Resumen del contenido incluido en la página 1
ULIN_016357_30089.fm Page 1 Monday, March 27, 2006 10:25 AM
Use and Care Guide
®
Combo Models:
CO29, CO75
CO29 CO75
Resumen del contenido incluido en la página 2
ULIN_016357_30089.fm Page 2 Monday, March 27, 2006 10:25 AM 1 Introduction Congratulations on your purchase of a U-Line refrigeration product. A pioneer in the field for more than 40 years, U-Line Corporation is the world’s number one manufacturer of built-in, under-counter, specialty refrigeration and ice making products. U-Line dedicates 100% of its research and development to these products. The result: U-Line technology consistently leads the market with innovation, design, depth of pr
Resumen del contenido incluido en la página 3
ULIN_016357_30089.fm Page 3 Monday, March 27, 2006 10:25 AM 2 Table of Contents Introduction ...............................................................................................................................2 Warranty Registration .......................................................................................................2 Please Record Your Model Information ...........................................................................2 Table of Contents ................
Resumen del contenido incluido en la página 4
ULIN_016357_30089.fm Page 4 Monday, March 27, 2006 10:25 AM This page intentionally left blank 4 CO29, CO75
Resumen del contenido incluido en la página 5
ULIN_016357_30089.fm Page 5 Monday, March 27, 2006 10:25 AM WARNING 3 Safety Precautions SHOCK HAZARD - Electrical Grounding Required. � Never attempt to repair or perform IM IMPO POR RT TA AN NT T maintenance on the unit until the electricity PLEASE READ all instructions completely before has been disconnected. attempting to install, operate, or service your unit. � Never remove the round grounding prong from � Proper installation procedures must be followed the plug and never use a two
Resumen del contenido incluido en la página 6
ULIN_016357_30089.fm Page 6 Monday, March 27, 2006 10:25 AM 4Product Features 5Operation Origins Ice Maker/Refrigerator Models CO29, CO75 � Both Origins models feature a manual defrost ice maker with a daily production capacity of 18 lbs (8.2 kg) and storage for 13 lbs (5.9 kg). ULIN_0130_A � Model CO29 provides 2.1 cu ft (59 L) of refrigeration capacity; Model CO75 provides a 4.2 cu ft (118 L) of Figure 2 refrigeration capacity. � Temperature is adjusted with a manual temperature IM IMP
Resumen del contenido incluido en la página 7
ULIN_016357_30089.fm Page 7 Monday, March 27, 2006 10:25 AM Temperature Control Ice Maker When the ice bucket is full, the ice making mechanism will Checking Product Temperature shut off. However, the refrigeration system will continue to cool and maintain the cube supply. Frost-free icemaker units have lower ice production than manual defrost units. IM IMPO POR RT TA AN NT T Do not place cans or bottles in the ice compartment because they will freeze. ULIN_0093_A Figure 4 To check the a
Resumen del contenido incluido en la página 8
ULIN_016357_30089.fm Page 8 Monday, March 27, 2006 10:25 AM The ice bucket can be removed for emptying and Storage, Vacation, Moving cleaning. To remove the ice bucket, raise the bin arm and If the unit will not be used for an extended period, or remove the bucket from the ice compartment. Use the ice otherwise stored, follow these steps completely: bucket for ice storage only. WARNING Normal Operating Sounds All models incorporate rigid foam insulated cabinets to Electrical Shock Hazard
Resumen del contenido incluido en la página 9
ULIN_016357_30089.fm Page 9 Monday, March 27, 2006 10:25 AM Product Disposal 6 Cleaning and Maintenance If the unit is being removed from service for disposal, check and obey all Federal, State and/or Local regulations General Cleaning regarding the disposal and recycling of refrigeration appliances, and follow these steps completely: Exterior Cleaning (As Required) 1. Disconnect power to the unit and unplug the power Black or White Models: cord from its outlet. � Surfaces may be cleaned
Resumen del contenido incluido en la página 10
ULIN_016357_30089.fm Page 10 Monday, March 27, 2006 10:25 AM � Do not use any solvent-based or abrasive To defrost: cleaners. These types of cleaners may transmit 1. Turn unit off. taste to the interior products and damage or discolor the interior. 2. Remove all products from the interior. Maintenance 3. Remove ice bucket and discard ice. 4. Place a towel or other absorbent material on bottom of Proper maintenance of your U-Line product will ensure ice bin and bottom of unit (Figure 7, 1)
Resumen del contenido incluido en la página 11
ULIN_016357_30089.fm Page 11 Monday, March 27, 2006 10:25 AM Condenser Cleaning Interval - Every Three Months To maintain operational efficiency, keep the front grille free of dust and lint, and clean the condenser every three months. Depending on environmental conditions, more or less frequent cleaning may be necessary. WARNING 2 1 Disconnect electric power to the unit before ULIN_0198_A cleaning the condenser. Figure 10 WARNING 6. Make sure grille cap is behind grille in slots provided i
Resumen del contenido incluido en la página 12
automatic ICE MAKER ULIN_016357_30089.fm Page 12 Monday, March 27, 2006 10:25 AM Ice Cube Thickness Adjustment Interval - As Required On ice maker equipped models, the cube size may be adjusted by changing the amount of water injected into 1 the ice maker assembly as follows: 2 ULIN_0154_A Figure 13 6. Place the two hook-hinges (Figure 13, 1) located on the rear bottom side of the grille onto the front lip of the unit base. Tilt the grille up into position and align the grille mounti
Resumen del contenido incluido en la página 13
ULIN_016357_30089.fm Page 13 Monday, March 27, 2006 10:25 AM Door Alignment Check and Adjustment IM IMPO POR RT TA AN NT T Use only genuine U-Line replacement parts. U-Line IM IMPO POR RT TA AN NT T ice maker parts are not the same as standard FSP Properly aligned, the door’s gasket should be firmly Whirlpool parts. Using non U-Line parts can reduce in contact with the cabinet all the way around the ice rate, cause water to overflow from ice maker door (no gaps). Carefully examine the d
Resumen del contenido incluido en la página 14
ULIN_016357_30089.fm Page 14 Monday, March 27, 2006 10:25 AM Door Reversal CO29: Depending upon the location of the unit, it may be desirable to change the side on which the door is mounted. NOTE: On built-in installations, changing the door mounting to the left side may interfere with ice bucket removal. To reverse the door mounting, perform the following: 1 ULIN_0215_A Figure 22 3. Remove bottom hinge from cabinet (two screws) (Figure 22). ULIN_0014_A Figure 20 1. Remove the control k
Resumen del contenido incluido en la página 15
ULIN_016357_30089.fm Page 15 Monday, March 27, 2006 10:25 AM 1 ULIN_0109_A ULIN_0145_A Figure 25 Figure 28 6. Relocate plastic spacer/bushing (Figure 25, 1) on 11. Fasten upper hinge to unit (three screws) (Figure 28). bottom of door to opposite side, and place door on Partially tighten screws until door is aligned. bottom hinge pin. Clean out bushing hole in door 12. Adjust door to assure proper seal. Tighten upper hinge bottom with a screwdriver if needed. screws securely. 13. Replace
Resumen del contenido incluido en la página 16
ULIN_016357_30089.fm Page 16 Monday, March 27, 2006 10:25 AM Figure 32 CO75: NOTE: The grille should not yet be installed. If it has been 4. Remove four plastic plugs in hinge holes, invert screw installed, remove it for door reversing. and reinstall pivot screw in top hinge (Figure 32). Do not install hinge on cabinet at this time. To reverse the door on black models: ULIN_0220_A ULIN_0218_A Figure 33 Figure 30 5. Remove bottom hinge from cabinet (four screws) and 1. Remove top hinge from
Resumen del contenido incluido en la página 17
ULIN_016357_30089.fm Page 17 Monday, March 27, 2006 10:25 AM 8. Relocate plastic spacer/bushing on bottom of door to Glass Shelf Removal/Installation the opposite side (Figure 35). Clean out bushing hole Remove the shelves as follows: in door bottom if necessary. ULIN_0223_A Figure 36 9. Place door on lower hinge pin. Align flat edge of top ULIN_0232_A hinge with outer edge of unit and fasten upper hinge to unit (four screws). Partially tighten screws (Figure Figure 37 36). 1. Pull shelf
Resumen del contenido incluido en la página 18
ULIN_016357_30089.fm Page 18 Monday, March 27, 2006 10:25 AM 7Service Before Calling for Service If your U-Line product appears to be malfunctioning, read through the OPERATION section of this guide to ensure that the function of all controls are clearly understood. If the malfunction persists, the TROUBLESHOOTING GUIDE in this guide will assist you in quickly identifying common problems, and provide information on possible causes and remedies. Most often, this will resolve the problem
Resumen del contenido incluido en la página 19
ULIN_016357_30089.fm Page 19 Monday, March 27, 2006 10:25 AM Troubleshooting Guide DANGER ELECTROCUTION HAZARD Never attempt to repair or perform maintenance on the unit until the main electrical power has been disconnected. Troubleshooting - What to check when problems occur: PROBLEM POSSIBLE CAUSE REMEDY Unit not cold enough Door gasket not sealing properly Adjust door (See MAINTENANCE; DOOR ALIGN, ADJUST, REVERSE). Item(s) interfering with door Reposition or remove item(s). Dirty conden
Resumen del contenido incluido en la página 20
ULIN_016357_30089.fm Page 20 Monday, March 27, 2006 10:25 AM This page intentionally left blank 20 CO29, CO75
