Manual de instrucciones de Bryston BP6DA

Resumen del contenido incluido en la página 1

BP6
PREAMPLIFIER
OWNER’S MANUAL
For preamp models
BP6, BP6DA & BP6P

Resumen del contenido incluido en la página 2

IMPORTANT SAFETY INSTRUCTIONS The lightning flash with arrowhead symbol within an equilateral triangle, is intended to alert the user to the presence of un-insulated “dangerous voltage “ within the product’s enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompan

Resumen del contenido incluido en la página 3

2

Resumen del contenido incluido en la página 4

BP6 Preamplifiers GENERAL SPECIFICATIONS: Additional Specifications for BP6DA: Frequency Response: 20Hz-20kHz ±.05dB Input Sample Rate: 16kHz to 108kHz. Word Length: 16, 18, 20, 24 Bit Data format: SPDIF standard Maximum Output: 15 Vrms Distortion: < 0.002%, 20Hz-20kHz IMD/THD: <0.0015% at 3 volts out Signal to Noise Ratio: > 100dB Frequency Response: 20Hz-20kHz ±.1dB Sensitivity: 500 mV (excluding phono inputs) Noise: -100dB (Ref. 500mV input, 20-20kHz) Additional Specifications for

Resumen del contenido incluido en la página 5

BP6 Preamplifiers INTRODUCTION HEADPHONE JACK Thank you for choosing a Bryston Preamplifier. Bryston A quarter inch stereo (3 conductor) headphone jack is locat- welcomes any suggestions you may have, or comments ede on the front panel of all BP6 pre-amps. We recommend regarding the operation of your amplifier. We consider you, the use of headphones with input impedances between our customer, to be Bryston’s most important resource, 50 ohms and 600 ohms. Headphones with an impedance a

Resumen del contenido incluido en la página 6

BP6 Preamplifiers MOVING MAGNET PHONO EQUALIZATION MODULE (optional) Bryston’s optional phono stage circuitry features highly accurate equalization, extremely low noise and distor- tion and provides headroom margins sufficient to prevent overload from any known phono source. If your turntable provides a separate ground lead system noise may be mini- mized by connecting it to the ground post adjacent to the phono inputs on the rear panel. Input impedance is 50K ohms and sensitivity is 5mV. D