water to which a little washing up liquid has been added. Avoid the use of the following: - household detergent and bleaches; - impregna
Resumen del contenido incluido en la página 7
Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. SYMPTOM SOLUTION There is no spark when lighting the gas Check that the unit is plugged in and the electrical supply is switched on Check that the RCCB h
Resumen del contenido incluido en la página 8
Instructions for the Installer Engineers technical data Semi-rapid Burner OVERALL DIMENSIONS Heat Input 1.9 kW (6,483 BTU/HR) ZGG 642 ZGG 782 Auxiliary Burner Width: 580 mm. 680 mm. Heat Input 1.0 kW (3,412 BTU/HR) Depth: 510 mm. 510 mm. Ultra-rapid Burner (triple crown) CUT OUT DIMENSIONS Heat Input 3.8 kW Natural Gas (12,966 BTU/HR) 3.8 kW L.P.G. (12,966 BTU/HR) ZGG 642 ZGG 782 Gas supply Natural gas G20 / 20mbar Width: 550 mm. 560 mm. Appliance class
Resumen del contenido incluido en la página 9
100 mm 100 mm 50 mm 50 mm 50 mm 50 mm 600 mm 600 mm Important safety requirements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition). For appliances installed in the Republic of Ireland please refer to NSAI- Domestic Gas Installation I.S. 813 Current Editions and the ETCI Rules for Electrical Installations. Provision for ventilation Detailed recommendations are contained in the followi
Resumen del contenido incluido en la página 10
Installation IMPORTANT WHEN THE HOB IS FIRST INSTALLED This hob must be installed by a competent Once the hob has been installed, it is important person to the relevant Gas Standards. to remove any protective materials, which were Any gas installation must be carried out by a put on in the factory. registered competent person. On the end of the shaft, which includes the GJ 1/2" The manufacturer will not accept liability, should threaded elbow, adjustment is fixed so that the washer the above ins
Resumen del contenido incluido en la página 11
Building In Building over a cupboard or drawer Dimensions are given in mm. If the hob is to be installed above a cupboard or drawer it will be necessary to fit a heat resistant board below 1 ON/OFF SWITCH the base of the hob on the underside of the work surface. It is also recommended to carry out the electrical connection to the hob as shown in diagrams 1 and 2. FLEX OUTLET Building over a kitchen unit with door Proper arrangements must be taken in designing the furniture unit, in order to avoi
Resumen del contenido incluido en la página 12
5 A a FO 2321 5 ZGG 782 a) Sealing gasket FO 2107 ZGG 642 Electrical connections Any electrical work required to install this hob A cut off plug inserted into a 13 amp socket is should be carried out by a qualified electrician or a seriuos safety (shock) hazard. Ensure that competent person, in accordance with the current the cut off plug is disposed of safely. regulations. THIS HOB MUST BE EARTHED. Permanent Connection The manufacturer declines any liability should these In the case of a perman
Resumen del contenido incluido en la página 13
Wiring Diagram L 1 A 0 2 3 4 220/240 5 A. IGNITOR SWITCH 6 B Brown B. IGNITOR UNIT N Fault Finding SOCKET PLUG (with cover Preliminary Electrical Systems (face view) removed) Check ( ) Earth Wire ( ) E Green/Yellow Blue Green START Yellow Isolate appliance and carry out: A: Earth Continuity Neutral Wire N L Blue check. Blue Green Brown Yellow Carry out: Electricity supply NO YES Carry out: D: Resistance to should now be C: Polarity check. Earth check. satisfactory. Has inlet fuse blown? A.
Resumen del contenido incluido en la página 14
Ignition System / Gas Ignition YES Check gas supply at Ignitor does not spark burner NO Check plug top fuse Light burner manually and replace if necessary Check polarity and Check by pass simmer earth continuity of adjusted supply point Check position of the Check earth continuity electrode of appliance Check continuity from the tip of Check fitting of burners Check continuity from 'N' on the each electrode to the mains connector block and "O" on terminals 1 to 4 on the ignitor the ignitor unit
Resumen del contenido incluido en la página 15
Commissioning When the hob has been fully installed it will be necessary to check the minimum flame setting. To do this, follow the procedure below. - Turn the gas tap to the MAX position and ignite. - Set the gas tap to the MIN flame position then turn the control knob from MIN to MAX several times. If the flame is unstable or is extinguished follow the procedure below. Procedure: Re-ignite the burner and set to MIN. Remove the control knob. FO 1042 To adjust, use a thin bladed screwdriver and
Resumen del contenido incluido en la página 16
Guarantee/Customer Service Standard guarantee conditions We, Zanussi-Electrolux, undertake that if within 12 months of the date of the purchase this Zanussi-Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: · The appliance has been correctly installed and used only on the electricity supply stated on the rating p
Resumen del contenido incluido en la página 17
European guarantee This appliance is guaranteed by Electrolux in each of the countries listed at the back of this user manual, for the period specified in the appliance guarantee or otherwise by law. If you move from one of these countries to another of the countries listed below the appliance guarantee will move with you subject to the following qualifications: • The appliance guarantee starts from the date you first purchased the appliance which will be evidenced by production of a valid purch
Resumen del contenido incluido en la página 18
18
Resumen del contenido incluido en la página 19
19
Resumen del contenido incluido en la página 20
www.zanussi-electrolux.co.uk 35668-9204 11/06 Grafiche MDM - Forlì
