Manual de instrucciones de Arboria Longevity

Resumen del contenido incluido en la página 1

ASSEMBLY INSTRUCTIONS

10
Longevity Arbor
PLEASE READ COMPLETELY BEFORE YOU BEGIN ASSEMBLY
CHECK BOX FOR THESE CONTENTS
Trellis Caps (16)
1
Headers (2)
2
Braces (4)
3
Lattice Side Panels (2)
4

HARDWARE
- 1” Wood screws (32)
- 2” Wood screws (16)
- 2 1/2” Wood screws (8)
- Anchoring kit.
- Brass medallion and nails (2)

TOOLS YOU WILL NEED
• Phillips screwdriver (electric driver recommended)
• Small hammer
• Two bags of concrete mix (60#) to anchor the arbor
HAN

Resumen del contenido incluido en la página 2

Page 2 CONNECTING THE MEDALLIONS TO THE HEADERS STEP 1 We recommend installing the medallion on the header prior to final assembly. Needle nose pliers can be help- ful in holding the 1/2” nail. 1 CONNECTING THE BRACES TO THE HEADER STEP 2 Install all 4 braces on the ends of the headers 2 ” screws into the pre-drilled holes using 2” screws. Important note: Placing screws into pre-drilled holes ensures proper align- ment of side panels. 2 CONNECTING THE SIDE PANEL TO THE HEAD

Resumen del contenido incluido en la página 3

Page 3 TURNING THE ARBOR 180 DEGREES TO ATTACH SECOND HEADER STEP 4 After attaching the first header to the side panels, Turn the assembly over by lifting the sides and moving backward. Then, turn and lower the arbor over the second header. Attach the second header following the same method as the first header. 4 BLOCKING Support the arbor with a block or other item to allow clearance for the STEP 5 attachment of the trellis caps. Block ATTACH THE CAPS TO THE HEADERS Insta

Resumen del contenido incluido en la página 4

INSTALLING THE ARBOR LWO Corporation 3841 N. Columbia Blvd. Portland, Oregon 97217 (503) 286-5372 (800) 459-8718 www.arboria.com