Manual de instrucciones de Dynamic Distributors Polarized-Media

Resumen del contenido incluido en la página 1

Polarized-Media
Electronic Air Cleaner



Installation
Instructions
&
Consumer
Information




Section I. Installation Instructions

1) Turn the thermostat fan switch to the “OFF” position.
2) Turn off power to the furnace/air handler.
3) Remove the existing filter from the furnace/air handler or return air grille.
4) Wiring to the on-board transformer or integrated furnace control:

NOTE: ONLY A QUALIFIED ELECTRICIAN SHOUL

Resumen del contenido incluido en la página 2

If a Common or 24vac terminal cannot be located, it will be necessary to install a separate transformer. If a hard-wired transformer is used, an isolated class II transformer is recommended. The transformer must be installed according to local codes and ordinances. 5) If necessary, route the power cord through the furnace/air handler cabinet to the filter rack area. If an existing access hole is not available, drill a 7/16” hole. A grommet is provided to fit a 7/16" hole (fig 2). The

Resumen del contenido incluido en la página 3

1) Turn the thermostat fan switch to the “OFF” position. 2) Turn off power to the furnace/air handler. 3) Open the filter access door or grille. 4) Unplug the power supply cord from the air cleaner powerhead. 5) Remove the air cleaner from the filter rack or return air grille. 6) Open the air cleaner (fig 4), remove the old media pad Figure 4 and discard. 7) If dust has accumulated on the outer screen of the air cleaner, clean with a dry brush or vacuum. 8) Pos

Resumen del contenido incluido en la página 4

Item Description 1 Replacement Media Pad 2 Powerhead (inside channel) 3 Power Cord 4 Electrode Insulator Button 5 Air Cleaner Latch 6 Power ON Light 7 Label “Unplug before Opening” 8 Power Input Jack 9 Label 10 Electrode 11 Model / Power Rating Label 12 Air Cleaner Size Label 13 Patent Label 14 Hinge 15 Screen 16 Frame 17 Spline Figure 7 FOR TECHNICAL SUPPORT Call 1-800-578-7873