Resumen del contenido incluido en la página 1
™
OWNER'S
MANUAL
MODEL NO.
45-03085
UNivERSAL T OW BEhiND TiLLER
IMPORTANT! The engine is shipped without oil. Oil must be added
before starting the engine. See Engine Maintenance on page 9 of
this manual for instructions.
• Assembly
CAUTION:
• Operation
Read Rules for
• Customer Responsibilities
Safe Operation
• Service and Adjustment
and Instructions
• Repair Parts
Carefully
the fastest way to purchase parts www.speedepart.com
Printed in U.S.A. FORM NO. 40907 rev. (06/01/09)
Resumen del contenido incluido en la página 2
TABLE OF CONTENTS SAFETY RULES .............................................................3 STORAGE .....................................................................11 ASSEMBLY .....................................................................4 TROUBLEShOOTiNG ..................................................12 OPERATION ................................................................5-7 REPAIR PARTS ........................................................13-15 MAINTENANCE ............
Resumen del contenido incluido en la página 3
SAFETY RULES • Never place hands or feet under or into rotating parts IMPORTANT or concealed areas. Keep hands and feet clearly away from tine elements, belts, pulleys, etc., while Warnings, Cautions and Notes are a means of attracting engine is running. attention to important or critical information in this manual. • Wear substantial shoes and eye protection while using tiller. LOOk FOR THIS SyMBOL TO POINT OUT • Never attempt to make a maintenance adjustment IMPORTANT SAFETy PRECAUTIONS
Resumen del contenido incluido en la página 4
ASSEMBLY TO REMOVE UNIT FROM CARTON TO iNSTALL TE h TLLER i TNE ASSEMBL i ES i • Cut from top to bottom all four corners of the carton • Attach the floating hitch to the tractor's draw bar. and lay panels flat. See figure 1. Refer to OPERATING INSTRUCTIONS on page 6. • Remove the lag screw that holds the floating hitch to • Remove the preassembled 3/8" x 2" hex bolt and 3/8" the packing skid. nylock nut from the L.H. Tine Assembly. Slide the tine • Disassemble and discard carton's wood top an
Resumen del contenido incluido en la página 5
OPERATION RIGHT HAND (RH) AND LEFT HAND (LH) ARE WE RECOMMEND THAT yOU REMOVE THE MOWER DETERMINED FROM THE DRIVERS POSITION DECk BEFORE USING THE TILLER. REFER TO yOUR WHILE SEATED ON THE TRACTOR. TRACTOR OWNER'S MANUAL. NO k W YOUR TiLLER Compare the illustration below with your tiller to familiarize yourself with the location of various controls and adjustments. FGURE i 5 SAFETy SWITCH - prevents engine from starting while RECOIL START HANDLE - used to start the engine tine clutch lever is
Resumen del contenido incluido en la página 6
OPERATION The operation of any tiller can result in foreign objects thrown into the eyes, which can result in severe eye damage. Always wear safety glasses or eye shields before starting your tiller and while tilling. We recommend a wide vision safety mask for over the spectacles or standard safety glasses. • Repeat instructions in two preceding paragraphs until O h W TO USE YOUR TiLLER engine fires. When engine starts, move choke control gradually to RUN position. BEFORE STARTNG i YOUR TLL
Resumen del contenido incluido en la página 7
OPERATION • If the soil is extremely hard and dry, it may be TRANSPORTING yOUR TILLER desirable to cross till an area at shallow depth first, AROUND ThE YARD then till in the direction of planting rows on the second • Pull forward on lift handle until it locks in the up, pass at the final depth. transport position. • Where possible, we recommend tilling in a pattern similar to that shown in Figure 7. Make the first pass, AROUND TOWN then skip a space equal to the width of the tiller, and
Resumen del contenido incluido en la página 8
MAINTENANCE • Once a year you should replace the spark plug, clean GENERAL RECOMMENDATIONS or replace air filter and check tines and belts for wear. The warranty on this tiller does not cover items that A new spark plug and clean air filter assure proper have been subjected to operator abuse or negligence. air-fuel mixture and help your engine run better and To receive full value from the warranty, operator must last longer. maintain unit as instructed in this manual. Some adjustments wil
Resumen del contenido incluido en la página 9
MAINTENANCE TILLER LUBRICATION ENGINE MAINTENANCE Check transmission oil level after first 5 hours of operation. Remove oil fill plug (figure 10). Oil level must WARNING: Always stop engine and be even with the plug hole (with tiller level). If necessary, disconnect spark plug wire before cleaning, add oil. Use SAE 30 non-detergent motor oil. Replace oil lubricating or before performing any repairs fill plug. or maintenance. Check transmission oil level after each 10 hours of operation
Resumen del contenido incluido en la página 10
SERVICE AND ADJUSTMENTS WARNING: Shut off (disengage) the Tine Clutch Lever, the Tiller Engine and the Tractor Engine before making any repairs. TO REPLACE V-BELT Replace V-belt if it has been damaged considerably from slipping under heavy loads or if it show cracks or frayed edges. Refer to figures 12 and 13. IMPORTANT: Do not move or remove the belt guide. If the position of the belt guide is accidentally altered, return it to the correct setting (6-1/2" above the tine shield support
Resumen del contenido incluido en la página 11
SERVICE AND ADJUSTMENTS WARNING: Shut off (disengage) the Tine SPARE TINE DRIVE BOLTS Clutch Lever, the Tiller Engine and the Tractor Engine before making any repairs. • The Tiller drive components are protected from damage by (shearable) Grade 5 hex bolts in the Tine Assemblies. The hex bolts drive the tines and hold them in the proper location. Should the Tine TINE CARE Assemblies strike or pick up a large hidden object or become jammed, the hex bolts will break and the • For best res
Resumen del contenido incluido en la página 12
TROUBLESOO h TNG i Follow the instructions in the "Service & Storage" section of the Engine Manual when performing any work on the Engine. PROBLEM Probable Cause Possible Remedy WiLL NOT START OR hARD TO START No gasoline in fuel tank Fill tank with gasoline Choke not set properly Place choke control in choke position Throttle control not set properly Place throttle control in fast position Choked improperly, flooded engine Move choke control to run position, place throttle control in fast pos
Resumen del contenido incluido en la página 13
REPAIR PARTS FOR MODEL 45-03085 UNIVERSAL TOW BEHIND TILLER 11 11 15 8 16 21 1 2 13 3 19 21 14 4 5 25 18 20 12 23 24 10 9 17 22 7 6 5 4 3 2 1 REF. PART NO. TY q . DESCRIPTION REF. PART NO. qTY . DESCRIPTION 1 HA20125 2 Felt Washer 14 66270 1 Idler Shaft Assembly 2 26707 2 Cap 15 66271 1 Input Shaft Assembly 3 49983 8 Flanged Lock Nut, 5/16-18 16 HA20145 1 Seal 4 66641 2 Flange and Bearing Assembly 17 42087 1 Roller Chain (Long) 5 HA20122 2 Flange Gasket 18 66722 1 Drive Housing (RH) 6 66721 1 D
Resumen del contenido incluido en la página 14
DANGER KEEP AWAY FROM ROTATING TINES. ROTATING TINES WILL CAUSE INJURY. 36" REPAIR PARTS FOR MODEL 45-03085 UNIVERSAL TOW BEHIND TILLER 14 DANGER KEEP AWAY FROM ROTATING TINES. ROTATING TINES WILL CAUSE INJURY. 36" DANGER TO AVOID SERIOUS INJURY, DO NOT OPERATE WITHOUT BELT GUARD AND ALL OTHER SHIELDS IN PLANCE AND IN GOOD CONDITION. 75 9 3 76 24 22 1 11 13 75 74 4 86 77 7 14 8 2 A 78 87 15 A 83 79 6 72 48 39 89 5 42 4 88 45 27 C 30 46 47 84 41 10 32 19 23 28 67 28 28 29 85 12 26 B 63 31 60
Resumen del contenido incluido en la página 15
REPAIR PARTS FOR MODEL 45-03085 UNIVERSAL TOW BEHIND TILLER REF. PART NO. TY q . DESCRIPTION REF. PART NO. TY q . DESCRIPTION 1 40993 1 Engine (49 State) 46 40711 1 Nylock Nut, 8-32 40997 1 Engine (California) 47 47600 1 Bolt, Hex 5/16-24 x 1" 2 48346 1 Guide - Belt 48 HA5236 1 Pin, Hitch 3 43085 4 Bolt, 5/16-18 x 1-1/2" Hex Head 49 43062 1 Bolt, 3/8-16 x 1-1/2" Hex Head 4 HA115321 2 Set Screw, 5/16-18 x 5/16" 50 HA20918 2 Wheel 5 HA11154 1 Key, Square 1/4" x 2" 51 R74780828 1 Bolt, 1/2-13 x 1-
Resumen del contenido incluido en la página 16
the fastest way to purchase parts www.speedepart.com REPAIR PARTS Agri-Fab, Inc. 809 South Hamilton Sullivan, IL. 61951 217-728-8388 www.agri-fab.com © 2001 Agri-Fab, Inc.
