Resumen del contenido incluido en la página 1
®
Owner's Manual with Assembly Instructions
Please read this manual and save it with your original sales receipt.
For Model 74180
Tools needed for assembly: Phillips Screwdriver, Safety Scissors and Hammer.
® ®
Use only with a Power Wheels Type H 6 Volt Battery, Power Wheels Thermal Fuse and Power
®
Wheels Type H 6 Volt Charger (all included).
Resumen del contenido incluido en la página 2
Table of Contents A Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .2 B Warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .3 C Parts . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Resumen del contenido incluido en la página 3
Warnings B WARNING • Children can be harmed by small parts, sharp edges and sharp points in the vehicle’s unassembled state, or by electrical items. Care should be taken in unpacking and assembly of the vehicle. Children should not handle parts, including the battery, or help with assembly of the vehicle. • Keep small parts and plastic bags out of children’s reach. Dispose of plastic bags properly. • Adult supervision is required. Children do not have the judgement necessary to avoid many accide
Resumen del contenido incluido en la página 4
Parts C • If you experience a problem with this product, or are missing a part, please call us at 1-800-348-0751, rather than return this product to the store. • Please identify all parts before assembly and save all packaging material until assembly is complete to ensure that no parts are discarded. • Metal parts have been coated with a lubricant to protect them during shipment. Wipe all metal parts with a paper towel to remove any excess lubricant. Wheel - 2 TM Vehicle Body Skid Guard Driver -
Resumen del contenido incluido en la página 5
Parts Round Bushing - 3 6 Volt Battery 6 Volt Charger Thermal Fuse Hex Bushing - 2 Wire Retainer -4 #8 x 1" Screw - 12 1 7 #12 x 1 /2" Screw 5 /16" (Large Diameter) 16 / " (Small Diameter) Washer - 2 Washer - 2 .437 (Large Diameter) Cap Nut - 4* .354 (Small Diameter) Cap Nut - 4* All Shown Actual Size *For your convenience, four extra cap nuts have been included; two .354 and two .437. 5 ® IMPORTANT A 25 AMP FUSE MUST BE INSTALLED IN TOP OF BATTERY BEFORE TOY WILL RECHARGE OR OPERATE
Resumen del contenido incluido en la página 6
OR OPERATE BO E TF B OY W S ATTE A ILLR R Y B EC E H FO AR R P G E E A 25 IN AMP T F LLE USE D IN MU TO ST IMPORTANT ® Parts Diagram D 8 12 12 17 11 20 20 19 3 3 7 6 14 10 23 14 10 2 13 20 22 22 23 20 TM 1 20 9 12 9 9 21 12 20 16 20 9 15 20 18 8 17 17 18 5 4 5 1. Vehicle Body 11. Seat 18. / " (Small Diameter) Washer - 2 16 2. Long Axle 12. Retainer Straps - 2 Sets 19. Thermal Fuse 3. Wheel - 2 (Seat Belt and Battery) 20. #8 x 1" Screw - 12 4. Pivot Wheel 13. 6 Volt Battery 21. Skid Guard 7 5. P
Resumen del contenido incluido en la página 7
Battery Charging E CAUTION WARNING Use the charger indoors only. • The battery must be handled by adults only. The battery is heavy and contains sulfuric acid (electrolyte). Dropping the Important Notes: battery could result in serious injury. • Your new battery must be charged for at least 18 • Never allow children to charge the hours before you use it in your vehicle for the first battery. Battery charging must be done time. by adults only. A child could be injured • We recommend that you star
Resumen del contenido incluido en la página 8
Battery Charging Thermal Fuse 3 1 • If you are charging the battery for the first time, insert a thermal fuse into the battery. The battery will not charge unless a thermal fuse is installed. • If you are recharging your battery, make sure the thermal fuse already installed in the battery is in good condition. • Plug the charger into a standard 120 volt wall outlet. Remove the fuse from the battery and shake it gently. If it Note: If power flow to the wall outlet is controlled by a rattles, it i
Resumen del contenido incluido en la página 9
Assembly F Round Bushing 3 1 Wire Retainer Screw Peg Hole Vehicle Rear View Body • Position the vehicle body upright. • Fit and hold a round bushing into the hole in the rear of the vehicle body. Metal Bracket 2 Large Hole Screw Bottom View Slot Peg 3a 3b 3c Square Opening Tab Attaching Wire Retainer Twisting Wire Retainer Correctly Wire Retainer to Screw Peg Twisted Vehicle • Fit a #8 x 1" screw through a wire retainer and into the Body Bottom View screw peg at the center of the vehicle body.
Resumen del contenido incluido en la página 10
Assembly 4 6 Wire Retainer Long Axle Screw Peg Bottom View .437 Cap Nut • Fit a #8 x 1" screw through a wire retainer and into the screw peg at the left side of the vehicle body, near the wire connectors. The square opening in the wire retainer • Fit a .437 (large diameter) cap nut onto one end of the should fit onto the tab on the screw peg. long axle. • Tighten the screw with a Phillips screwdriver. Do not • Tap the other end of the long axle with a hammer to over-tighten. secure the cap nut o
Resumen del contenido incluido en la página 11
Assembly Gearbox Temporary Wheel Retainer 8 10 Driver Long Strap Driver Axle Hex CUT Bushing 7 /16" Washer HERE Long Gearbox Axle 7 .437 /16" Washer Cap Temporary Retainer Strap Nut Wheel CUT HERE Bottom View 7 • Fit a /16" (large diameter) washer onto the end of the Bottom View long axle. • Fit a driver (ring side out) onto the end of the axle. The driver may need to be rotated so that it fits onto the teeth on the gearbox. • While carefully holding a gearbox in place, cut and • Fit a large
Resumen del contenido incluido en la página 12
Assembly • Fit the skid guard under the vehicle body with the .354 Cap Nut pegs on the skid guard aligned with the holes in the vehicle body floor. 12 • Insert four #8 x 1" screws through the vehicle body floor and into the skid guard. Metal • Tighten the screws with a Phillips screwdriver. Do not Hole Bracket over-tighten. 14 Left Vehicle Hole Right Shifter Body 5 Shifter / " Washer 16 Pivot Axle Pivot Wheel (Long Leg) Assembly Rear View • Position the vehicle body upright. 5 • Fit a / " (
Resumen del contenido incluido en la página 13
Assembly • Insert the end T-loops on the strap through a slot in the battery compartment. Do not insert the second set of T-Loops T-loops through the slots. 15 • Pull up gently on the each end of the strap to make sure the end T-loops are secure in the slots. T-Loops Retainer Straps Slot Slot Tabs 17 Seat Slots Slots Tabs Front View Please note: The seat has been factory assembled. You will need to remove the seat to complete assembly steps 15 - 17. Please see Step 1 on page 15 for instructions
Resumen del contenido incluido en la página 14
TO OR Y O W PILL ER R ATE ECHARGE B O E F IN BA STTE TALLE RYD B IN EF TO ORP E A 25 IMPORT AMP FU ANT SE MUST Label Decoration G Proper label application will help to keep the labels looking their best! 4 • Wash you hands before applying the labels. • Make sure the areas where the labels will be applied are clean and dry. Wipe your vehicle with a clean, soft, dry cloth to remove any dust or oils. • For best results, avoid repositioning a label once it has been applied to the vehicle. • Apply t
Resumen del contenido incluido en la página 15
OR OPERATE BE INST OF BA TOY W TTER ILL ALLED IN RECHARGE Y BEFORE TOP A 25 AMP FUSE MUST OR OPERATE OF BA TOY W TTER ILL RECHARGE Y BEFORE A BE INST 25 AMP ALLED IN FUSE MUST TOP IMPORTANT IMPORTANT IMPORTANT T OR OPERA OY WILL RECHARGE TE BE INST OF BATTER ALLED IN Y BEFORE TOP A 25 AMP FUSE MUST IMPORTANT OR OPERATE OF BA TOY WILL TTER RECHARGE Y BEFORE A BE INST 25 AMPALLED IN FUSE MUST TOP ® Battery Installation H ® Important Note: Use only a Power Wheels Type H 6 volt Motor ® battery wi
Resumen del contenido incluido en la página 16
Battery Care Rules For I J and Disposal Safe Driving Care If a battery leak develops, avoid contact with the leaking WARNING acid and place the damaged battery in a plastic bag. See information below for proper disposal. • Adult supervision is required. Children If acid comes in contact with skin or eyes, flush with cool water for at least 15 minutes and call a physician. do not have the judgement necessary to If acid is internally ingested, give water, milk of magnesia avoid many accidents.
Resumen del contenido incluido en la página 17
IMPORTANT OR OPERATE OF BA TOY WILL TTER RECHARGE Y BEFORE A BE INST 25 AMP ALLED IN FUSE MUST TOP Rules For Safe Driving 6. Always wear shoes or sneakers when operating Teach Safety Rules to Children this vehicle. While children can quickly develop the skill necessary to 7. Never put anything near any moving parts. Rotating drive this vehicle, it is important to remember that their parts such as motors, gear boxes and wheels can judgement skills are still very immature. Unsupervised snag fin
Resumen del contenido incluido en la página 18
OR OPERATE OF BA TOY W TTER ILL RECHARGE Y BEFORE A BE INST 25 AMP ALLED IN FUSE MUST TOP TO OR OPERA Y WILL RECHARGE TE T OR OPERA OY WILL RECHARGE TE A BE INST OF BA 25 AMP TTER ALLED IN FUSE MUST Y BEFORE TOP BE INST OF BATTER ALLED IN Y BEFORE TOP A 25 AMP FUSE MUST IMPORTANT IMPORTANT IMPORTANT How to Operate Your Vehicle K Your vehicle has been designed with a REVERSE LOCK-OUT system and has been pre-set to drive forward only. The vehicle will not drive in reverse or spin until you faste
Resumen del contenido incluido en la página 19
Statement of Caring for L M Limited Warranty Your Vehicle • Check all screws, retainers and protective coverings 90-day limited warranty for the Power ® regularly and tighten as required. Check plastic parts on Wheels Ride-On Toy Vehicle a regular basis for cracks or broken pieces. A 6-month battery warranty applying only to • During snowy or rainy weather, the vehicle should be the 6 volt battery which was included by ® ® stored inside or under a protective cover. Remember to Power Wheels , wi
Resumen del contenido incluido en la página 20
Problems and Solutions Guide N IMPORTANT! If you experience a problem with your vehicle, first check the Problems and Solutions Guide below. If you ® still experience a problem, please contact Power Wheels Consumer Affairs, toll-free at 1-800-348-0751 between 8 AM ® and 6 PM (EST) Monday through Friday. Or, contact your local Power Wheels authorized service center. For the location nearest you, please refer to the Authorized Service Center list beginning on page 24. Problem Possible Cause Soluti
