Resumen del contenido incluido en la página 1
®
REFRIGERATOR USER INSTRUCTIONS
THANK YOU for purchasing this high-quality product. If you should experience a problem not covered in TROUBLESHOOTING,
please visit our website at www.whirlpool.com for additional information. If you still need assistance, call us at 1-800-253-1301.
In Canada, visit our website at www.whirlpool.ca or call us at 1-800-807-6777.
You will need your model and serial number, located on the inside wall of the refrigerator compartment.
Table of Contents / Índic
Resumen del contenido incluido en la página 2
IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of fire, electric shock, or injury when using your refrigerator, follow these basic precautions: ■ Plug into a grounded 3 prong outlet. ■ Use nonflammable cleaner. ■ Do not remove ground prong. ■ Keep flammable materials and vapors, such as gasoline, away from refrigerator. ■ Do not use an adapter. ■ Use two or more people to move and install refrigerator. ■ Do not use an extension cord. ■ Disconnect power before installing ice maker (
Resumen del contenido incluido en la página 3
Location Requirements Electrical Requirements WARNING WARNING Explosion Hazard Electrical Shock Hazard Keep flammable materials and vapors, such as Plug into a grounded 3 prong outlet. gasoline, away from refrigerator. Do not remove ground prong. Failure to do so can result in death, explosion, or fire. Do not use an adapter. Do not use an extension cord. To ensure proper ventilation for your refrigerator, allow for ¹⁄₂" (1.25 cm) of space on each side and at the top. Allow for 1" Failure to f
Resumen del contenido incluido en la página 4
6. Fasten the shutoff valve to the cold water pipe with the pipe Water Pressure clamp. Be sure the outlet end is solidly in the ¹⁄₄" (6.35 mm) drilled hole in the water pipe and that the washer is under the pipe clamp. Tighten the packing nut. Tighten the pipe clamp A cold water supply with water pressure of between 30 and screws slowly and evenly so the washer makes a watertight 120 psi (207 and 827 kPa) is required to operate the water dispenser and ice maker. If you have questions abou
Resumen del contenido incluido en la página 5
NOTE: Tighten the nut by hand. Then tighten it with a wrench two more turns. Do not overtighten. REFRIGERATOR USE Using the Controls Temperature Control Adjustment and Cooling On/Off The refrigerator and freezer control buttons are located on the dispenser panel. A B C D E F G A. Refrigerator water tubing E. Ferrule (purchased) B. Nut (provided) F. Nut (purchased) C. Bulb G. Household water line D. Coupling (purchased) 4. Turn shutoff valve ON. 5. Check for leaks. Tighten any nuts or connec
Resumen del contenido incluido en la página 6
■ Press the FAST ICE/COOL button to turn on the Fast Cool Adjusting the Controls feature. When the feature turns on, the “Fast Cool” animation will appear on the dispenser display. To adjust the set points, press and hold the TEMPERATURE button for 3 seconds. When adjust mode is activated, set points and adjusting information will appear on the display screen. The Fast Cool setting will remain on for 24 hours unless manually turned off. ■ Press FAST ICE/COOL again to turn off Fast Cool an
Resumen del contenido incluido en la página 7
Convertible Drawer Temperature Control Water and Ice Dispensers (on some models) (on some models) The control can be adjusted to properly chill meats or vegetables. Depending on your model, you may have one or more of the The air inside the pan is cooled to avoid “spot” freezing and can following options: the ability to select either crushed or cubed ice, be set to keep meats at the National Livestock and Meat Board a rotating water dispenser faucet and pull-out tray, a special light recommen
Resumen del contenido incluido en la página 8
2. You can dispense water by the ounce, cup, or liter. Press ICE NOTE: When using the dispenser with the faucet rotated, do and LIGHT to select your desired setting. Default, minimum, not use the water dispenser pad. Only use the WATER button and maximum volumes are listed below. to dispense. Dispensing by pressing the container against the water dispenser pad may result in unintentional spilling. Units Default Minimum Maximum ■ The tray can be pulled out approximately 2" (5.08 cm) to Ounce
Resumen del contenido incluido en la página 9
■ Do not use anything sharp to break up the ice in the storage The Dispenser Light (on some models) bin. This can cause damage to the ice container and the dispenser mechanism. When you use the dispenser, the light will automatically turn on. ■ Do not store anything on top of or in the ice maker or storage If you want the light to be on continuously, you may choose either bin. ON or DIM or AUTO. The display screen indicates which mode is selected. Removing and Replacing Ice Storage Bin 1.
Resumen del contenido incluido en la página 10
5. Remove the covers from the O-rings. Be sure the O-rings are 6. Push the filter into the base grille. The eject button will pop still in place after the covers are removed. back out when the filter is fully engaged. 7. Flush the water system. See “Water and Ice Dispensers.” REFRIGERATOR CARE 5. There is no need for routine condenser cleaning in normal home operating environments. If the environment is Cleaning particularly greasy or dusty, or there is significant pet traffic in the home, t
Resumen del contenido incluido en la página 11
TROUBLESHOOTING First try the solutions suggested here or visit our website and reference FAQs (Frequently Asked Questions) to possibly avoid the cost of a service call. In the U.S.A., www.whirlpool.com In Canada, www.whirlpool.ca Refrigerator Operation ■ Sizzling/Gurgling - water dripping on the heater during The refrigerator will not operate defrost cycle ■ Popping - contraction/expansion of inside walls, especially during initial cool-down WARNING ■ Water running - may be heard when ice
Resumen del contenido incluido en la página 12
Off-taste, odor or gray color in the ice Temperature and Moisture ■ New plumbing connections? New plumbing connections Temperature is too warm can cause discolored or off-flavored ice. ■ Ice stored too long? Discard ice. Wash ice bin. Allow ■ New installation? Allow 24 hours following installation for the 24 hours for ice maker to make new ice. refrigerator to cool completely. ■ Odor transfer from food? Use airtight, moisture-proof ■ Door(s) opened often or left open? Allows warm air to en
Resumen del contenido incluido en la página 13
The water dispenser will not operate properly WATER FILTER CERTIFICATIONS ■ Freezer door closed completely? Close the door firmly. If it does not close completely, see “The doors will not close completely.” ■ Refrigerator connected to a water supply and the supply shutoff valve turned on? Connect refrigerator to water supply and turn water shutoff valve fully open. ■ Is the water pressure at least 30 psi (207 kPa)? The water pressure to the home determines the flow from the dispenser. See
Resumen del contenido incluido en la página 14
PERFORMANCE DATA SHEETS Base Grille Water Filtration System Model T2WG2L/T2RFWG2 Capacity 200 Gallons (757 Liters) Model T2WG2/T2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class II*; and against NSF/ANSI Standard 53 for the reduction of Mercury, Benzene, Toxaphene, O-dichlorobenzene, and Carbofuran. This system has been tested according to NSF/ANSI Standards 42
Resumen del contenido incluido en la página 15
Base Grille Water Filtration System Model T1WG2L/T2RFWG2 Capacity 200 Gallons (757 Liters) Model T1WG2/T2RFWG2 Capacity 200 Gallons (757 Liters) System tested and certified by NSF International against NSF/ANSI Standard 42 for the reduction of Chlorine Taste and Odor, Particulate Class II*; and against NSF/ANSI Standard 53 for the reduction of Mercury, Benzene, Toxaphene, O-dichlorobenzene, and Carbofuran. This system has been tested according to NSF/ANSI Standards 42 and 53 for the reductio
Resumen del contenido incluido en la página 16
WHIRLPOOL CORPORATION MAJOR APPLIANCE WARRANTY LIMITED WARRANTY For one year from the date of purchase, when this major appliance is operated and maintained according to instructions attached to or furnished with the product, Whirlpool Corporation or Whirlpool Canada LP (hereafter “Whirlpool”) will pay for Factory Specified Parts and repair labor to correct defects in materials or workmanship. Service must be provided by a Whirlpool designated service company. This limited warranty is valid o
Resumen del contenido incluido en la página 17
® INSTRUCCIONES PARA EL USUARIO DEL REFRIGERADOR LE AGRADECEMOS la compra de este producto de alta calidad. Si usted experimenta un problema que no se haya cubierto en SOLUCIÓN DE PROBLEMAS, visite nuestro sitio de internet en www.whirlpool.com para obtener información adicional. Si considera que aún necesita ayuda, llámenos al 1-800-253-1301. En Canadá, visite nuestro sitio de internet en www.whirlpool.ca o llámenos al 1-800-807-6777. Necesitará tener a mano su número de modelo y de serie
Resumen del contenido incluido en la página 18
Antes de tirar su viejo refrigerador o congelador: Cómo deshacerse adecuadamente de su ■ Saque las puertas. refrigerador viejo ■ Deje los estantes en su lugar para que los niños no puedan meterse con facilidad. ADVERTENCIA Peligro de Asfixia Remueva las puertas de su refrigerador viejo. No seguir esta instrucción puede ocasionar la muerte o daño al cerebro. IMPORTANTE: El atrapamiento y asfixia de niños no es un problema del pasado. Los refrigeradores tirados y abandonados son un peligro, a
Resumen del contenido incluido en la página 19
NOTAS: ■ No se recomienda instalar el refrigerador cerca de un horno, Requisitos del suministro de agua radiador u otra fuente de calor. No instale el refrigerador cerca Reúna las herramientas y piezas necesarias antes de comenzar la de una ubicación en la que la temperatura puede bajar de los instalación. Lea y siga las instrucciones provistas con cualquiera 55°F (13°C). de las herramientas enlistadas aquí. ■ El ancho mínimo normal necesario para el área de corte del HERRAMIENTAS NECESAR
Resumen del contenido incluido en la página 20
Conexión del suministro de agua Lea todas las instrucciones antes de comenzar. Conexión al refrigerador IMPORTANTE: Si enciende el refrigerador antes de conectar la línea del agua, APAGUE la fábrica de hielo. Estilo 1 1. Desenchufe el refrigerador o desconecte el suministro de Conexión a la línea de agua energía. 1. Desenchufe el refrigerador o desconecte el suministro de 2. Quite y deseche la parte de plástico que está sujeta a la energía. entrada de la válvula de agua. 3. Fije el tubo de co
