Manual de instrucciones de Seagate CHEETAH ST373207LW/LC/LCV

Resumen del contenido incluido en la página 1

®
 Most Cheetah 10K.7 drives are factory set with the SCSI ID set at 0. If
this is the only SCSI drive in your system and there are no other SCSI
devices on the daisychain, you can leave this drive’s SCSI ID set to 0 and
proceed to the next step.
 The host system’s SCSI controller usually uses SCSI ID 7.
 If you have an LC model drive, the host normally sets the ID over the I/O
Cheetah 10K.7 SCSI Installation Guide
interface, so you don’t need to worry about this step.
ST3300007LW/LC/LCV, ST3

Resumen del contenido incluido en la página 2

necessary to format a drive that previously has been used to J2 Drive with Pin 1 store data, unless your intention is to erase all user data. HDA up, PCB down, viewed ® Seagate is not responsible for lost user data. from front Pin 1 Reserved Positions HDA Cheetah 10K.7 disc drives are designed to operate with a variety of operat- Delay Motor Start option (valid ing systems. Please refer to your system or SCSI controller manual for only if the Enable Motor Start J6 jumper is not connected) L