Resumen del contenido incluido en la página 1
COMPACT COMPONENT SYSTEM
CA-MXGT90/CA-MXGT80
CA-MXG70
STANDBY/ON
STANDBY PLAY & EXCHANGE
CD-R/RW PLAYBACK
MX-GT90
CA-MXGT90
STANDBY/ON STANDBY/ON
PLAY & EXCHANGE STANDBY PLAY & EXCHANGE
STANDBY
CD-R/RW PLAYBACK CD-R/RW PLAYBACK
MX-GT80 MX-G70
CA-MXGT80 CA-MXG70
INSTRUCTIONS
For Customer Use:
Enter below the Model No. and Serial
No. which are located either on the rear,
bottom or side of the cabinet. Retain this
information for future reference.
Model No.
Serial No.
GVT0052-005A
[A]
CA-MXGT
Resumen del contenido incluido en la página 2
Warnings, Cautions and Others Caution — STANDBY/ON button! Disconnect the mains plug to shut the power off completely. The STANDBY/ON button in any position does not disconnect the mains line. The power can be remote controlled. CAUTION To reduce the risk of electrical shocks, fire, etc.: 1. Do not remove screws, covers or cabinet. 2. Do not expose this appliance to rain or moisture. CAUTION • Do not block the ventilation openings or holes. (If the ventilation openings or holes are blocked by a
Resumen del contenido incluido en la página 3
IMPORTANT FOR LASER PRODUCTS REPRODUCTION OF LABELS 1 CLASSIFICATION LABEL, PLACED ON REAR 1. CLASS 1 LASER PRODUCT 2. DANGER: Invisible laser radiation when open and inter- ENCLOSURE lock failed or defeated. Avoid direct exposure to beam. 3. CAUTION: Do not open the top cover. There are no user serviceable parts inside the Unit; leave all servicing to qualified service personnel. CLASS 1 LASER PRODUCT 2 WARNING LABEL, PLACED INSIDE THE UNIT DANGER: Invisible laser VARNING: Osynlig las
Resumen del contenido incluido en la página 4
Introduction We would like to thank you for purchasing one of our JVC products. Before operating this unit, read this manual carefully and thoroughly to obtain the best possible performance from your unit, and retain this manual for future reference. Power sources About This Manual • When unplugging from the wall outlet, always pull the This manual is organized as follows: plug, not the AC power cord. • The manual mainly explains operations using the DO NOT handle the AC power cord with wet butt
Resumen del contenido incluido en la página 5
Contents Location of the Buttons and Controls ....................... 3 Playing Back CDs (CD/CD-R/CD-RW) .................. 13 Front Panel ................................................................. 3 Loading CDs ............................................................ 13 Remote Control .......................................................... 5 Playing Back the Entire Discs — Continuous Play............................................. 14 Basic CD Operations .........................
Resumen del contenido incluido en la página 6
Location of the Buttons and Controls Become familiar with the buttons and controls on your unit. Front Panel Front Panel 1 STANDBY/ON PLAY & EXCHANGE STANDBY 2 3 i 4 CD-R/RW PLAYBACK o 5 ; a 6 s 7 8 d 9 f p g q h w j e r k t y l u / – 3 – EN01-12.CA-MXGT90&80&70[A]f 3 01.4.16, 10:08 PM
Resumen del contenido incluido en la página 7
Continued Display Window 1 2 3 4 5 6 7 8 9 p See pages in the parentheses for details. Front Panel 1 Disc trays s SOUND MODE control (10) 2 STANDBY/ON button and STANDBY lamp d SUBWOOFER LEVEL + / – control (10) (9, 22, 23) f TUNING + / – buttons (12) 3 Remote sensor 1 / Á (fast left/fast right) buttons (11, 14, 17) 4 ECO button (9) g VOLUME + / – control (10) 5 PRESET + / – control (12) h7 (stop) button (14 – 20, 23) 4 / ¢ (reverse search/forward search) control j Tape operation buttons (9, 11
Resumen del contenido incluido en la página 8
Remote Control Remote Control 1 Disc number buttons (CD1, CD2, and CD3) (14, 15) Pressing one of these buttons also turns on the unit. 2 Number buttons (12, 14, 15) 34 (reverse search) button (12, 14, 15, 17) 47 (stop) button (14 – 20, 23) 5 REC START/STOP button (18 – 20, 23) 1 6 SOUND MODE button (10) 8 7 FADE MUTING button (10) 8 STANDBY/ON button (9) 9 9 SLEEP button (24) p AUX button (9) p 2 Pressing this button also turns on the unit. q q FM/AM button (9, 12) Pressing this button also tur
Resumen del contenido incluido en la página 9
Getting Started Continued Supplied Accessories Connecting Antennas Make sure that you have all the following items. FM antenna The number in the parentheses indicates the quantity of the pieces supplied. • AM loop antenna (1) FM antenna (supplied) • FM antenna (1) • Remote control (1) • Batteries (2) If anything is missing, consult your dealer immediately. Putting the Batteries into the Remote Control Insert the batteries — R6(SUM-3)/AA(15F) — into the 1 Attach the FM antenna to the FM 75 Ω remo
Resumen del contenido incluido en la página 10
AM antenna Connecting Speakers 1 3 ANTENNA 2 Vinyl-covered wire (not supplied) AM EXT Red 1 AM LOOP Speaker cords Speaker cords SUBWOOFERS (red/black) (red/black) RIGHT LEFT FM 75 COAXIAL Black Black RIGHT LEFT MAIN SPEAKERS CAUTION: SPEAKER IMPEDANCE 616 2 Blue AM loop antenna (supplied) Speaker cords (blue/black) 1 Connect the AM loop antenna to the AM LOOP terminals as illustrated. • If the AM loop antenna wire is covered with vinyl, remove the vinyl by twisting it as shown in the diagram. 2
Resumen del contenido incluido en la página 11
Connecting Other Equipment Now, you can plug the AC power cord. You can connect both analog and digital equipment. When connecting the AC power cord into a wall outlet, the unit automatically starts display demonstration. • DO NOT connect any equipment while the power is on. • DO NOT plug in any equipment until all IMPORTANT: Be sure to check all connections to be done connections are complete. before plugging the AC power cord into a wall outlet. To connect an analog component Be sure that the
Resumen del contenido incluido en la página 12
Common Operations Turning On or Off the Power 2 Turn 4 / ¢ to adjust the hour, then press STANDBY/ON To turn on the unit, press SET/DISPLAY. STANDBY/ON so that the STANDBY The minute digits start flashing on the STANDBY lamp goes off. display. To turn off the unit (on standby), press STANDBY/ON STANDBY/ON again so that the • If you want to correct the hour STANDBY lamp lights up. STANDBY after pressing SET/DISPLAY, press • The clock appears on the display (if CANCEL/DEMO. Ecology Mode is not a
Resumen del contenido incluido en la página 13
Continued Adjusting the Volume Selecting the Sound Modes You can adjust the volume level only while the unit is turned You can select one of the 6 preset sound modes (3 surround on. The volume level can be adjusted in 32 steps (VOL MIN, modes and 3 SEA — Sound Effect Amplifier — modes). This VOL 01 — VOL 30, and VOL MAX). function only affects the playback sound, but does not affect your recording. Turn VOLUME + / – clockwise (+) to increase the volume or To select the sound modes, turn counterc
Resumen del contenido incluido en la página 14
Creating Your Own Sound Mode 4 Press SET/DISPLAY again. — Manual Mode You can change SEA pattern to suit your preference. These changed settings can be stored in the MANUAL 1, MANUAL 2, and MANUAL 3 modes. • There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again. 5 Turn 4 / ¢ to select one of On the unit ONLY: the MANUAL 1, MANUAL 2, and MANUAL 3 modes into 1 Select one of the preset sound modes. which you want to store the • If
Resumen del contenido incluido en la página 15
Listening to FM and AM Broadcasts Tuning in a Station On the unit ONLY: 1 Tune in the station you want to preset. 1 Press FM/AM. • See “Tuning in a Station.” The unit automatically turns on and tunes in the previously tuned station 2 Press SET/DISPLAY. (either FM or AM). • Each time you press the button, the band alternates between FM and AM. 2 Start searching for stations. On the unit: 3 Turn PRESET + / – to select Press and hold TUNING + a preset number. or TUNING – for more than 1 second. On
Resumen del contenido incluido en la página 16
Playing Back CDs (CD/CD-R/CD-RW) This unit has been designed to playback the following CDs: Loading CDs • CD (Audio CD) • CD-R (CD-Recordable) On the unit ONLY: • CD-RW (CD-ReWritable) 1 Press 0 for the disc tray (CD1, CD2, and CD3) you Continued use of irregular shape CDs want to load a CD onto. (heart-shape, octagonal, etc.) can damage The unit automatically turns on and the System. the disc tray comes out. 2 Place a disc correctly on the circle of the disc General Notes tray, with its label s
Resumen del contenido incluido en la página 17
Continued Playing Back the Entire Discs Basic CD Operations — Continuous Play While playing a CD, you can do the following operations. To exchange CDs during playback of another 1 Load CDs. Press 0 corresponding to a CD, not playing or selected currently, to eject and exchange the CD. 2 Press one of the disc number If you exchange CDs during play, the current play will not buttons (CD1, CD2, and stop until all CDs you have exchanged are played. CD3) for the disc you want to play. CD play starts
Resumen del contenido incluido en la página 18
Programming the Playing Order of the Tracks 5 Program other tracks you want. — Program Play • To program tracks from the same disc, repeat step 4. • To program tracks from a different disc, repeat steps 3 You can arrange the order in which tracks play before you and 4. start playing. You can program up to 32 tracks. • To use Repeat play (see page 16) for Program play, press 6 Press CD 3´8. REPEAT after starting Program play. The tracks are played in the order you • There is a time limit in doing
Resumen del contenido incluido en la página 19
Playing at Random — Random Play Repeating Tracks or CDs — Repeat Play The tracks of all loaded CDs will play at random. You can have all the CDs, the program or the individual track • To use Repeat play for Random play, press REPEAT after currently playing repeat as many times as you like. starting Random play. On the unit ONLY: 1 Load CDs. To repeat playing, press REPEAT during or • If the current playing source is not the CD player, press before play. To use Repeat play for Program CD 3´8, the
Resumen del contenido incluido en la página 20
Playing Back Tapes You can play back type I, type II, and type IV tapes without To play both sides repeatedly — Reverse Mode changing any settings. Reverse Mode works for both decks at the same time. When it is in use, the tape automatically reverses at the end of a side and the unit starts playing for the other side of the tape, Playing Back a Tape and repeats the same process. To use Reverse Mode, press 1 Press EJECT (0) for the deck you want to REVERSE MODE so that the Reverse Mode use. indic
