Resumen del contenido incluido en la página 1
ª
R
29 Xtra 29 Xtra
R
Multimedia Monitor
User's Manual
1
R
29 Xtra 29 Xtra
NEC Technologies, Inc.
MultiSync is a registered trademark of NEC Technologies, Inc. in the U.S.A.
1250 N. Arlington Heights Road, Suite 500
Printed in Thailand
NEC is registered trademark of NEC Corporation.
1993 by NEC Technologies, Inc.
Itasca, Illinois 60143-1248
78410091
Resumen del contenido incluido en la página 2
DOC compliance Notice CAUTION This Class A digital apparatus meets all requirements of the Canadian RISK OF ELECTRIC SHOCK Interference-Causing Equipment Regulations. DO NOT OPEN CAUTION: TO REDUCE THE RISK OF ELECTRIC SHOCK, DO WARNING NOT REMOVE COVER. NO USER-SERVICEABLE This equipment has been tested and found to comply with the limits for PARTS INSIDE. REFER SERVICING TO QUALIFIED a Class A digital device, pursuant to Part 15 of the FCC Rules. These SERVICE PERSONNEL. limits are designe
Resumen del contenido incluido en la página 3
DOC avis de conformation ATTENTION Cet appareil numérigue de la classe A respecte toutes les exigences du RISQUE D’ELECTROCUTION Réglement sur le Matériel Brouilleur du Canada. NE PAS OUVRIR MISE EN GARDE: AFIN DE REDUIRE LES RISQUES D’ELECTRO- Mises en garde et précautions de sécurité CUTION, NE PAS DEPOSER LE COUVERCLE, IL Les moniteurs MultiSync Multimédia XP29 Xtra et XM29 Xtra de NEC ont été N’Y A AUCUNE PIECE UTILISABLE A L’INTERIEUR conçus et fabriqués pour assurer une longue durée de se
Resumen del contenido incluido en la página 4
unauthorized product modification, or failure to follow instructions supplied with LIMITED WARRANTY the product. NEC Multimedia Monitor Products • Repair or attempted repair by anyone not authorized by NECTECH. NEC Technologies, Inc.(hereafter NECTECH)warrants this product to be free from • Any shipment of the product (claims must be presented to the carrier). defects in material and workmanship under the following terms. • Removal or installation of the product. HOW LONG IS THE WARRANTY • Any o
Resumen del contenido incluido en la página 5
CONTENTS 1. Introduction Introduction to the MultiSync XP29 Xtra/XM29 Xtra .............................................................. 1 Feature Highlights ...................................................................................................................... 1 2. Part Names and Functions Front View / Rear View ............................................................................................................. 3 Terminal Board ..........................................
Resumen del contenido incluido en la página 6
1 OSM and IPM are trademarks of NEC Technologies, Inc. • Flexible inputs IBM PC/AT, PS/2, VGA, S-VGA, 8514/A and XGA are registered Connect up to four different inputs at once and switch among them trademarks of International Business Machines Corporation. with a touch of a button to seamlessly integrate information from a Apple and Macintosh are registered trademarks of Apple Computer, computer and VCR into one presentation. Inc. • Signal loop-through Microsoft is a registered trademark of Micr
Resumen del contenido incluido en la página 7
3 Part Names and Functions Front View Rear View PROCEED VIDEO 1 VIDEO 2 RGB 1 RGB 2/DTV EXIT POWER /STANDBY 2 9 8 7 6 5 4 3 1 SPEAKERS MUST HAVE VIDEO 1 RGB1 MORE THAN 5WATT RATING PC / EXT CTL IMPEDANCE 8 OHM BNC S DIP SW REMOTE 75 AUDIO 75 EXT SPEAKERS ON IN RIGHT LEFT IN R L(MONO) IN HIGH IN HIGH 1 2 3 4 5 6 7 8 THROUGH THROUGH THROUGH OUT OUT OUT OUT SPEAKER SELECT VIDEO 2 RGB AUDIO RGB 2 BNC S R/CR/PR G/Y/Y B/CBPB HV INT EXT AUDIO 75 75 75 AC IN IN R L(MONO) R L(MONO) IN HIGH HIG
Resumen del contenido incluido en la página 8
5 Terminal Board AB D SPEAKERS MUST HAVE VIDEO 1 RGB1 PC / EXT CTL MORE THAN 5WATT RATING BNC S DIP SW REMOTE IMPEDANCE 8 OHM AUDIO 75 75 EXT SPEAKERS ON R L(MONO) IN RIGHT LEFT IN IN 1 2 3 4 5 6 7 8 HIGH HIGH IN THROUGH THROUGH THROUGH OUT OUT OUT OUT VIDEO 2 RGB AUDIO RGB 2 SPEAKER SELECT R/CR/PR G/Y/Y B/CBPB H/CS V BNC S INT EXT AUDIO 75 75 75 R L(MONO) R L(MONO) AC IN IN IN HIGH HIGH HIGH IN IN THROUGH THROUGH THROUGH THROUGH OUT OUT OUT OUT C A Speakers THROUGH OUT (BNC type) .....
Resumen del contenido incluido en la página 9
7 Terminal Board F SPEAKERS MUST HAVE VIDEO 1 RGB1 PC / EXT CTL MORE THAN 5WATT RATING BNC S DIP SW REMOTE IMPEDANCE 8 OHM AUDIO 75 75 EXT SPEAKERS ON IN R L(MONO) RIGHT LEFT IN IN 1 2 3 4 5 6 7 8 HIGH HIGH IN THROUGH THROUGH THROUGH OUT OUT OUT OUT VIDEO 2 RGB AUDIO RGB 2 SPEAKER SELECT R/CR/PR G/Y/Y B/CBPB H/CS V BNC S INT EXT AUDIO 75 75 75 AC IN R L(MONO) R L(MONO) IN IN HIGH HIGH HIGH IN IN THROUGH THROUGH THROUGH THROUGH OUT OUT OUT OUT EG E VIDEO 2 F RGB 1 (Mini D-Sub 15-pin) VIDE
Resumen del contenido incluido en la página 10
9 Terminal Board I J K SPEAKERS MUST HAVE VIDEO 1 RGB1 PC / EXT CTL MORE THAN 5WATT RATING BNC S DIP SW REMOTE IMPEDANCE 8 OHM AUDIO 75 75 EXT SPEAKERS ON R L(MONO) IN RIGHT LEFT IN IN 1 2 3 4 5 6 7 8 HIGH HIGH IN THROUGH THROUGH THROUGH OUT OUT OUT OUT VIDEO 2 RGB AUDIO RGB 2 SPEAKER SELECT R/CR/PR G/Y/Y B/CBPB H/CS V BNC S INT EXT AUDIO 75 75 75 R L(MONO) R L(MONO) AC IN IN IN HIGH HIGH HIGH IN IN THROUGH THROUGH THROUGH THROUGH OUT OUT OUT OUT H controlled by one remote control. H RGB
Resumen del contenido incluido en la página 11
11 Remote Control Unit NOTE: When not in use the remote control unit is conveniently stowed in the holder on the rear panel. 1 POWER ON/OFF Press POWER ON to turn the monitor on when the POWER/STANDBY POWER indicator is lit amber. DEGAUSS OFF ON 1 Press POWER OFF to turn the monitor off and the monitor will go into the 2 VIDEO 1 VIDEO 2 RGB 1 RGB 2 standby condition. 3 2 DEGAUSS POSITION/CONTROL PROCEED 5 Press to demagnetize the picture tube in the manual operation. See also EXIT page 27. 4 6
Resumen del contenido incluido en la página 12
13 Raster Control 7 WIDTH (+ / -) Adjusts the horizontal size of the image. 8 HEIGHT (+ / -) POWER Adjusts the vertical size of the image. DEGAUSS OFF ON 9 SIDE PIN (+ / -) VIDEO 1 VIDEO 2 RGB 1 RGB 2 Adjusts the curvature of the edges of the left and right side of the display POSITION/CONTROL PROCEED image either inward or outward. The image should be adjusted to attain a straight line on the left and right sides. EXIT 0 SCAN SELECT Each time this key is pressed, the picture size switches from
Resumen del contenido incluido en la página 13
15 Battery Installation and Replacement The remote control is powered by two 1.5V AA batteries. 1. Turn the remote control unit upside 2. Install the two new batteries, making 3. Close the battery compartment cover. sure that their polarity matches the (+) down. Press down on the battery compartment grip and slide the (-) diagrams inside the battery compartment. Incorrect polarity could compartment in the direction of the arrow. damage the remote control unit. Remote Control Cautions • Do not dr
Resumen del contenido incluido en la página 14
17 Functions and Settings of DIP SW Functions of DIP SW This DIP switch is used for Sync. Control, Intelligent Power Manager, External control, wireless control, and OSM control. To change a switch setting use a ON ON pointed object, such as a pen or pencil, to push the switch to the desired position. OFF 12 3 4 5 6 7 8 Set all the pins except No.7 to the OFF position during normal operation. The pins nos 2,3 and 5 are not used. Pin No 1(Sync. Control ) The No. 1 pin set Sync. Control. Set the
Resumen del contenido incluido en la página 15
19 Installation Macintosh or Wiring Diagram Compatibles IBM XGA/SuperVGA/VGA or Compatibles or Macintosh G3 series EXTERNAL CONTROL RGB Cable (supplied) To Mini D-SUB 15 Pin input Pin adapter for Macintosh (supplied) RGB Cable (supplied) To Mini D-SUB 15 Pin input To EXTERNAL CONTROL XP29 Xtra/XM29 Xtra (Mini D-SUB 15 Pin input) SPEAKERS MUST HAVE VIDEO 1 RGB1 MORE THAN 5WATT RATING PC / EXT CTL BNC S DIP SW REMOTE IMPEDANCE 8 OHM AUDIO 75 75 EXT SPEAKERS ON To R,G,B,H, V R L(MONO) IN RIGHT LE
Resumen del contenido incluido en la página 16
21 NOTE: The new Macintosh computer such as G3 will have the 15-pin HD Connecting Your PC or Macintosh Computer connector. Connecting your PC or Macintosh computer to your MultiSync XP29 Xtra/ The XP29 Xtra/XM29 Xtra’s “Plug and Play” data will be downloaded to XM29 Xtra will enable you to display your computer's screen image. All of the Macintosh. these following display standards are supported: Therefore, the pin adapter will not be necessary. VGA 640 x 480 for graphics, VGA 640 x 400 for grap
Resumen del contenido incluido en la página 17
23 3. Connect the external component stereo right channel audio input to R AU- Daisy-chaining Your monitors DIO. The REMOTE IN/OUT terminals allow you to control monitors by one remote 4. Set the 75W /HIGH impedance select switch of the corresponding input signal control. (BNC, S-VIDEO) on all but the last monitor to “HIGH” position. Only the last NOTE: The connection of three XP29 Xtra/XM29 Xtra monitors or more with monitor is set to the “75W ” position. THROUGH OUT (VIDEO 1, VIDEO 2, RGB 1 o
Resumen del contenido incluido en la página 18
25 External Speaker Connections If non-shielded speakers are used, they must be located a minimum of 4 feet away from the monitor. External speakers may be connected to the monitor to reproduce sound from SPEAKER SELECT VIDEO 1, VIDEO 2, RGB 1 or RGB 2 signal sources. INT EXT External speakers may be connected directly to the EXTERNAL SPEAKERS terminals or indirectly by connecting a stereo system amplifier to the audio 4 ft. 4 ft. RIGHT LEFT 120cm 120cm outputs. MORE THAN 5WATT RATING SPEAKERS
Resumen del contenido incluido en la página 19
27 NOTE 2: Select the over scan mode for VIDEO display. Operation 3. Adjust The Raster or The Picture Control. You can adjust the raster such as the horizontal size, vertical size or side Power pincushion correction, and the brightness and contrast of the image with the This section describes how to select a computer or video source and how to remote control. adjust the picture and sound. 4. Turning Off The monitor. General Controls Press the POWER OFF button on the remote control or press the P
Resumen del contenido incluido en la página 20
29 c. HEIGHT Direct Control Screen Press to adjust the vertical size of the image. You can adjust the raster, visual and sound using the direct key on the remote control. To switch to another control screen, press any one of the other keys. d. SIDE PIN *To end the OSM display, press EXIT. Press to adjust the curvature of the edges of the left and right side of the *If no key operation is made within 3 seconds, the OSM display will disappear. display image either inward or outward. The image shou
