Manual de instrucciones de Seagate BARRACUDA 5400.1 ST340015A

Resumen del contenido incluido en la página 1

Jumper settings for this drive are shown below
Drive is master
or single drive
Drive is slave
Use cable select
Barracuda 5400.1 Installation Guide
ST340015A and ST340015ACE
Drive is master with non-
ATA-compatible slave
ATA Interface Disc Drives
Master/slave jumpers (see table for key to jumper settings)
Publication Number: 100264272, Rev. C, November 2003
2. Mount the drive and attach cables
The easiest way to install your drive
a. Slide the drive into a 3.5-inch drive bay. You can mount th

Resumen del contenido incluido en la página 2

of this sheet. are installed correctly. 4. Partition and format the drive 2. Does the computer recognize the drive? Make sure the master/ slave jumpers are set correctly on all installed hard drives. Verify that Before your new drive can store data, it must be partitioned (assigned one the drive is detected by the system CMOS or Setup program. or more drive letters) and each partition must be formatted. You can parti- tion and format the drive using DiscWizard or using programs built into 3. Doe