Resumen del contenido incluido en la página 1
Caboose Stand-On Tandem
Instruction Manual
40X & 41X Series
Patent No. 5,622,375
Joovy • 2919 Canton Street • Dallas, TX 75226 • (877) 456-5049 • Fax: (214) 761-1774
E-mail: customerservice@joovy.com • Website: www.joovy.com
Resumen del contenido incluido en la página 2
! WARNINGS ! Please read this instruction manual completely before using this stroller. Keep these instructions for future reference. • Failure to follow these instructions could result in serious injury or death. • Never leave child unattended. • Avoid serious injury from falling or sliding out. • Always use safety belts and ensure that all children are positioned according to these instructions. • Keep all small parts out of the reach of children while assembling t
Resumen del contenido incluido en la página 3
Assembling and Using your Stroller ! To ensure safe operation of your stroller, please follow these instructions carefully. Unpacking the Product • Carefully remove stroller and all parts from the box and plastic bag. • Identify the parts (stroller, front wheels (2), rear wheels (2), canopy, tray, car seat carrier support, rear axle, washers (4), snap pins (2), hub caps (2) and documents) with the pictures in Figures 1a and 1b. NOTE: The rear axle is attached with red tie wraps to the rear
Resumen del contenido incluido en la página 4
Unfolding the Stroller • Keep children away from stroller while unfolding. • Position the stroller with the handle bar closest to you. • Release the locking latch located on the right side by lifting the lever off of the extended rivet. See Figure 2. • Lift up slightly on the handle of the stroller. Then place one foot onto the rear platform and pull up and back on the handle until both side frame bars snap into their locking positions in the frame. CAUTION: While unfolding the stroller be c
Resumen del contenido incluido en la página 5
• Push the axle as far as it will go toward the opposite side of the stoller, then repeat the installation steps for the other wheel. • Install a hubcap onto each wheel by aligning the 5 tabs on the hubcap with the 5 slots in the wheel, and then pushing it into place. Ensure that ALL 5 snaps have engaged securely and the hubcap cannot be pulled off. See Figure 7. Figure 4 Figure 5 Figure 6 Figure 7 Installing the Front Wheels • Take one of the double wheel sets and locate the small hole
Resumen del contenido incluido en la página 6
Front Wheel Locks The front wheels can be either in swivel mode or locked mode. • To put the front wheels in their locked mode, first rotate each wheel set so that the wheels are pointed straight ahead. • Pull up on the lever to engage the small tab on the lever with the slot in the plastic frame sleeve. The lever can be either facing forward or rearward to lock the wheels. See Figure 9. • To unlock the wheels and put them Figure 9 into swivel mode, push down on the lever to disengage
Resumen del contenido incluido en la página 7
Figure 12 Figure 13 ! WARNING Possible pinching hazard - Be careful when closing and opening the side hinges so as not to pinch your fingers. Attaching/Detaching the Front Tray • To attach the front tray, line up the female fittings on the tray with the male fittings on the front of the stroller and push inward until the fittings snap into place. See Figure 14. Pull outward on both sides of the tray to be sure both are snapped securely in place. • To remove the front tray, press the lock bu
Resumen del contenido incluido en la página 8
Rear Wheel Brakes • Before placing any child into the stroller or removing them from the stroller, be certain that the rear wheel brakes are engaged. • To engage the rear wheel brakes, push down on the brake lever located on each rear wheel. See Figure 16. The stroller may require slight forward or rearward movement in order to line up the teeth on the brake with each wheel brake cluster. • Check that the brakes are properly applied by attempting to push the stroller backward and forward.
Resumen del contenido incluido en la página 9
! WARNING Never allow a child to step onto the footrest in either position in order to get into or out of the stroller. This may cause the stroller to tip over and injure the child. Securing the Front Seated Child • Ensure that the two snaps on both armrest pads that hold the seat onto the frame are securely snapped together. • Ensure that both shoulder straps are attached to the waist strap buckles. See Figure 20. • Unlatch the waist/shoulder buckle by squeezing the latch releases on both sid
Resumen del contenido incluido en la página 10
Seatback Positioning The front seat has two positions. The fully upright position should only be used for a child that is at least 6 months old. • To place the seat in the upright position, push the bar on the rear of the seat toward the front of the stroller and rotate the seatback towards the front of the stroller until this bar is locked in its LOWEST position. See Figure 24. • To recline the seat, pull the bar on the rear of the seat toward the rear of the stroller and rotate the seatbac
Resumen del contenido incluido en la página 11
! WARNING The rear stand-on platform and the rear bench seat are designed for a child that is at least 2-1/2 years old but LESS than 44 inches tall and less than 45 lbs. Use of the stroller with two children weighing more than 45 pounds each, or children totaling more than 90 pounds, will cause excessive wear and stress on the stroller and may cause a hazardous unstable condition. NEVER use this stroller to carry more than 2 children at the same time. NEVER allow a standing child to use the
Resumen del contenido incluido en la página 12
Using the Stroller as an Infant Car Seat Carrier • To use the stroller to carry an infant car seat carrier, you must replace the Front Tray with the Car Seat Carrier Support. • Remove the Front Tray by pressing in on the lock tabs and pulling the tray off the brackets. Store the tray in a convenient place for later use. Figure 28 • Line up the female fittings on the Car Seat Carrier Support to the male fittings on the front of the stroller and push inward until the fittings snap into
Resumen del contenido incluido en la página 13
! WARNING ALWAYS install the infant carrier so that the child is facing toward the rear (handle) of the stroller with the restraining straps secured. ALWAYS position the infant carrier so that it is securely placed down inside the Car Seat Carrier Support frame. ALWAYS position the infant carrier so that it is resting ON the seatback, but NOT on the top of the seatback. NEVER position the carrier restraining straps on or near the child’s neck as this may result in strangulation. Right Way Pa
Resumen del contenido incluido en la página 14
! IMPORTANT NOTE When using your stroller as an infant car seat carrier, the following are the compatible infant car seat models that the Caboose Stand-On Tandem will accommodate: • Evenflo® Embrace™ • Baby Trend® Latch-Loc and Flex-Loc • Britax® Companion™ • Graco® Safe Seat™ • Chicco® Key Fit Car Seat • Graco® Snug Rider™ Series • Combi® Centre Series • Maxi Cosi Mico • Peg Perego® Primo Viaggio • Combi® Connection • Peg Perego® Primo Viaggio SIP • Compass® Light and Portable Infant Car
Resumen del contenido incluido en la página 15
Figure 32 Figure 33 Storage Basket Please note there is elastic on the basket sides for easy access, or, you can access the storage basket by sliding the rear bench seat forward or backward. The maximum weight that can be carried in the storage basket is 5 pounds. Excessive weight may result in a hazardous unstable condition. Maintenance All of the fittings, snaps, locks, rivets, and other hardware and plastic parts on the stroller should be inspected periodically to ensure that they are s
Resumen del contenido incluido en la página 16
SATISFACTION GUARANTEED We want you to be completely satisfied with your purchase of this product. Should you experience any difficulty in assembling or using this product, or if you have any questions, please contact our Customer Service Department at (877) 456-5049 between the hours of 8:30 am and 5:00 pm Central Time. Deluxe neoprene parent organizer 2 Cupholders Zipperedpocket Three additional pockets Notools needed for installation Reversible two-sidedseat pad. COOL
Resumen del contenido incluido en la página 17
Customrain cover for both children Zipperedbutton holepass through for front seat Custom sun filter for both children’s comfort Zippered button hole pass through for front seat Protectsfrom insects Page 15 Caboose Stand-On Tandem Instruction Manual Page 16
Resumen del contenido incluido en la página 18
Please log onto www.joovy.com to register your new Joovy product. Look for these other Joovy products Page 17 Caboose Stand-On Tandem Instruction Manual Page 18
Resumen del contenido incluido en la página 19
h t e B n a i c k s , e o r d S Page 17 Caboose Stand-On Tandem Instruction Manual Page 18 i i R t s i l n l t o h e D F r o r n t! u o Y
Resumen del contenido incluido en la página 20
Joovy • 2919 Canton Street • Dallas, TX 75226 • (877) 456-5049 • Fax: (214) 761-1774 E-mail: customerservice@joovy.com • Website: www.joovy.com ©Joovy 2008 • Document Version 1.1
