Manual de instrucciones de JVC 0710DTSMDTJEIN

Resumen del contenido incluido en la página 1

INFORMATION (For U.S.A.)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no g

Resumen del contenido incluido en la página 2

Listening to the radio Listening to the disc ~ Ÿ ~ Ÿ ] “FM” or “AM” ] Turn on the power. “ST” lights up when receiving an FM stereo broadcast with sufficient signal strength. All tracks will be played repeatedly until you change the source or eject the disc. Manual search Selecting a preset station “M” flashes, then press the Stopping playback and ejecting the disc Selecting the playback modes 1 button repeatedly. You can use only one of the following playback “NO DISC” appears. [Hold] mode

Resumen del contenido incluido en la página 3

Selecting a preset sound mode You can select a preset sound mode suitable for the music genre. Storing your own sound mode Sound element Tone FLAT = NATURAL = DYNAMIC = You can store your own adjustments in memory. Frequency Level Q VOCAL BOOST = BASS BOOST = BASS 60 Hz, 80 Hz, 100 Hz, –06 to +06 Q1.0, Q1.25, 1 USER = (back to the beginning) [Hold] 200 Hz Q1.5, Q2.0 MIDDLE 0.5 kHz, 1.0 kHz, –06 to +06 Q0.75, Q1.0, While listening, you can adjust the tone level of the selected sound 2 1.5 k

Resumen del contenido incluido en la página 4

Troubleshooting More about this unit General • This unit can recognize a total of 512 files, 255 Symptom Remedy/Cause folders, and 8 hierarchical levels. • If you turn off the power while listening to a track, Sound cannot be heard from the • Adjust the volume to the optimum level. • This unit can play back files recorded in VBR playback will start from where it had been stopped speakers. • Make sure the unit is not muted/paused. (See page 1.) (variable bit rate). previously next time you t

Resumen del contenido incluido en la página 5

Maintenance Preparation You need the installation kits which corresponds to your car. How to clean the connectors To play new discs • Mark all the check boxes ( ) to make sure you have follow the instructions and the listed parts. Wipe the connectors with a cotton swab or cloth Remove any rough areas from the moistened with alcohol. inner and outer edges of the disc. Check the battery system in your car 12 V DC, NEGATIVE ground Do not use the following discs: Connectors • Single CD—8 cm (3-3/

Resumen del contenido incluido en la página 6

Installation The following illustration shows a typical installation. If you are not sure how to install this unit correctly, contact your JVC car audio dealer or a company supplying kits. In-dash mounting See “Electrical connections” below. When installing the unit without using the sleeve Removing the unit In a Toyota car for example, first remove the car radio and install the unit in its place. Release the rear section first... 8 mm (3/8") 2 Flat head screws—M5 × 8 mm (3/8") * Pocket 2 Brac