Manual de instrucciones de Transcend Information TS2G-8GCF266

Resumen del contenido incluido en la página 1

TS2G~8GCF266
TS2G~8GCF266 266X CompactFlash Card
TS2G~8GCF266

Features
Description
• CompactFlash Specification Version 4.1 Complaint
The Transcend CF 266X is a High Speed Compact
• RoHS compliant products
Flash Card with high quality Flash Memory assembled
• Single Power Supply: 3.3V ± 5% or 5V ± 10%
on a printed circuit board.
o o

• Operating Temperature: -25 C to 85 C
•
Operation Modes:
Placement

PC Card Memory Mode

PC Card IO Mode

Resumen del contenido incluido en la página 2

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266 Transcend Transcend Information Inc. 2

Resumen del contenido incluido en la página 3

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266 Block Diagram Transcend Information Inc. 3

Resumen del contenido incluido en la página 4

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266 Pin Assignments and Pin Type Transcend Information Inc. 4

Resumen del contenido incluido en la página 5

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266 Note: 1) These signals are required only for 16 bit accesses and not required when installed in 8 bit systems. Devices should allow for 3-state signals not to consume current. 2) The signal should be grounded by the host. 3) The signal should be tied to VCC by the host. 4) The mode is optional for CF+ Cards, but required for CompactFlash Storage Cards. 5) The -CSE

Resumen del contenido incluido en la página 6

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266 Signal Description Transcend Information Inc. 6

Resumen del contenido incluido en la página 7

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266 Transcend Information Inc. 7

Resumen del contenido incluido en la página 8

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266 Transcend Information Inc. 8

Resumen del contenido incluido en la página 9

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266 Transcend Information Inc. 9

Resumen del contenido incluido en la página 10

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266 Transcend Information Inc. 10

Resumen del contenido incluido en la página 11

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266 Electrical Specification The following tables indicate all D.C. Characteristics for the CompactFlash Storage Card. Unless otherwise stated, conditions are: Vcc = 5V ±10% Vcc = 3.3V ± 5%  Absolute Maximum Conditions  Input Power  Input Leakage Current Input Characteristics  Transcend Information Inc. 11

Resumen del contenido incluido en la página 12

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266  Output Drive Type  Output Drive Characteristics  Transcend Information Inc. 12

Resumen del contenido incluido en la página 13

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266  Signal Interface Transcend Information Inc. 13

Resumen del contenido incluido en la página 14

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266 Notes: 1) Control Signals: each card shall present a load to the socket no larger than 50 pF 10 at a DC current of 700 μ A low state and 150 μ A high state, including pull-resistor. The socket shall be able to drive at least the following load 10 while meeting all AC timing requirements: (the number of sockets wired in parallel) multiplied by (50 pF with DC current 700 μ A low state and 150 μ A hi

Resumen del contenido incluido en la página 15

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266  Ultra DMA Electrical Requirements  Host and Card signal capacitance limits for Ultra DMA operation The host interface signal capacitance at the host connector shall be a maximum of 25 pF for each signal as measured at 1 MHz. The card interface signal capacitance at the card connector shall be a maximum of 20 pF for each signal as measured at 1 MHz.  Series termination required for Ultra DMA

Resumen del contenido incluido en la página 16

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266 Table: Ultra DMA Termination with Pull-up or Pull down Example  Printed Circuit Board (PCB) Trace Requirements for Ultra DMA On any PCB for a host or device supporting Ultra DMA:
The longest D[15:00] trace shall be no more than 0.5" longer than either STROBE trace as measured from the IC pin to the connector.
The shortest D[15:00] trace shall be no more

Resumen del contenido incluido en la página 17

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266  Attribute Memory Read Timing Specification Transcend Information Inc. 17

Resumen del contenido incluido en la página 18

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266  Configuration Register (Attribute Memory) Write Timing Specification Transcend Information Inc. 18

Resumen del contenido incluido en la página 19

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266  Common Memory Read Timing Specification Transcend Information Inc. 19

Resumen del contenido incluido en la página 20

TS2G~8GCF266 TS2G~8GCF266 266X CompactFlash Card TS2G~8GCF266  Common Memory Write Timing Specification Transcend Information Inc. 20