Manual de instrucciones de American Standard 2891

Resumen del contenido incluido en la página 1

INSTALLATION INSTRUCTIONS
®
BOULEVARD Dual Flush One-Piece Toilet
®
Model 2891-Elongated Right Height with Seat
Thank you for selecting American Standard – the benchmark of fine quality for over 100 years. To ensure
this product is installed properly, please read these instructions carefully before you begin. (Certain
Certified by
installations may require professional help.) Also be sure your installation conforms to local codes.
IAPMO R&T
CAUTION: PRODUCT IS FRAGILE. TO AVOID BREAKAGE AND P

Resumen del contenido incluido en la página 2

INSTALL CLOSET BOLTS 4 5 3 Install closet bolts in flange channel, turn 90°, and slide into place 6" (152mm) apart and parallel to wall. NUT OPENING CLOSET WASHER FLANGE A FLANGE CLOSET CLOSET BOLTS SEALANT BOLT WAX RING INSTALL WAX SEAL Invert toilet on floor (cushion to prevent POSITION TOILET ON FLANGE damage), and install wax ring evenly around a. Unplug floor waste opening and install toilet on closet TIP: Place 2 pieces of masking waste flange (horn), with tapered end of ring

Resumen del contenido incluido en la página 3

9 10 SEE STEP 10 Rod Adjustment SEE STEP 11 REFILL NIPPLE IMPORTANT: REFILL TUBE Refill Float Adjustment If short flush does not refill the bowl, turn thumbscrew CCW 1 turn, flush, repeat if necessary. FLOAT CUP HALF 16 14 12 Install and adjust push 10 8 button rods for about 6 Turn on water supply. 4 1/16" (1-1/2mm) 2 Submerge the FLOAT CUP FILL clearance between rod VALVE under the water for 30 seconds. end and valve button. Adjust the water to desired level VALVE SEE STEP 11 - TIP

Resumen del contenido incluido en la página 4

13 TROUBLESHOOTING IF FILL VALVE SHUTS OFF BUT CONTINUES TO LEAK SLOWLY, repeat Step 13. IF FILL VALVE TURNS OFF AND ON DURING PERIODS OF NON-USE, it is a signal you are wasting water because: � The end of the refill tube is inserted into overflow pipe, below LIFT ARM water level in tank. Attach refill tube to overflow pipe using FIRST "S" clip provided. � The flush valve is leaking because it's worn, dirty or misaligned with tank ball or flapper (replace with a new flapper). I