Manual de instrucciones de Human Touch Massage Chairs

Resumen del contenido incluido en la página 1

July 17, 2012
REPLACING THE CONTROLLER
™
ZeroG 2.0
®
It is imperative that Human Touch products are repaired in a manner that ensures product safety and regulatory compliance and that is fully consistent with the practices used
during the manufacturing process. Therefore, Human Touch requires that all product repairs are performed using only factory-new parts and in accordance with these repair SERVICE LEVEL: 2
instructions. Failure to adhere to these instructions voids the product warranty and

Resumen del contenido incluido en la página 2

INSTALLING THE NEW CONTROLLER 1. Feed the controller cable through the cable guide on the chair, and then through the front of the power panel. 2. Connect the controller cable connector to the corresponding connector on the chair. 3. Secure the controller cord to the chair cable harness in the same location in which it was secured previously, using a new zip tie. 4. Replace the two screws to secure the controller cord to the outside of the power panel. 5. Place the power panel into positio