Resumen del contenido incluido en la página 1
I N F O
INSTRUCTION BOOKLET
REFRIGERATOR
ER 6436 U
2222682-51
Resumen del contenido incluido en la página 2
CONTENTS Instructions for the User Instructions for the Installer Important Safety Instructions 3 Technical Specifications 13 Description of the Appliance 4 Installation 13 Positioning 13 Operation 4 Before use 4 Electrical Connection 14 Setting the temperature 4 Building-in Instructions 15 Fresh food refrigeration 5 Door Reversal 15 The door shelves 5 Building the appliance in under a worktop 17 Normal Operating Sounds 5 Fitting the plinth 19 Health and safety guidelines 6 Defrosting 6 Mainten
Resumen del contenido incluido en la página 3
IMPORTANT SAFETY INSTRUCTIONS These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. Your safety is of paramount importance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Prior to Installation General Safety n Check the appliance for transport damage. Under n This appliance contains hydrocarbons in its no circumstance should a damaged appliance be cooling uni
Resumen del contenido incluido en la página 4
n When unplugging always pull the plug from the At the end of the Appliance Life mains socket, do not pull on the cable. n When disposing of your appliance use an autho- rised disposal site. Servicing n Remove the plug and ensure that any locks or n This product should be serviced by an authorised catches are removed, to prevent young children engineer and only genuine spare parts should be being trapped inside. used. n Under no circumstances should you attempt to repair the appliance yourself.
Resumen del contenido incluido en la página 5
Important If the fridge is not defrosting correctly, it is pos- sible that because a very low temperature has been selected, the motor is working continuous- ly, which prevents the defrost cycle from oper- ating. During prologed periods of abnormally hot weather, if the thermostat is set on too high a number, the cooling system may operate con- tinuously and the fridge cooling plate may not defrost. Turning the knob to a lower number will cause the automatic defrosting to resume. Fresh food refr
Resumen del contenido incluido en la página 6
HEALTH AND SAFETY GUIDELINES Because of consumer demand, preservatives have been removed from many pre-prepared foods. This together with the changes in shopping habits to a once-a-week shop, mean that safe handling and storage of food is even more important than ever. The following tips should help you to ensure that the food in your home is in as perfect condition as possible. n n Keep the time between buying chilled food and Never allow spillages to dry and harden. placing it in your fridge a
Resumen del contenido incluido en la página 7
MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried Changing the light bulb out, DISCONNECT the appliance from the ELEC- TRICITY supply. Should the interior light fail to work, first switch off the appliance and disconnect from the electricity Warning supply, then replace the bulb as follows: This appliance contains hydrocarbons in its 1. Unscrew the light cover and then pull it outward cooling unit maintenance and recharging must by pressing as shown in the figure. Unsc
Resumen del contenido incluido en la página 8
SOMETHING NOT WORKING? Before contacting your local Service Force Centre check the following points. IMPORTANT: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom Solution No power to appliance - Check there is power at the socket. - Check there is not a power cut by checking the household lights. - Check the fuse has not blown. The light does not come on - Ens
Resumen del contenido incluido en la página 9
SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if you wish to purchase spare parts please contact your local Electrolux Service Force Centre by telephoning: 0870 5 929929 Your telephone call will be automatically routed to the Service Centre covering your post code area. The addresses are listed on the following pages. Before calling out an engineer, please ensure you have read the details under the heading “Something Not Working” and have the model number and pur-
Resumen del contenido incluido en la página 10
GUARANTEE CONDITIONS Standard guarantee conditions We, Electrolux, undertake that if within 12 months of the date of purchase this Electrolux appliance or any part thereof is proved to be defective by reason only of faulty workmanship or materials, we will, at our option repair or replace the same FREE OF CHARGE for labour, materials or carriage on condition that: n The appliance has been correctly installed and used only on the electricity supply stated on the rating plate. n The appliance has
Resumen del contenido incluido en la página 11
11
Resumen del contenido incluido en la página 12
12
Resumen del contenido incluido en la página 13
TECHNICAL SPECIFICATIONS DIMENSIONS Height 81,5 cm Width 59,6 cm Depth 53,8 cm POWER SUPPLY VOLTAGE AND FREQUENCY 220-240 V / 50 Hz TOTAL POWER ABSORBED 70 W AVERAGE DAILY UNITS ELECTRICITY(*) 0,49 kWh GROSS CAPACITY 142 l NET CAPACITY 140 l (*)This figure is based on standard test results in accordance with European Standard EN153. Actual con- sumption will depend on how the appliance is used and where it is located. INSTALLATION Positioning For this appliance to work efficiently, it should be
Resumen del contenido incluido en la página 14
ELECTRICAL CONNECTION This appliance complies with the E.E.C. Directive WARNING: No. 87/308 of 2.6.87 relative to radio interference THIS APPLIANCE MUST BE EARTHED. suppression. The manufacturer declines any liability should this safety measure not be observed. This appliance complies with the following E.E.C. Directive: If the plug that is fitted to your appliance is not suit- able for your socket outlet, it must be cut off and the - 73/23 EEC of 19.2.73 (Low Voltage Directive) appropriate plu
Resumen del contenido incluido en la página 15
BUILDING-IN INSTRUCTIONS Before carrying out any work, remove the plug from the power socket. Door Reversal Left door opening: 1. Remove the grid from the appliance pulling it A towards you with hands. 2. Remove the left side (A) of the grid cutting it from the rear (see figure). DO002 To reposition the grid on the appliance proceed as fol- lows: a Apply the grid to the base of the appliance by pushing the clasps (a) until they click. N.B. The grid is to be assembled after having fixed the app
Resumen del contenido incluido en la página 16
To reverse the opening direction of the door, proceed as shown in the figures: Attention After completion of the door reversing opera- tion, check that the door gasket adheres to the cabinet. If the ambient temperature is cold (i.e. in Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fit- ting of the gasket or accelerate this process by heating up the part involved with a normal hairdryer on a low setting. 16
Resumen del contenido incluido en la página 17
600 550 min. Building the appliance in under a worktop The dimensions of the recessed installation area must correspond with those indicated in the figure. DO013 Remove covering and adjusting strips. Push the appliance into place. The plug socket neces- sary for connection of the appliance to the electricity supply should be positioned, so that the plug is not placed in the recess. S.I.005 Adjust height. 17 600
Resumen del contenido incluido en la página 18
To mount the furniture door proceed as shown in the figures: 18
Resumen del contenido incluido en la página 19
25 ÷ 80 Screw appliance into place. Refit the covering strip. Fitting the plinth Important For the efficient operation of the appliance, it is important that the original ventilation grid is used. n For an opening height dimension A=820 mm and a plinth height dimension a=100 mm, the plinth may be fitted without adjustments. The same applies to an opening height dimension B=870 mm and a plinth height dimension b=150 mm. n For plinth heights greater than a=100 mm, b=150 mm, a cut should be made
Resumen del contenido incluido en la página 20
© Electrolux Household Appliances Limited 2000
