Manual de instrucciones de Turbosound NUQ-10/DP

Resumen del contenido incluido en la página 1

Quickstart Guide
NuQ series

Models covered by this Quickstart Guide
NuQ-6, NuQ-8/DP, NuQ-10/DP, NuQ-12/DP, NuQ-15/DP, B-12DP, B-15/DP, B-18/DP.
Thank you for choosing a TURBOSOUND loudspeaker product for your application. If you would like further information
about this or any other TURBOSOUND product, please contact us on +44 (0)1403 711447. A detailed user manual on this
product range is available on our website at http://www.turbosound.com
Unpacking the Loudspeaker
After unpacking

Resumen del contenido incluido en la página 2

Quickstart Guide NuQ series Turbosound LMS-D2X controllers provide factory presets for all NuQ systems, downloadable from the Turbosound website, as well as additional user program slots. 1. Power up the controller(s) and associated power amplifiers. 2. Press RECALL to select the appropriate program from the preset menu using the ‘A’ ROTARY ENCODER. 3. Press RECALL again to accept the preset. The controller will un-mute and is then ready for use. Use as Monitor Wedges NuQ 2-way systems

Resumen del contenido incluido en la página 3

Quickstart Guide NuQ series network protocol among the networked devices and is carried over CAT5-type cables. Minimum system requirements are: PC with Pentium processor, Windows NT, 2000, XP, or Vista, CD ROM drive or internet access, RS232 or USB port  RS232:Connect your computer to the BvNet interface using a standard 9-pin serial cable. External power is required for RS232 operation and this should be supplied by the Linea Research Accessory Power Supply  USB: Connect your computer

Resumen del contenido incluido en la página 4

Quickstart Guide NuQ series SC-01 Scaffold Clamp NuQ-FY8 WB-20B PB-55 Flying yoke Wall Bracket Pole Bracket SC-01 SC-01 Scaffold Clamp Scaffold Clamp NuQ-FY8 NuQ-TB FlyingYoke NuQ-SB8 Twin Bar Swivel bracket NuQ-SBE8 Extender Bar To install a loudspeaker using Turbosound brackets, first separate the brackets into their wall/ceiling plate and speaker plate component parts. Remove the two countersunk M10 bolts on the rear panel of the cabinet. Attach the speaker plate to the cabinet with