Resumen del contenido incluido en la página 1
3-044-713-71 (2)
Personal
Component
System
Operating Instructions
PMC-DR45
© 2000 Sony Corporation
Resumen del contenido incluido en la página 2
communications. However, there is no Warning guarantee that interference will not occur in a To prevent fire or shock hazard, do particular installation. If this equipment does cause harmful interference to radio or not expose the player to rain or television reception, which can be determined moisture. by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the
Resumen del contenido incluido en la página 3
Basic Operations Table of contents Basic Operations 4 Playing a CD 6 Listening to the radio 8 Playing a tape 10 Recording on a tape The CD Player The Timer 13 Using the display 23 Setting the clock 14 Locating a specific track 25 Waking up to music 15 Playing tracks repeatedly 28 Timer-recording radio programs (Repeat Play) 31 Falling asleep to music 16 Playing tracks in random order (Shuffle Play) Setting Up 17 Creating your own program 32 Hooking up the system (Program Play) 37 Saving power 38
Resumen del contenido incluido en la página 4
Basic Operations Playing a CD 21 For hookup instructions, see pages 32 - 36. 1 Press Z CD OPEN/CLOSE (direct power-on) and place the CD on the CD tray. With the label side up 2 Press u. Display (On the remote, press N on the CD section.) The CD tray closes and the player plays all the tracks once. Track number Playing time 4 Basic Operations
Resumen del contenido incluido en la página 5
Basic Operations Use these buttons for additional operations u POWER ., > x VOLUME +, – Z CD OPEN/CLOSE Tip To Press Next time you want to adjust the volume VOLUME +, – listen to a CD, just press u. The player turns on (VOL +, – on the remote) automatically and starts stop playback x playing the CD. pause playback u (X on the remote) Press again to resume play after pause. go to the next track > go back to the previous track . remove the CD Z CD OPEN/CLOSE turn on/off the player POWER Basic Oper
Resumen del contenido incluido en la página 6
Listening to the radio 1 2 For hookup instructions, see pages 32 - 36. Display 1 Press BAND•AUTO PRESET until the band you want appears in the display (direct power-on). 2 Hold down TUNE TIME SET + or Indicates an FM – (TUNE + or – on the remote) stereo broadcast. until the frequency digits begin to change in the display. The player automatically scans the radio frequencies and stops when it finds a clear station. If you cannot tune in a station, press the button repeatedly to change the frequen
Resumen del contenido incluido en la página 7
Basic Operations Use these buttons for additional operations POWER MODE VOLUME +, – Tips To Press • The “FM1” and “FM2” adjust the volume VOLUME +, – bands have the same (VOL +, – on the remote) functions. You can store the stations you want turn on/off the radio POWER separately in “FM1” and “FM2”. • If the FM broadcast is To improve broadcast reception noisy, press MODE until FM: “MONO” appears in the display and the radio Keep the FM lead antenna as horizontal as possible will play in monaur
Resumen del contenido incluido en la página 8
Playing a tape 1, 2 3 For hookup instructions, see pages 32 - 36. 1 Press Z PUSH OPEN/CLOSE to With the side you want to play facing up open the tape compartment and insert a recorded tape. Use TYPE I (normal), TYPE II (high position) and TYPE IV (metal) tapes. 2 Press Z PUSH OPEN/CLOSE to close the compartment. Display 3 Press N. (On the remote, press TAPE N.) The player turns on (direct power-on) and starts playing. Tape counter 8 Basic Operations
Resumen del contenido incluido en la página 9
Basic Operations Use these buttons for additional operations POWER TAPE m, M Z PUSH OPEN/CLOSE x n VOLUME +, – COUNTER RESET DIR MODE Tips To Press • Press COUNTER RESET adjust the volume VOLUME +, – to reset the counter to “000”. (VOL +, – on the remote) • Next time you want to stop playback x listen to a tape, just press N or n. The play the reverse side n player turns on fast-forward or rewind the tape TAPE M or m automatically and starts playing the tape. eject the cassette Z PUSH OPEN/CLOSE
Resumen del contenido incluido en la página 10
Recording on a tape 3 3 3 1 For hookup instructions, see pages 32 - 36. To record on a MiniDisc or DAT recorder, connect the component (see page 38). With the side you want 1 Press Z PUSH OPEN/CLOSE to to record on facing up open the tape compartment, and insert a blank tape. Use TYPE I (normal) tape only. Press Z PUSH OPEN/CLOSE again to close the compartment. 2 Select the program source you Display want to record. To record from the CD player: Insert a CD (see page 4) and press x on the CD sec
Resumen del contenido incluido en la página 11
Basic Operations 3 Start recording. To record the whole CD Press CD DUBBING. When is displayed: If the tape is reversed with the recording of the track unfinished, the player will record the track again from its beginning on the reverse side. When is displayed: If the tape reaches to its end, the player stops. To record the radio (You can also record the CD according to the following procedure. Play the CD after the tape starts recording.) Press z/X and then N. m To record on the reverse side,
Resumen del contenido incluido en la página 12
Recording on a tape (continued) Use these buttons for additional operations POWER z/X x n, N MODE DIR MODE Tips To Press • Adjusting the volume or the audio emphasis stop recording x on the tape section (page 22) will not affect pause recording z/X the recording level. Press the button again to • When or is resume recording. displayed, recording will be made on both turn on/off the player POWER sides of the tape. To record on one side, press DIR MODE to display To erase a recording, proceed as
Resumen del contenido incluido en la página 13
The CD Player The CD Player Using the display DISPLAY You can check information about the CD using the display. Checking the total track number and playing time Press DISPLAY in stop mode. Total track number Total playing time Checking the remaining time Press DISPLAY while playing a CD. To display Press DISPLAY the current track number once and the remaining time on the current track* the number of tracks left twice and remaining time on the CD the current track number three times and playing t
Resumen del contenido incluido en la página 14
Locating a specific track You can quickly locate any track using the number buttons. You can also find a Number specific point in a track while playing a buttons CD. ., > Note To locate Press You cannot locate a a specific track directly number button of the track. specific track if “SHUF” or “PGM” is lit a point while listening to . or > while playing in the display. Turn off the sound and hold down until you the indication by find the point. pressing x on the CD section. a point while observi
Resumen del contenido incluido en la página 15
The CD Player Playing tracks ., > repeatedly (Repeat Play) x You can play tracks repeatedly in normal, single, shuffle or program play modes (see pages 16 - 18). u MODE On the remote 1 Press x on the CD section. • Use N instead of u. “CD” appears in the display. • When you’ve selected “REP 1”, select the 2 Proceed as follows: track by pressing the number buttons. To repeat Do this a single track 1 Press MODE until “REP 1” appears. 2 Select the track by pressing . or >, then press u. all the trac
Resumen del contenido incluido en la página 16
Playing tracks in random order (Shuffle Play) x You can play tracks in random order. u MODE On the remote 1 Press x on the CD section. Use N instead of u. “CD” appears in the display. 2 Press MODE until “SHUF” appears in the display. 3 Press u. To cancel Shuffle Play Press MODE until “SHUF” disappears from the display. 16 The CD Player
Resumen del contenido incluido en la página 17
The CD Player Creating your u ., > own program (Program Play) x You can arrange the playing order of up to 20 tracks on a CD. ENTER MEMORY MODE On the remote 1 Press x on the CD section. 1 Press x. “CD” appears in the display. 2 Press MODE until “PGM” appears in 2 Press MODE until “PGM” appears in the display. the display. 3 Press . or > to select the track you want to 3 Press the number program, and press ENTER MEMORY. buttons for the tracks you want to program Repeat this step. in the order yo
Resumen del contenido incluido en la página 18
Creating your own program (Program Play) (continued) Tips To cancel Program Play • If you open the CD Press MODE until “PGM” disappears from the tray, the program is display. erased. • You can record your own program. To check the order of tracks before play 1 After you have Press ENTER MEMORY on the player. created the program, insert a blank tape Every time you press the button, the track number into the tape appears in the programed order. compartment. 2 Press CD DUBBING. To change the curren
Resumen del contenido incluido en la página 19
The Radio The Radio Presetting radio BAND stations AUTO PRESET TUNE TIME SET –, + You can store radio stations into the player's memory. You can preset up to 30 radio stations, 20 for FM (10 each for PRESET –, + FM-1 and FM-2) and 10 for AM band in any order. ENTER MEMORY Tip 1 Press BAND•AUTO PRESET to select the band. If you automatically 2 Hold down BAND•AUTO PRESET for 2 seconds preset the “FM1” or until “AUTO” flashes in the display. “FM2” band, 10 radio stations are stored in “FM1” band a
Resumen del contenido incluido en la página 20
Playing preset BAND radio stations AUTO PRESET Once you've preset the stations, use PRESET +, – on the player or the number buttons on the remote to tune in your PRESET –, + favorite stations. On the remote 1 Press BAND•AUTO PRESET to select the band. 1 Press BAND to select 2 Press PRESET + or – to display the preset number the band. of the station you want. 2 Press the number button to display the preset number of the station you want. Preset number 20 The Radio
