Resumen del contenido incluido en la página 1
Resumen del contenido incluido en la página 2
IMPORTANT SAFEGUARDS 11.Grounding or Polarization - Precaution should be taken so that the grounding or polarization means of an appliance is not defeated. 12.Power Cord Protection - Power supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, receptacles, and the point where they exit from the appliance. 13.Cleaning - The appliance should be cleaned only as recommended by WARNING:
Resumen del contenido incluido en la página 3
TABLE OF CONTENTS Product Introduction..........................................................................................................4-5 Component Guide ST2-XM Front Panel.............................................................................................................6 ST2-XM Rear Panel..............................................................................................................7 ST2-RC Remote Control.........................................................
Resumen del contenido incluido en la página 4
INTRODUCTION DESCRIPTION gration. It can also be controlled by IR signals received through the IR connections on the rear Thank you for choosing the Russound ST2-XM panel from IR repeating system commonly used Smart Tuner. Whether you are adding radio to an in distributed audio systems. existing system, expanding a CAi Series system or taking advantage of the CAV6.6’s robust If the ST2-XM Tuner is part of an RNET-enabled RNET™ communication link, the ST2-XM Tuner is system such as the CAV6.6-S2
Resumen del contenido incluido en la página 5
INTRODUCTION frequency or channel, preset names and AM/FM tem with an audio distribution hub such as the band or XM is displayed on UNO-S2 keypads. An A-H484 and IR-repeating keypads such as the additional RNET device can be connected to an A-KP2. The connections on the rear panel are existing ST2 by using the Link Out of the first designed to receive IR signals from a repeating unit into the Link In of the second unit. system commonly used in A-BUS distributed audio systems. Before using the
Resumen del contenido incluido en la página 6
COMPONENT GUIDE ST2-XM FRONT PANEL 1 2 3 XM 64 : The Groove AM/FM 4 5 6 7 8 9 10 XM 64 : The Groove AM/FM 13 12 11 1 MAIN POWER SWITCH - Turns power on and off 2 POWER ON/OFF LED - Indicates power on or off 3 REMOVABLE COVER LENS - Covers the selection buttons on the tuner 4 BANK SELECT BUTTON - Selects bank 1-6 5 MEMORY SELECT BUTTONS - Sets and selects memory presets 1-6 for each bank 6 IR RECEIVER - Receives IR signal from remote control 7 LCD PANEL - 12-character backlit display shows stat
Resumen del contenido incluido en la página 7
COMPONENT GUIDE ST2-XM REAR PANEL 1 2 3 4 5 6 7 8 9 10 11 LOOP Serial# TUNER 2 TUNER 1 ST2 Smart Tuner NEWMARKET, NH U.S.A. ANTENNA FM COAX AUDIO OUTPUT AUDIO OUTPUT LINK RS-232 KEYPAD PORTS LR LR IR INTERFACE IR 12VDC 1.5A ANTENNA IN OUT TUNER 2 AM/FM TUNER 1 XM 1 RNET LINK IN/LINK OUT - Links to other Russound components that are RNET compatible, dis- plays frequency and other information on the UNO keypads 2 RS-232 INTERFACE - The RS-232 Interface allows the tuner to be controlled by PC or o
Resumen del contenido incluido en la página 8
TUNE COMPONENT GUIDE ST2-RC REMOTE CONTROL 1 POWER - Puts the tuner in/out of standby mode 1 2 TUNER CONTROL - Select TUNER 1 (XM) or TUNER 2 (AM/FM) and all subsequent button presses affect that tuner 2 3 NUMERIC INPUT - Number buttons for direct PWR selection of station, channel, bank, preset 4 BANK SELECT - Used for direct bank selection TUNER 1 TUNER 2 (numeric input 1-6) 3 123 5 TUNE SELECT - Used for direct station or chan- 15 nel selection (numeric input) 4 56 4 6 14 TUNE UP/DOWN - Increm
Resumen del contenido incluido en la página 9
ST2-XM SETUP AND CONNECTIONS BASIC CONNECTIONS Power ST2-KP RJ-45 Connection Wiring To power the tuner, connect the 12VDC external power supply by inserting the power supply jack into the power supply connection on the tuner’s rear panel. Audio Output Connect one end of a dual RCA audio cable to the Tuner 1 Audio Output connection. Keep prop- er channel identity. Attach the other end of the RCA cables to the source input of the audio con- trol system. Repeat the same procedure for the Tuner 2 A
Resumen del contenido incluido en la página 10
ST2-XM SETUP AND CONNECTIONS ST2-KP AND CAV6.6 CONNECTIONS CAT-5 Cable ST2-KP Connections to ST2-XM Tuner (Non-RNET Systems) The diagram depicts a standard ST2-KP keypad connection to the keypad port on the back of the ST2-XM. The keypad uses a 110 punchdown connection and an RJ-45 T568A connection to the tuner. UNO-S2 keypads 64:The Groove ST2 Tuner CAV6.6 RCA Cable Source Connections with CAV6.6 Controller/Amplifier (RNET System) The diagram depicts a typical setup using the ST2-XM Tuner with
Resumen del contenido incluido en la página 11
ST2-XM SETUP AND CONNECTIONS CAi SERIES AND A-BUS CONNECTIONS VOLUME SOURCE STORE POWER REMOTE SENSOR ST2-KP CA-LCD2 LOOP TUNER 2 TUNER 1 Serial# NEWMARKET, NH U.S.A. ST2 Smart Tuner ANTENNA FM COAX AUDIO OUTPUT AUDIO OUTPUT LINK RS-232 KEYPAD PORTS LR INTERFACE LR IR IR 12VDC 1.5A ANTENNA IN OUT IR Link Cable RCA Cable RCA Cable CA6.4i NEWMARKET, NH U.S.A. ZONE PREAMP KEYPAD PORTS OUTPUTS SOURCE INPUTS 123456 1 2 34 1 2 VARIABLE VARIABLE ~220-240VAC ~110VAC R R FIXED FIXED L L OUTPUT TO 8 OHM
Resumen del contenido incluido en la página 12
ST2-XM SETUP AND CONNECTIONS ANTENNA CONNECTIONS XM Antenna XM Signal Strength Mode Connect the included XM antenna for XM recep- To test the XM reception, turn the unit on. When tion to the back panel of the XM module. The the XM radio is powered for the first time, the antenna comes with 20 feet of cable. If this XM service will start playing XM Channel 1, a length is not sufficient, there are aftermarket preview/promotional channel. Verify that Channel antenna kits available for custom lengt
Resumen del contenido incluido en la página 13
ST2-XM SETUP AND CONNECTIONS ANTENNA CONNECTIONS AM Antenna FM Antenna Connect the included loop antenna for AM recep- Attach the included FM antenna to the Tuner 2 tion to the back panel, attaching the GND FM COAX connection on the back panel by push- (ground) and AM ends to the appropriate connec- ing the F-type quick-connect termination of the tions for Tuner 2. antenna onto the FM connection. It is recommended to use an external outdoor or It is recommended to use an external outdoor or at
Resumen del contenido incluido en la página 14
ST2-XM OPERATION XM RADIO OVERVIEW XM Radio Activation XM Radio is over 100 channels of radio broadcasts with the signal delivered by satellite and (depend- ing on location) transferred by terrestrial antennas. The radio is a subscription-based service with a monthly provider fee and an activation charge. XM radio broadcasts several channels for preview but will not broadcast the full range of channels without activation. Activation and billing are handled sole- ly through XM Radio. To activate
Resumen del contenido incluido en la página 15
ST2-XM OPERATION XM RADIO MODES XM Radio Modes There are four user “modes” for selecting music and viewing music information on the XM Tuner: Preset (default or normal) Category Search Now Playing Display Preferences. These modes are accessed through certain button and key presses from the tuner panel, remote controls and keypads. When choosing modes, if no choice is made after 20 seconds, the tuner will time out by showing EXIT and return to tuner display and Preset mode. For all XM Modes Th
Resumen del contenido incluido en la página 16
MEM ST2-XM OPERATION XM RADIO MODES Preset (default) Mode This is the normal operating mode of the XM tuner. In this mode the XM tuner operates similarly to the AM/FM tuner for channel up and down, bank selection and memory presets. Next Preset This button press accesses the next saved preset (6 presets for each bank) in the chosen bank. Previous Preset This button press accesses the previous saved preset in the chosen bank Next Bank This button press accesses the next bank (total of 6 banks).
Resumen del contenido incluido en la página 17
MEM ST2-XM OPERATION XM RADIO MODES Category Search Mode (1 1. .C CA AT T S SE EA AR RC CH H) XM Radio is organized by Channel Category (e.g., Rock, Country, News). Within each category is a series of channels (e.g., Top Tracks, Bluegrass Junction, XM Classics). Channel selection in this mode is refined to scrolling only those channels in the selected category. Next Category This button press accesses the next category from the current category. Previous Category This button press accesses t
Resumen del contenido incluido en la página 18
MEM MEM MEM MEM ST2-XM OPERATION XM RADIO MODES Now Playing Mode (2 2. .N NO OW W P PL LA AY YN NG G) This mode displays information about the current XM selection. Appropriate button presses access the next or previous information item. N NA AM ME E: : Displays the artist’s name, feature name or program name (news, talk, sports). T TI IT TL LE E: : Displays the song title or program title. C CA AT TE EG GO OR RY Y: : Displays the current category. ST2-XM ST2-RC ST2-KP UNO-S2 UNO-LRC1 OK N
Resumen del contenido incluido en la página 19
ST2-XM OPERATION FRONT PANEL CONTROLS screen when selecting mode. Normal operation is in Front Panel Operation Distant mode. In cities, antennas can pick up multi- Turning the unit on path signals when they bounce off buildings and get To turn the unit on, push the On/Off button up on the doubled. The Local mode limits the noise associated front panel. Pushing the On/Off button down turns the with these reflected signals. tuner off. Bank/Memory Presets Selecting the desired tuner Each tuner has
Resumen del contenido incluido en la página 20
MEM ST2-XM OPERATION ST2-RC REMOTE CONTROL Frequency Seek (AM/FM only) ST2-RC Remote Control Operation The SEEK function is performed by pressing and The ST2-RC remote control is the only means of remote operation of the ST2-XM in a non--RNET sys- releasing to seek lower frequencies or for tem. The ST2-XM front panel displays information for higher frequencies. SEEK tuning begins at the current the tuner that is receiving commands from the ST2- frequency, seeks upward and stops at the next tuned
