Resumen del contenido incluido en la página 1
A
JA-2SD
HANDSFREE SUB MASTER STATION
HANDSFREE SUB MASTER STATION
HANDSFREE SUB MASTER STATION
HANDSFREE SUB MASTER STATION
HANDSFREE SUB MASTER STATION
JA-2SD
INSTALLATION & OPERATION MANUAL
MANUEL D’INSTALLATION ET D’UTILISATION
EINBAU- & BEDIENUNGSANLEITUNG
MANUAL DE INSTALACION Y OPERACION
INSTALLATIE- EN BEDIENINGSHANDLEIDING
- 1 -
Resumen del contenido incluido en la página 2
* Places where the temperature is quite low, such as inside a refrigerated areaor in front of air-conditioner. General Prohibitions Prohibition to Dismantle the Unit PRECAUTIONS GENERALES 1. This unit is for indoor use only. Do not use outdoors. Prohibition on Subjecting the Unit to Water General Precautions 2. In areas where broadcasting station antennas are close by, the intercom system may be affected by radio frequency interference. WARNING 3. If a cellular phone is used close by, the
Resumen del contenido incluido en la página 3
PRECAUCION INSTALLATION (No seguir estas instrucciones podría causar daños físicos o materiales) INSTALLATION 1. Before turning on the power, make sure wires are not crossed or shorted. Fire or EINBAU electric shock could result. 2. When mounting the unit on wall, install the unit in a convenient location, but INSTALACIÓN not where it could be jarred or bumped. Injury could result. 3. While the power supply is turned on, do not make any wiring INSTALLATIE connections.Electric shock or unit troub
Resumen del contenido incluido en la página 4
Deutsch WIRING NAMES Wiring method NOMES Wire the inside stations in a station-to-station manner. BEZEICHNUNGEN Cable 1. Parallel cable or single-sheathed cable are recommended. NOMBRES Vinyl jacket, PE(polyethylene) insulation cable is BENAMINGEN recommended. 2. Never use loose wires, twisted pair cable or coaxial cable. 3. When using existing wires, which may contain unused wires, it is suggested to terminate both ends of unused pair(s) with a 120Ω resistor. Español WIRING Wiring method Wire t
Resumen del contenido incluido en la página 5
Deutsch NAMES & FUNCTIONS MOUNTING [1] Speaker MONTAGE [2] Door call-in LED (Door 1) [3] Door call-in LED (Door 2) MONTAGE [4] Room CALL button MONTAJE [5] DOOR RELEASE button [6] Mic. MONTAGE [7] TALK button [8] Transmit LED [9] Door call-in selector: 1, 2 or 1&2 3-1 [10] Chime TONE volume control Español NAMES & FUNCTIONS [1] Speaker [2] Door call-in LED (Door 1) [3] Door call-in LED (Door 2) [4] Room CALL button [5] DOOR RELEASE button [6] Mic. [7] TALK button [8] Transmit LED [9] Door call-i
Resumen del contenido incluido en la página 6
3-2 WIRING CABLAGE VERDRAHTUNG ALAMBRADO AANSLUITING English MOUNTING 1. Push RELEASE button (to unlock or to insert the wire securely). 2. Insert the cable into terminal. [1] Screw (x2) [2] Wall mounting bracket [3] Single-gang box English Français WIRING MOUNTING Impedance matching switch 1. Push RELEASE button (to unlock or to insert the wire Terminate farthest sub station, putting SW. to ON position, securely). otherwise both image and audio are deteriorated. 2. Insert the cable into termina
Resumen del contenido incluido en la página 7
Español Answering a door call (AUTO mode) OPERATIONS 1. Momentarily depress CALL button. OPÉRATION 2. Chime tone sounds and caller’s voice is heard. Door call-in LED is lit for DOOR 1, or DOOR 2. BEDIENUNG 3. Press for a moment TALK button and reply handsfree. OPERACIÓNES 4. Press once TALK button at the end. NOTES: Call-in timer; 45 sec. (approx.) BEDIENING Communication timer; 1 min. (approx.) Press TALK button to manually turn on again (within 30 sec. after communication). 5-1 Nederlands Answ
Resumen del contenido incluido en la página 8
Français English Answering a door call (MANUAL mode) Instant voice calling 1. Momentarily depress CALL button. 1. Momentarily depress CALL button. And, speak to inside 2. Chime tone sounds and caller’s voice is heard. station. Door call-in LED is lit for DOOR 1 or DOOR 2. 2. Chime tone sounds and caller’s voice is heard. Door call-in 3. Depress and hold down TALK button for 1 sec. or more. LED is lit for DOOR 1 or DOOR 2. 4. To transmit, talk while pressing TALK button, and to listen, NOTES: JA-
Resumen del contenido incluido en la página 9
Nederlands Activating Door Release 5-6 1. Depress and hold down DOOR RELEASE button. 2. The door is unlocked. NOTES: Not available in standby mode. 5-5 English Transfer door call 1. While answering door, press CALL (Room call) button. After sounding a pretone, speak to the rest station(s). 2. At the called station(s), a pretone sounds, and both image and audio of door are activated. 3. Transferred station answers by pressing once TALK button. Room-to-room communication English To end, press TALK
Resumen del contenido incluido en la página 10
Nederlands Español Transfer door call For JA-2M(E)CD system 1. While answering door, press CALL (Room call) button. After Turning on/off Alarm (activated by Motion-detect sounding a pretone, speak to the rest station(s). sensor camera) 2. At the called station(s), a pretone sounds, and both image and In standby, keep pressing TALK button for 5 seconds or more. audio of door are activated. Release TALK button, after the SET tone is heard as follows; 3. Transferred station answers by pressing once
Resumen del contenido incluido en la página 11
Español Español TECHNICAL PRECAUTIONS SPECIFICATIONS * Operating temperature: 0°C ~ 40°C (+32°F ~ +104°F). • Power source: Supplied from master station * Cleaning: Clean the units with a soft cloth dampened with (DC18V). neutral household cleanser. Do not use any abrasive cleaner or • Consumption: (MAX) 120mA. cloth. • Calling: Chime tone, 30 sec. approx. * In case of system malfunction, turn off the power switch at • Communication: Handsfree voice-actuated master station. If this doesn't
Resumen del contenido incluido en la página 12
Aiphone warrants its products to be free from defects of material and Aiphone warrants its products to be free from defects of material and workmanship workmanship under normal use and service for a period of one year after delivery to under normal use and service for a period of one year after delivery to the ultimate user the ultimate user and will repair free of charge or replace at no charge, should it become and will repair free of charge or replace at no charge, should it become defective
