Manual de instrucciones de Toshiba E-STUDIO1355

Resumen del contenido incluido en la página 1

Copier Bulletin: TSB-1078
Date: 4/8/2011
Page: 1 of 3

Models: e-STUDIO1355 Series
Subject: Service Manual Correction – Tray Heaters

Overview
Corrections are needed to the “Connecting the Tray Heaters” section of the e-STUDIO1355
Series Service Manual.
Detail
Please download the corrected manual or store the following corrections with your service
manual. The corrected manual is version 00a or later, posted on 3/25/2011. (Corrections are in
red)
Location of the Incorrect

Resumen del contenido incluido en la página 2

1. Switch off the main power switch and disconnect the power cord from the power source. 2. Open the PSU box [A]. To set the connector 1. Connect the white connector [B] to CN602 on the AC drive board [C]. NOTE:  Connect the large connector clamped beneath the board.  This step is not required if the LCIT anti-condensation heater will be connected. To supply power 24 hours a day Doing the connection in the previous procedure assures that power is supplied to the machine for th

Resumen del contenido incluido en la página 3

1. Remove the small connector [A] from the relay connector and then connect it to connector CN606. 2. Clamp the relay connector [B] to the bracket of the AC drive board. 3. Connect the large connector [C] to connector CN602 as described in the previous procedure.