Resumen del contenido incluido en la página 1
GEAppliances.com
Safety Instructions . . . . . . . . . . . . .2
Owner’s Manual and
Installation Instructions
Operating Instructions
Air Direction . . . . . . . . . . . . . . . . . . . . . . . .4
Heat/Cool Model 4100
Auxiliary Controls . . . . . . . . . . . . . . . .5–8
Heat Pump Model 6100
Controls . . . . . . . . . . . . . . . . . . . . . . . . . . .3
To Remove the Room Cabinet . . . . . .4
Ventilation Control . . . . . . . . . . . . . . . . .4
Español
For a Spanish version of this
Care and Cle
Resumen del contenido incluido en la página 2
IMPORTANT SAFETY INFORMATION. READ ALL INSTRUCTIONS BEFORE USING. WARNING! For your safety, the information in this manual must be followed to minimize the risk of fire or explosion, electric shock, or to prevent property damage, personal injury, or loss of life. SAFETY PRECAUTIONS This Zoneline must be properly installed These R410A air conditioning systems in accordance with the Installation require contractors and technicians to Instructions before it is used. See the use tools, equipment
Resumen del contenido incluido en la página 3
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support About the controls on your Zoneline. GEAppliances.com TEMP CONTROL FAN, MODE & SLEEP OPERATION Controls Temp Control Fan, Mode and Operation Control The temp control is used to maintain the room FAN—Sets the fan operation for HIGH, temperature. The compressor will cycle on LOW or AUTO speed. When set at AUTO, and off to keep the room at the same level it automatically switches between LOW of comfor
Resumen del contenido incluido en la página 4
Other features of your Zoneline. Closed Ventilation Control Open position position NOTE: Two shipping screws must be removed from the vent door before use. See the Installation Instructions in the back of this manual. If you do not plan to use the ventilation feature, leave these two screws in place. The ventilation control lever is located at the middle left side of the Zoneline unit, behind the room cabinet. When set at the closed position, only the air inside the room is circulated and filter
Resumen del contenido incluido en la página 5
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support Auxiliary controls on your Zoneline. GEAppliances.com Auxiliary Set Button Auxiliary Controls—Aux Set Button The auxiliary set controls are located behind the room cabinet, below the control panel. Access Cover Remove the room cabinet. See the To Remove the Room Cabinet section. The owner is responsible for ensuring the auxiliary controls are set to the desired function. There are 9 different modes
Resumen del contenido incluido en la página 6
Auxiliary controls on your Zoneline. Freeze Sentinel/Heat Sentinel MODE 3 HIGH COOL In the default setting for Mode 3, Heat Sentinel is off, Freeze Sentinel is on. LOW FAN Press MODE until a 3 appears in the first digit of the display for AUTO HEAT Freeze Sentinel mode. The COOL LED light on the main control Freeze Sentinel OFF will be on. Press MODE again to change to the Heat Sentinel. The HIGH COOL HEAT LED light on the main control will be on. Press the down LOW FAN arrow for OFF " " or the
Resumen del contenido incluido en la página 7
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support GEAppliances.com MODE 7 Duct Mode The default setting for Mode 7 is OFF. For Model AZ6100, press MODE to continue setting other functions. Pressing MODE on Model AZ4100 will This setting is used when the unit is installed using a return you to AUX SET mode and an “AU” will appear in duct adapter kit. If the unit is ducted, the Duct Mode the display. needs to be set to ON. This increases the fan spe
Resumen del contenido incluido en la página 8
Auxiliary controls on your Zoneline. External Fan (Obtained locally) When connected, an auxiliary or external fan can be controlled with the indoor fan motor on the Zoneline. Connections provide 24 V AC to energize a remote relay, turning on the external fan. Central Desk Control When connected, the unit can be turned ON or OFF with a switch located at the Central Control Panel. A separate wire pair must be run from each separate controlling switch to each individual Zoneline. Refer to MODE 2 on
Resumen del contenido incluido en la página 9
Safety Instructions Operating Instructions Care and Cleaning Troubleshooting Tips Consumer Support Care and cleaning. Room Cabinet and Case Turn the Zoneline off and disconnect the To clean, use water and a mild detergent. power supply. Do not use bleach or abrasives. Some commercial cleaners may damage the plastic parts. Outdoor Coils The coils on the outdoor side of the Zoneline should be checked regularly. If they are clogged with dirt or soot, they may be professionally steam cleaned. You wi
Resumen del contenido incluido en la página 10
Care and cleaning. To maintain optimum performance, clean the filters at least every 30 days. Air Filters To remove the air filters: FRONT FRONT 2 Air filters Pull up Dirty filter—Needs cleaning Clogged filter—Greatly reduces cooling, heating and airflow. Turn the Zoneline off before cleaning. The most important thing you can do to maintain the Zoneline is to clean the filter at least every 30 days. Clogged filters reduce cooling, heating and air flow. To replace the air filters: Keeping these f
Resumen del contenido incluido en la página 11
Installation Zoneline Air Instructions Conditioners Questions? Call 800.GE.CARES (800.432.2737) or Visit our Website at: GEAppliances.com IMPORTANT ELECTRICAL BEFORE YOU BEGIN Read these instructions completely and carefully. SAFETY—READ CAREFULLY • IMPORTANT – Save these instructions for CAUTION: local inspector’s use. • Follow the National Electrical Code (NEC) or local • IMPORTANT – Observe all governing codes and ordinances. codes and ordinances. • For personal safety, this Zoneline must be
Resumen del contenido incluido en la página 12
Installation Instructions REPLACING AN EXISTING UNIT? Replacing a ducted unit Check the “Essential Elements” label for New ducted installation: important information. If this unit is to be installed in a new ducted application using a duct adapter kit, the kit must be installed before the unit is placed in the wall case. The installation instructions are packed with the kit. Duct kits available: RAK6052 RAK601/602 Mounting Use the correct wall case plate Duct This unit is designed to be installe
Resumen del contenido incluido en la página 13
Installation Instructions 230/208 VOLT ELECTRICAL CONNECTION OPTIONS Power cords may include an arc fault interruption HOW TO CONNECT or a leakage current detection interruption device. A test and reset button is provided on the plug case 1. Remove the room cabinet. or the inline case. The device should be tested on 2. Connect to electrical power. a periodic basis by first pressing the TEST button 3. Review the following steps for applicable supply and then the RESET button. If the TEST button d
Resumen del contenido incluido en la página 14
Installation Instructions 265 VOLT ELECTRICAL CONNECTION OPTIONS B. FOR DIRECT CONNECT WARNING: INSTALLATION Connection of this 265 V AC product to a branch circuit MUST be done by direct connection in accordance with If an electrical subbase is not used, direct connection to the National Electrical Code. Plugging this unit into a branch circuit wiring inside the provided junction box must building-mounted exposed receptacle is not permitted be done in accordance with the following steps. by cod
Resumen del contenido incluido en la página 15
Installation Instructions MAKE ELECTRICAL CONNECTION TO THE UNIT 1 3 REMOVE JUNCTION BOX ATTACH CONDUIT 1. Remove the junction box cover by removing the front 1. Use the round knockout at the bottom of the junction two screws. box to attach conduit coming from the branch circuit. Remove the knockout, attach the conduit and bring 2. Remove the junction box by removing the top and bottom rear screws. Note how the tabs on the lower wires into the junction box. Leave 6″ of wire free at the left side
Resumen del contenido incluido en la página 16
Installation Instructions POWER CONNECTION CHART Power Cord Connections 230/208 Volt Power Supply Kits with Current Leakage Wall Plug Heater Wattage Detection Device Configuration Circuit Protective Device @ 230/208 Volts RAK3153 Tandem 15-Amp Time-Delay Fuse or Breaker 2.55/2.09 KW RAK3203 Perpendicular 20-Amp Time-Delay Fuse or Breaker 3.45/2.82 KW RAK3303* Large Tandem 30-Amp Time-Delay Fuse or Breaker 5.00/4.10 KW Direct Connections 230/208 Volt Heater Wattage Power Supply Kits Circuit Prote
Resumen del contenido incluido en la página 17
Installation Instructions INSTALLING THE ZONELINE 1 2 INSTALL THE WALL CASE AND PREPARE THE UNIT • Carefully remove shipping tape and foam shipping EXTERIOR GRILLE blocks from the room cabinet, compressor and The RAB71A series or RAB77A4 wall case must be vent door. There may be multiple blocks and pieces properly installed per instructions packed with the case. of shipping tape that need to be removed. • Remove the corrugated stiffener and the outdoor protective panel. Use the slit in the outdo
Resumen del contenido incluido en la página 18
Installation Instructions INSTALLING THE ZONELINE (cont.) 3 4 INSTALL THE UNIT INTO THE REPLACE THE ROOM CABINET Reinstall the room cabinet by hooking the top over WALL CASE the rail along the unit top (1), then pushing it in at Slide the unit into the wall case and secure with four the bottom (2). screws through the unit flange holes. NOTE: There are several extra holes in the unit side flanges for installation in wall cases other than GE. To avoid damaging the flange insulation, the installer
Resumen del contenido incluido en la página 19
Installation Instructions OPTIONAL—DRAIN KIT INSTALLATION Dry Air 25 Series models are designed to improve dehumidification by 25%. Since more moisture will be removed from the air, there is a greater possibility that water will drip from the wall case than with a standard unit. To prevent this water from dripping onto external building walls, we recommend the use of RAD10 Drain Kit. External Drain See the Installation Instructions in the RAD10 kit. Alternate: 6″ long, 1/2″ O.D. straight copper
Resumen del contenido incluido en la página 20
Before you call for service… Troubleshooting Tips Save time and money! Review the charts on the following pages first and you may not need to call for service. Problem Possible Causes What To Do Zoneline does The unit is • Make sure the Zoneline plug is pushed completely not start unplugged. into the outlet. The power cord is not • Remove the room cabinet and make sure that the firmly attached. yellow connector on the end of the power cord is firmly engaged. The fuse is blown/circuit • Check the
