Manual de instrucciones de Guardian Technologies , LLCGGU300

Resumen del contenido incluido en la página 1

LIMITED WARRANTY
™
pureguardian
To the consumer, Guardian Technologies LLC warrants this product to be free of defects in materials
or workmanship commencing upon the date of the original purchase. Refer to your product carton
for the length of warranty and save your original sales receipt to validate start of warranty period.
2-in-1
If this product should become defective within the warranty period, we will repair or replace any
defective parts free of charge. The complete machine must be deliv

Resumen del contenido incluido en la página 2

P P O W E R THIS VACUUM CLEANER IS INTENDED FOR HOUSEHOLD USE ONLY PLEASE READ ALL INSTRUCTIONS BEFORE USING THIS APPLIANCE WARNING! Do not use the Dirt Cup Handle to move the cleaner. IMPORTANT SAFETY INSTRUCTIONS *Thermal Reset Button: Operates due to over heating, caused by a full dirt cup, clogged filter or When you use an appliance, basic precautions should always be followed. Please read the entire blocked pipes. Unplug the cleaner and remove the blocked materials. To operate again, after

Resumen del contenido incluido en la página 3

HOSE CRADLE & HOSE ASSEMBLY HANDLE ASSEMBLY Handle · HOSE CRADLE ASSEMBLY · HANDLE ASSEMBLY · Set hose cradle on the top of the cleaner. (Fig. 1) · Insert handle in the handle hole on the top of the body. (Fig. 6) · Using a Phillips screwdriver, secure the 3/4-inch screw. · HANDLE DISASSEMBLY · HOSE ASSEMBLY · Push the handle removal button. · Insert the body end of hose into the hose hole on the top of the cleaner. (Fig. 2) · Pull handle upward. Protrusion to lock · Line up circular tab on hose

Resumen del contenido incluido en la página 4

TOOL ASSEMBLY CONVERTING TO CANISTER MODE (cont.) · Attach crevice tool, dusting brush and upholstery · Push handle removal button and pull up on handle to disconnect from body. (Fig. 13) brush into storage area on the back of the vacuum. (Fig. 8) · Insert hose into handle hose connector and twist clockwise to lock in position. (Fig. 14) Crevice · Push button on wand to extend telescoping wand. (Fig. 14) Tool · Insert end of handle into hard floor nozzle. (Fig. 15) · Canister mode. (Fig. 16) Dus

Resumen del contenido incluido en la página 5

HEIGHT ADJUSTMENT KNOB STORING CLEANING & REPLACING FILTER · Rotate the height adjustment knob to the · After using the cleaner, store in To optimize the vacuum performance you should clean the filter each time you empty the dirt cup. correct carpet height. (Fig. 17) upright mode. · Lift up the dirt cup cover, rotate and remove the inner filter. (Fig. 21) · To clean bare floor, set this knob to the · Store accessories on the storage clips · Tap the inner filter on a trash bin to remove the dust

Resumen del contenido incluido en la página 6

BELT REPLACEMENT TROUBLESHOOTING GUIDE Warning: Before replacing the belt, make sure the cleaner is unplugged from electrical outlet. Please check each item below if you have trouble with your cleaner. Before checking, ensure that · Turn off the cleaner and unplug from electrical outlet. the cleaner is unplugged from the power supply. · Remove the bottom plate of the base by removing the 5 screws using a Phillips screwdriver. (Fig. 25) PROBLEM PROBLEM SOLUTION · Set the new belt over motor pulle