Resumen del contenido incluido en la página 1
TOSHIBA AMERICA INFORMATION SYSTEMS
STORAGE DEVICE DIVISION
IRVINE, CALIFORNIA
SD-C2712
DVD-ROM MOBILE DRIVE
USER MANUAL
Resumen del contenido incluido en la página 2
CONTENTS Introduction..............................................................................1 Setup ........................................................................................3 Using the DVD-ROM ................................................................4 Troubleshooting.......................................................................6 Specifications ..........................................................................7 Drive Connectors...............
Resumen del contenido incluido en la página 3
INTRODUCTION – SD-C2712 General Features 100ms Average Access Time (DVD) RPC2 Compliant Drawer Type Manual Load/ Electrical Release DVD-R, DVD-RW, DVD-RAM, CD-R and CD-RW Compatible Drive Speed DVD 8X DVD-R/RW 4X CD-ROM 24X DVD-RAM 2X BUS Interface ATAPI Types of Disc Formats Supported – DVD-ROM DVD-5 (single-sided, single layered) DVD-9 (singled-sided, double layered) DVD-10 (double-sided, single layered) DVD-18 (double-sided, double layered DVD-R (Ver 1.0 & 2.1)
Resumen del contenido incluido en la página 4
Eject Button The EJECT button is used to open the disc tray so you can install or remove a disc Busy Indicator When you install a disc into the DVD-ROM drive, the BUSY light flashes slowly as it attempts to locate the disc. One of the following will occur: • BUSY light goes out. The DVD-ROM drive is ready to read data from the disc. • BUSY light flashes slowly. The disc may be dirty. • BUSY light remains ON. The DVD-ROM is accessing data. • BUSY light remains ON indefinitely. The DVD
Resumen del contenido incluido en la página 5
SETUP – SD-C2712 Toshiba recommends that only trained professionals install this DVD-ROM drive into your laptop/notebook. Installation Notes • The SD-C2712 DVD-ROM drive has no jumpers that need to be set • Mounting orientation: 15° (horizontally), 15° vertically (volume control in down position), 30° (drive with volume control in up position). • When mounting drive use 4 M2-PO.4 tapping holes located on the left and right sides of drive. • When mounting drive, the tightening tor
Resumen del contenido incluido en la página 6
USING THE DVD-ROM Drive – SD-C2712 Drive Operation Inserting Media – Horizontally or Vertically To insert a DVD in a DVD-ROM drive that is mounted horizontally, perform the following steps: Figure 1.Inserting Disc 1. Open the drive's loading tray by pressing the Eject Button and pulling out the tray. 2. Place media disc into drive's loading tray, and lightly press down on the inner portion of the disc. 3. Gently close the disc tray. Removing Media To remove media disc from
Resumen del contenido incluido en la página 7
Regional Coding Region Protection Coding (RPC) of DVD Discs: this feature is supported on DVD Players and is used with DVD-Video Discs (i.e. movies). Currently, the motion picture industry has divided the world into different regional "zones." These regions or "zones" correlate to the regional markets into which the motion picture industry releases movies. Simply put, RPC Codes are placed on Movie Discs marketed throughout the world based on the region of the world where they are being so
Resumen del contenido incluido en la página 8
TROUBLESHOOTING – SD-C2712 Problem Solution Disc tray cannot be opened • Check that there is power to drive. • Use Emergency Eject instructions to open tray. Drive is not recognized by • Is the drive connected properly? Are all cables plugged in system properly (e.g. Power Cable, Interface Cable and Audio Cables). • Is the software driver loaded? On a step-by-step (F8) Boot of the system is the DVD-ROM drive recognized? (BIOS / DOS reports "device driver not found" or "no val
Resumen del contenido incluido en la página 9
SPECIFICATIONS –SD-C2712 General Interface: ATAPI Compatible DVD-ROM Standard - Read: DVD: DVD-ROM (DVD-5, DVD-9, DVD-10, DVD-18) DVD-R (ver 1.0 & 2.0, read) DVD-RW (ver 1.1, read) DVD-RAM (ver 1.0 & 2.1, read) CD-ROM: CD-DA, CD+(E)G, CD-MIDI, CD-TEXT, CD-ROM, CD-ROM XA, MIXED MODE CD, CD-I, CD-I Bridge (Photo-CD, Video-CD), Multi-session (Photo CD Disc, CD-Extra, CD-R, CD-RW), CD-RW (read), CD-R (read) Note: All DVD/CD formats, except CD-Red Book (audio), require additional a
Resumen del contenido incluido en la página 10
Transfer Rate DVD (Single) 4,463 - 10,816 Kbytes/s DVD (Dual) 3,380 - 8,112 Kbytes/s DVD-R/-RW 2,298 - 5,408 Kbytes/s DVD+R/+RW 2,298 - 5,408 Kbytes/s DVD-RAM (Ver 2.1) 2,704 Kbytes/s CD (mode 1) 1,552 - 3,600 Kbytes/s CD (mode 2) 1,761 - 4,104 Kbytes/s Rotational Speed DVD single layer: 4,670rpm (3.3X – 8X) DVD dual layer: 3,792rpm (2.5X – 6X) DVD-R (Ver 1.0) 2,560rpm (1.7X – 4X) DVD-R (Ver .1.2) 2,224rpm (1.7X – 4X) DVD-RW: 2,224rpm (1.7X – 4X) DVD+R/+RW 2,224rpm (1.7X –
Resumen del contenido incluido en la página 11
Environmental Ambient Temperature Operating 5° to 50° C (41° to 122° F) Storage -20° to 65° C (4° to 149° F) Shipping -40° to 65° C (-40° to 149° F) Relative Humidity Operating 8% to 80% Storage/Shipping 5% to 95% (wet bulb 40° C max) Acoustical Noise 40dB Power DC Voltage and Current Requirements +5V ±5% (Operating), 8% (start-up) Physical Height 0.5" (12.7mm) Width 5.04" (128mm) Depth 4.96" (126.1mm) Weight 6.0oz (0.17kg) Connectors IDE Interface Connector 50
Resumen del contenido incluido en la página 12
Drive Connectors –SD-C2712 Figure 1.SD-C2712 DVD Writeable Drive Rear Panel – Connector ATAPI A 50-pin ATAPI interface connector is found at the rear of the SD-C2712 DVD-ROM drive. Connecting cable should use Japan Aviation Electronics Industry Limited KX14-50Series L Connector or equivalent connector. Table 1.Interface Pin Assignments PIN I/O SIGNAL NAME PIN I/O SIGNAL NAME NO. NO. 1 O Audio L-CH 2 O Audio R-CH 3 Audio Ground 4 Digital Ground 5 I /RESET 6 I/O DD8 7 I/
