Manual de instrucciones de Invacare 6905A

Resumen del contenido incluido en la página 1

Installing Cover Guards for MPR Clinical Recliners
Assembly, Installation and Operating Instructions
Kit # 1102816 for Model Nos. 6905A, 6907A, 6908A
SAVE THESE INSTRUCTIONS
NOTE: Check all parts for shipping damage, in case of damage, DO NOT use. Contact Carrier/Invacare
for further instructions.
SAFETY SUMMARY
To ensure the safe and proper installation and use of footrest and scissor mechanism guards,
these instructions MUST be followed:
GENERAL WARNING
DO NOT install this equipment without

Resumen del contenido incluido en la página 2

8. With a tie wrap, secure the footrest guard to the upper side frame as shown in DETAIL “B” in FIGURE 1. NOTE: If necessary, trim excess tie wrap to prevent binding and pinching. CAUTION When installing tie-wrap, pull tie wrap tight but not too tight causing the guard to buckle or deform. WARNING Tie wrap should be installed with the excess located on the interior side of the footrest assembly. Failure to do so may result in serious injury. 9. Place chair in the upright position. Close the foot

Resumen del contenido incluido en la página 3

DETAIL “A” - MODEL 6905A DETAIL “B” - MODEL 6905A MANUFACTURED BEFORE MANUFACTURED AFTER 04/01/2002 04/01/2002 Recliner Frame Bolts Rivets Recliner Frame Bolts Rivets Bolts Rivets NOTE: Side panel not shown to show rivet locations. DETAIL “C” - REMOVING SIDE COVER MODELS 6907A AND 6908A Bolts FIGURE 2 - INSTALLING THE SCISSOR MECHANISM GUARD 4. Remove four (4) existing bolts A, B, C and D from side frame as shown in FIGURE 3. 5. Position scissor mechanism guard against the side frame with

Resumen del contenido incluido en la página 4

9. Place chair in the upright position. 10. Close the footrest. NOTE: If binding or pinching of footrest guard occurs, call Invacare at the number listed below. 11. Carefully tip recliner onto the left side. Be sure there are no obstructions on or around the floor before doing this. 12. Repeat STEPS 3-11 to install remaining scissor mechanism guard. SIDE VIEW REAR OF FRONT OF CHAIR CHAIR Seat Cushion Side Frame Footrest DO NOT remove this bolt Scissor Mechanism Guard Bolt A Bolt B Bolt C Bolt D