Resumen del contenido incluido en la página 1
R
P/I-AP55TV
All-In-One Pentium Motherboard
USER'S MANUAL
Resumen del contenido incluido en la página 2
USER'S NOTICE No part of this product, including the product and software may be reproduced, transmitted, transcribed, stored in a retrieval system, or translated into any lan- guage in any form by any means without the express written permission of ASUSTeK COMPUTER INC. (hereinafter referred to as ASUS) except documentation kept by the purchaser for backup purposes. ASUS provides this manual "as is" without warranty of any kind, either express or implied, including but not limited to the implie
Resumen del contenido incluido en la página 3
ASUS CONTACT INFORMATION ASUSTeK COMPUTER INC. Marketing Info: Address: 150 Li-Te Road, Peitou, Taipei, Taiwan, ROC Telephone: 886-2-894-3447 Fax: 886-2-894-3449 Email: info@asus.com.tw Technical Support: Fax: 886-2-895-9254 BBS: 886-2-896-4667 Email: tsd@asus.com.tw WWW: http://www.asus.com.tw/ Gopher: gopher.asus.com.tw FTP: ftp.asus.com.tw/pub/ASUS ASUS COMPUTER INTERNATIONAL Marketing Info: Address: 721 Charcot Avenue, San Jose, CA 95131, USA Telephone: 1-408-474-0567 Fax: 1-408-474-0568 Ema
Resumen del contenido incluido en la página 4
CONTENTS I. INTRODUCTION........................................................................... 1 How this manual is organized ..................................................................... 1 Item Checklist ............................................................................................. 1 II. FEATURES .................................................................................... 2 Features of the ASUS Motherboard ...................................................
Resumen del contenido incluido en la página 5
CONTENTS VI. Microsoft Windows 95 ................................................................53 Video Driver Installation ........................................................................... 53 Video Driver Installation ........................................................................... 54 Video Driver Installation ........................................................................... 55 Video Driver Installation ..........................................................
Resumen del contenido incluido en la página 6
FCC & DOC COMPLIANCE Federal Communications Commission Statement This device complies with FCC Rules Part 15. Operation is subject to the following two conditions: • This device may not cause harmful interference, and • This device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provid
Resumen del contenido incluido en la página 7
I. INTRODUCTION How this manual is organized This manual is divided into the following sections: I. Introduction: Manual information and checklist II. Features: Information and specifications concerning this product III. Installation: Instructions on setting up the motherboard. IV. BIOS Setup: BIOS software setup information. V. DMI Utility: BIOS supported Desktop Management Interface VI. VGA Drivers: ATI VGA Drivers and Utilities Item Checklist Please check that your package is complete. If y
Resumen del contenido incluido en la página 8
II. FEATURES (Features) II. FEATURES Features of the ASUS Motherboard The ASUS P/I-AP55TV is specially designed for the demanding PC user who wants a high-performance multi-media motherboard in a single package. This motherboard: • Easy Installation: Is equipped with BIOS that supports auto detection of hard drives, PS/2 mouse, and Plug and Play devices to make setup of hard drives, expansion cards, and other devices virtually automatic. • Multi-Processor/Multi-Speed Support: Supports one P
Resumen del contenido incluido en la página 9
II. FEATURES • Optional IrDA Connector: Supports an optional infrared port module for wire- less interface. • NCR SCSI BIOS: Has firmware that supports the optional ASUS PCI-SC200 SCSI controller cards. Parts of the ASUS Motherboard PS/2 PS/2 Monitor Parallel COM 2 Mouse Keyboard COM 1 Audio Port USB Connector (Reserved) Multi-I/O & RTC Riser Slot AMC Connector Floppy Connector Programmable Flash ROM IDE Connectors Audio Wave Table Upgrade (4) 72-pin SIMM DRAM Sockets Intel's 430VX PCIset CPU
Resumen del contenido incluido en la página 10
P8 P9 SIMM Socket 4 (Bank 1) Board Power Input SIMM Socket 3 (Bank 1) SIMM Socket 2 (Bank 0) SIMM Socket 1 (Bank 0) JP14 JP15 JP16 Secondary IDE Primary IDE Floppy Drives Raiser Card Connector JP20 JP21 JP22 JP23 JP24 Wave Table Upgrade JP25 JP26 JP18 JP19 Case Connectors 256/512KB OnBoard L2 Cache IDE LED Infrared Con. AMC Connector Pipelined Burst Level 2 Cache Expansion Slot III. INSTALLATION (Map of Board) III. INSTALLATION Map of the ASUS Motherboard PS/2 PS/2 VGA Output Parallel Connector
Resumen del contenido incluido en la página 11
III. INSTALLATION Jumpers 1) JP6 p. 7 Flash ROM Boot Block Program (Enable/Disable) 2) JP5A p. 7 Clear CMOS Data / Battery Test Jumper 3) JP17 P. 8 Total L2 Cache Size (512KB / 256KB) 4) JP4A p. 9 Audio Selection (Enabled/Disabled) 5) VOL_CON p. 9 Digital Volume Control (Up / Down) 6) JP14, 15, 16 p. 10 CPU External Clock (BUS) Frequency Selection 7) JP18, 19 p. 10 CPU:BUS Frequency Ratio 8) JP20-26 p. 11 Voltage Regulator Output Selection Expansion Slots 1) SIMM Sockets p. 11 DRAM Memory Expans
Resumen del contenido incluido en la página 12
III. INSTALLATION (Jumpers) III. INSTALLATION Installation Steps Before using your computer, you must follow the six steps as follows: 1. Set Jumpers on the Motherboard 2. Install DRAM Modules 3. Install the CPU 4. Install Expansion Cards 5. Connect Cables, Wires, and Power Supply 6. Setup the BIOS Software 1. Jumpers Several hardware settings are made through the use of jumper caps to connect jumper pins (JP) on the motherboard. See "Map of the Motherboard" on page 4 for loca- tions of jumper
Resumen del contenido incluido en la página 13
III. INSTALLATION Jumper Settings 1. Flash ROM Boot Block Programming (JP6) This sets the operation mode of the boot block area of the BIOS Flash ROM to allow programming in the Enabled position. Programming JP6 Disabled [1-2] (Default) Enabled [2-3] JP6 JP6 1 1 2 2 3 3 Disabled / Protected Enabled (Default) Boot Block Programming (Disable / Enable) 2. Clear CMOS Data / Battery Test Jumper (JP5A) The CMOS RAM is powered by the onboard button cell battery. You can test the battery’s current by
Resumen del contenido incluido en la página 14
III. INSTALLATION (Jumpers) III. INSTALLATION 3. Total Level 2 Cache Size Setting (JP17) This jumper sets the total amount of L2 cache that is present. If you have two cache chips onboard (see "Map of Motherboard" for locations), then you have 256KB. A cache module can be used to upgrade the 256KB version to 512KB. If there is no onboard cache, you may install a cache module of either 256KB or 512KB. IMPORTANT: See page 14 "SRAM Cache" for installation proce- dures. Regardless of your cac
Resumen del contenido incluido en la página 15
III. INSTALLATION 4. Onboard Audio Selection (JP4A) This jumper allows you to Disable the onboard audio chipset inorder to use your own audio card. Otherwise, leave on default of Enabled. Onboard Audio JP4A Enabled [1-2] (Default) Disabled [2-3] JP4A JP4A 1 1 2 2 3 3 Enabled Disabled (Default) Onboard Audio Selection (Enable / Disabled) 5. Onboard Digital Audio Control (VOL_CON) This jumper allows you to adjust the audio volume digitally using case mounted momentary buttons. Audio Control VOL_
Resumen del contenido incluido en la página 16
JP18 JP19 JP18 JP19 JP18 JP19 JP18 JP19 III. INSTALLATION (Jumpers) JP14 JP15 JP16 JP14 JP15 JP16 JP14 JP15 JP16 JP14 JP15 JP16 III. INSTALLATION 6. CPU External (BUS) Frequency Selection (JP14, JP15, JP16) These jumpers tell the clock generator what frequency to send to the CPU. These allow the selection of the CPU’s External frequency (or BUS Clock). The BUS Clock times the BUS Ratio equals the CPU's Internal frequency (the advertised CPU speed). 7. CPU to BUS Frequency Ratio (JP18, JP19)
Resumen del contenido incluido en la página 17
JP20 STD JP21 VRE JP22 2.8V JP23 2.7V JP24 2.9V JP25 2.5V JP26 Res. III. INSTALLATION Compatible Cyrix CPU Identification The Cyrix CPU that is supported on this motherboard is la- beled Cyrix 6x86 P166+ but must be Revision 2.7 and later. Look on the underside of the CPU for the serial number. The number should read G8DC6620A or larger. 8. Voltage Regulator Output Selection (JP20-JP26) These jumpers set the voltage supplied to the CPU. Determine whether your CPU has a single power plane or du
Resumen del contenido incluido en la página 18
III. INSTALLATION (DRAM Memory) III. INSTALLATION 2. System Memory (DRAM & SRAM) This motherboard supports four 72-pin SIMMs (Single Inline Memory Modules) of 4MB, 8MB, 16MB, or 32MB to form a memory size between 8MB to 128MB. The DRAM can be either 60ns or 70ns Fast Page Mode (FPM) (Asymmetric or Symmet- ric) or Enhanced Data Output (EDO). SIMMs must be installed in pairs so that each bank contains two of the same size memory modules. Maximum memory size of SIMM’s must be 128MB or less. IM
Resumen del contenido incluido en la página 19
III. INSTALLATION DRAM Memory Installation Procedures: 1. The SIMM memory modules will only fit in one orientation as shown because of a "Plastic Safety Tab" on one end of the SIMM slots which requires the "Notched End" of the SIMM memory modules. 1234 DRAM Memory Module Example Notched End Bank 0 Bank 1 72 Pin SIMM DRAM Sockets 2. Press the memory module firmly into place starting from a 45 degree angle making sure that all the contacts are aligned with the socket. 3. With your finger tips, roc
Resumen del contenido incluido en la página 20
III. INSTALLATION (External Cache) III. INSTALLATION Static RAM (SRAM) for Level 2 (External) Cache The motherboard you purchase may have either 0KB, 256KB, or 512KB onboard. If you have both onboard cache chips (see "Map of Motherboard" for locations) and a Cache Expansion Slot, then you have 256KB. If you only have onboard cache chips, then you have 512KB. An "ASUS" or "COAST" cache module can be used to upgrade the 256KB version to 512KB. If there is no onboard cache, you may install a ca
