Resumen del contenido incluido en la página 1
Contents
AV RECEIVER
Safety Information and Introduction ............2
Table of Contents...........................................6
TX-NR1010
Connections .................................................13
Turning On & Basic Operations..................23
Instruction Manual
Advanced Operations ..................................54
Controlling Other Components...................88
Appendix.......................................................97
Internet Radio Guide
Remote Control Codes
En
Resumen del contenido incluido en la página 2
Safety Information and Introduction 9. Do not defeat the safety purpose of the polarized or D. If the apparatus does not operate normally by grounding-type plug. A polarized plug has two blades following the operating instructions. Adjust only WARNING: with one wider than the other. A grounding type plug those controls that are covered by the operating TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, has two blades and a third grounding prong. The wide instructions as an improper adjustment of
Resumen del contenido incluido en la página 3
Safety Information and Introduction 5. Preventing Hearing Loss For U.S. models Precautions Caution FCC Information for User Excessive sound pressure from earphones and 1. Recording Copyright—Unless it’s for personal use CAUTION: headphones can cause hearing loss. only, recording copyrighted material is illegal without The user changes or modifications not expressly approved 6. Batteries and Heat Exposure the permission of the copyright holder. by the party responsible for compliance could vo
Resumen del contenido incluido en la página 4
Safety Information and Introduction For Canadian Models IMPORTANT The plug is fitted with an appropriate fuse. If the fuse needs NOTE: THIS CLASS B DIGITAL APPARATUS to be replaced, the replacement fuse must approved by COMPLIES WITH CANADIAN ICES-003. ASTA or BSI to BS1362 and have the same ampere rating For models having a power cord with a polarized plug: as that indicated on the plug. Check for the ASTA mark or CAUTION: TO PREVENT ELECTRIC SHOCK, the BSI mark on the body of the fuse. M
Resumen del contenido incluido en la página 5
Safety Information and Introduction ■ Aiming the remote controller Supplied Accessories To use the remote controller, point it at the AV receiver’s remote control sensor, as shown below. Make sure you have the following accessories: Remote control sensor Indoor FM antenna (➔ page 21) AM loop antenna (➔ page 21) AV receiver (North American models) Two AM loop antennas and two Indoor FM antennas are supplied. Power cord (➔ page 22) Speaker cable labels (➔ page 14) Speaker setup microphone (➔ pag
Resumen del contenido incluido en la página 6
Safety Information and Introduction Playback ......................................................................26 Multi Zone ................................................................... 83 Table of Contents Playing the Connected Component ..........................26 Making Multi Zone Connections ............................... 83 Controlling Contents of USB or Network Devices.....27 Controlling Multi Zone Components ......................... 85 Understanding Icons on the Display ...
Resumen del contenido incluido en la página 7
Safety Information and Introduction Connections Miscellaneous Features 9 HDMI Inputs (1 on front panel) and 2 Outputs 40 FM/AM Presets Amplifier Zone 2 HDMI Output Dolby Volume ® Audyssey MultEQ XT32 to correct room acoustic Onkyo for System Control 140 Watts/Channel @ 8 ohms (FTC) problems 6 Digital Inputs (3 Optical/3 Coaxial) 200 Watts/Channel @ 6 ohms (IEC) ® Audyssey Dynamic EQ for loudness correction Component Video Switching (2 Inputs/1 Output) WRAT–Wide Range
Resumen del contenido incluido en la página 8
Safety Information and Introduction Front & Rear Panels Front Panel (North American models) (European models) En-8
Resumen del contenido incluido en la página 9
Safety Information and Introduction For detailed information, see the pages in parentheses. PHONES jack (52) ON/STANDBY button (23) ZONE 2, ZONE 3, and OFF buttons (85) Remote control sensor (5) TONE and Tone Level buttons (55) Display (10) MONITOR OUT button (60) MASTER VOLUME control and indicator (26, 51) DISPLAY button (51) HYBRID STANDBY indicator (59) TUNING / (34), PRESET / (34), cursor and enter (middle) buttons PURE AUDIO button and indicator (42) DIMMER
Resumen del contenido incluido en la página 10
Safety Information and Introduction Display s For detailed information, see the pages in parentheses. Input indicators (109) Speaker/channel indicators HDMI indicator (80) Z2 (Zone 2) indicator (85) DIGITAL indicator ANALOG indicator Z3 (Zone 3) indicator (85) Bi AMP indicator Listening mode and format indicators (42, 77) Audyssey indicator (39, 72) M.Opt indicator (57) Dynamic EQ indicator (72) , and cursor indicators (28) (Dolby) Vol indicator NET indicat
Resumen del contenido incluido en la página 11
Safety Information and Introduction Rear Panel (North American models) (European models) RS232 port ZONE 2 and ZONE 3 LINE OUT jacks PRE OUT jacks Terminal for control. *1 (FRONT L/R, CENTER, SURR L/R, SB/FH/FW MAIN/ZONE 2 FM ANTENNA jacks and L/R, SW1 and SW2) MAIN/ZONE 2 AM ANTENNA terminals DIGITAL IN COAXIAL and OPTICAL jacks *1 SB···Surround Back, FH···Front High, FW···Front Wide PC IN jack USB port *1 SB/FH/FW EXT AMP jacks AC INLET ETHERNET port
Resumen del contenido incluido en la página 12
Safety Information and Introduction ■ Controlling the tuner To control the AV receiver, press RECEIVER to select Remote Controller To control the AV receiver’s tuner, press TUNER (or Receiver mode. RECEIVER). You can also use the remote controller to control Controlling the AV Receiver You can select AM or FM by pressing TUNER repeatedly. Onkyo Blu-ray Disc/DVD player, CD player, and / buttons ( 34) other components. See “Entering Remote Contro
Resumen del contenido incluido en la página 13
Connections Connecting the Speaker Cables Connecting the AV Receiver ■ 7.2-channel playback The following illustration shows how to connect the speakers to each pair of terminals. If you’re using only one surround back speaker, connect it to the SURR BACK L terminals. Select the speakers (surround back, front high, front wide) you Connecting Your Speakers want to use for 7.2-channel playback. You can set which speakers you want to use by priority. See “Selecting Speaker Layout” (➔ page 52).
Resumen del contenido incluido en la página 14
Connections ■ 9.2-channel playback Attaching the Speaker Cable Labels Speaker Connection Precautions By adding an external amplifier to the 7.2-channel The speaker terminals are color-coded for identification Read the following before connecting your speakers: configuration, you can enjoy 9.2-channel playback. purpose. You can connect speakers with an impedance of between Connect your power amplifier’s analog audio input jacks to 4 and 16 ohms. If the impedance of any of the connected *1 S
Resumen del contenido incluido en la página 15
Connections Don’t connect more than one cable to each speaker Using Dipole Speakers Using Powered Subwoofers terminal. Doing so may damage the AV receiver. Don’t connect one speaker to several terminals. TV/screen LINE INPUT LINE INPUT aa LINE INPUT LINE INPUT Powered subwoofer bb You can use dipole speakers for the surround and surround back speakers. Dipole speakers output the same sound in two directions. Corner Dipole speakers typically have an arrow printed on them to position indi
Resumen del contenido incluido en la página 16
Connections Bi-amping the Front Speakers Using Speakers Without Crossover Network Connecting a Power Amplifier If you want to use a more powerful power amplifier, you Important: Important: can use the AV receiver as a preamp. Connect all speaker When making the bi-amping connections, be sure to remove Speakers without crossover network are speakers with no outputs to the power amplifier. See the manuals supplied the jumper bars that link the speakers’ tweeter (high) and built-in crossove
Resumen del contenido incluido en la página 17
Connections Push plugs in all the way to make Right! ■ Optical digital audio About AV Connections good connections (loose connections Optical digital connections allow you to enjoy digital can cause noise or malfunctions). *2 sound such as PCM , Dolby Digital or DTS. The audio Connecting AV components To prevent interference, keep audio quality is the same as coaxial. a and video cables away from power Wrong! HDMI cable : Video & Audio cords and speaker cables. TV, projector, etc. AV Cabl
Resumen del contenido incluido en la página 18
Connections Connecting Components with HDMI Satellite/cable set-top box, etc. Personal computer TV, projector, etc. Camcorder, etc. Blu-ray Disc/DVD player Game console Set top box/digital video recorder, etc. * If your TV doesn’t support Audio Return Channel (ARC), you Connect your components to the appropriate jacks. The Tip need to connect an optical digital cable together with the HDMI default input assignments are shown below. To listen to the audio of a component connected via HDMI c
Resumen del contenido incluido en la página 19
Connections Connect your components to the appropriate jacks. The Connecting Your Components default input assignments are shown below. See “Connection Tips and Video Signal Path” for more The on-screen menus appear only on a TV that is connected to HDMI OUT MAIN. If your TV is connected to other information (➔ page 107). video outputs, use the AV receiver’s display when changing settings. ✔: Assignment can be changed (➔ page 62, 63). No. Jack/Port Components *1*2 USB iPod/iP
Resumen del contenido incluido en la página 20
Connections output from PC IN, select “-----” for “PC” in the “HDMI No. Jack/Port Components Input” setting (➔ page 61). COMPONENT VIDEO With connection , you can enjoy Dolby Digital and MONITOR OUT TV, projector, etc. DTS. (To listen in Zone 2/3 as well, use and .) IN 1 (BD/DVD) Blu-ray Disc/DVD player, ✔ With connection , you can enjoy analog video from RI dock external components while you are in Zone 2. IN 2 (CBL/SAT) Satellite/cable set-top box, ✔ RI dock, etc. With conne
